Dataset Information

Calculation of Deformation-Related Quantities in a Hot-Rolling Process.

ABSTRACT: The hot deformation of metal as a nonlinear system is mathematically described by a local linear model associated with the working conditions using a transfer function (TF) in the Laplace domain. Experimental data (true stress vs. true strain curves) are obtained using the established compressive uniaxial deformation test, where experimental conditions (strain rate and temperature) define the working conditions of the local linear TF model, which is intrinsically a function of strain. Based on the TF model, three important physical quantities of the tested metal are determined exactly: the work done per unit deformation, the average flow stress, and the flow-stress derivative with respect to the strain based on a particular TF. The exactly determined quantities, determined as a function of strain, can replace the previously used approximations in some rolling force and torque calculations.

SUBMITTER: Vode F

PROVIDER: S-EPMC10096073 | biostudies-literature | 2023 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Calculation of Deformation-Related Quantities in a Hot-Rolling Process.

Vode Franci F Malej Simon S Tehovnik Franc F Arh Boštjan B Podgornik Bojan B

Materials (Basel, Switzerland) 20230330 7

The hot deformation of metal as a nonlinear system is mathematically described by a local linear model associated with the working conditions using a transfer function (TF) in the Laplace domain. Experimental data (true stress vs. true strain curves) are obtained using the established compressive uniaxial deformation test, where experimental conditions (strain rate and temperature) define the working conditions of the local linear TF model, which is intrinsically a function of strain. Based on t ...[more]

PMID: 37049080

Similar Datasets

Project description:In this paper, analytical results are compared for the newly developed steels, Fe-Mn-Al-C (X105) and Fe-Mn-Al-Nb-Ti-C (X98), after being hot-rolled and also after undergoing thermomechanical treatment in a Gleeble simulator. These steels have a relatively low density (~6.68 g/cm3) and a content of approx. 11% aluminum. The multistage compression of axisymmetric samples constituting a simulation of the real technological process and hot-rolling performed on a semi-industrial line were carried out using three cooling variants: in water, in air, and after isothermal heating and cooling in water. The temperature at the end of the thermomechanical treatment for all variants was 850 °C. On the basis of detailed structural studies, it was found that the main mechanism for removing the effects of the strain hardening that occurred during the four-stage compression involved the dynamic recrystallization occurring in the first and second stages, the hot formability and dynamic recovery in successive stages of deformation, and the static and/or metadynamic recrystallization that occurred at intervals between individual deformations, as well as after the last deformation during isothermal heating. Analysis of the phase composition and structure allowed us to conclude that the tested steels have an austenitic-ferritic structure with carbide precipitates. Research using scanning and transmission electron microscopy identified ?-(Fe, Mn)3AlC and M7C3 carbides in both the analyzed steels. In addition, complex carbides based on Nb and Ti were identified in X98 steel; (Ti, Nb)C carbides occurred in the entire volume of the material. Slow cooling after thermomechanical treatment influenced the formation of larger ?-carbides at the border of the austenite and ferrite grains than in the case of rapid cooling. The size and morphology of the carbides found in the examined steels was varied. Back-scattered electron diffraction studies showed that wide-angle boundaries dominated in these steels.

Dataset Information

Calculation of Deformation-Related Quantities in a Hot-Rolling Process.

Publications

Calculation of Deformation-Related Quantities in a Hot-Rolling Process.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets