How Beam Damage Can Skew Synchrotron Operando Studies of Batteries
Ontology highlight
ABSTRACT:
SUBMITTER: Jousseaume T
PROVIDER: S-EPMC10426324 | biostudies-literature | 2023 Jul
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Operando powder X-ray diffraction (PXRD) is a widely employed method for the investigation of structural evolution and phase transitions in electrodes for rechargeable batteries. Due to the advantages of high brilliance and high X-ray energies, the experiments are often carried out at synchrotron facilities. It is known that the X-ray exposure can cause beam damage in the battery cell, resulting in hindrance of the electrochemical reaction. This study investigates the extent of X-ray beam damage during operando PXRD synchrotron experiments on battery materials with varying X-ray energies, amount of X-ray exposure and battery cell chemistries. Battery cells were exposed to 15, 25 or 35 keV X-rays (with varying dose) during charge or discharge in a battery test cell specially designed for operando experiments. The observed beam damage was probed by µPXRD mapping of the electrodes recovered from the operando battery cell after charge/discharge. The investigation reveals that the beam damage depends strongly on both the X-ray energy and the amount of exposure, and that it also depends strongly on the cell chemistry, i.e. the chemical composition of the electrode.
| S-EPMC10161878 | biostudies-literature
Project description:To understand inhomogeneous reactions perpendicular to the current collector in an electrode for batteries, a method combining operando synchrotron X-ray diffraction and two-layer electrodes with different porosities is developed. The two layers are built using two different active materials (LiNi0.80Co0.15Al0.05O2 and LiMn2O4), therefore, tracing each diffraction pattern reveals which active material is reacting during the electrochemical measurement in transmission mode. The results demonstrate that the active material close to the separator is obviously more active than that one close to the current collector in the case of low porosity electrodes. This inhomogeneity should be due to the rate-limitation and especially to low average ionic conductivity of the electrolyte in the porous electrode because the current flows first mainly into the electrode regions close to the separator. The inhomogeneity is found to be mitigated by the adjustment of the electrode density and thus porosity. Hence, the novel operando method reveals a clear inhomogeneous reaction perpendicular to the current collector.
| S-EPMC5033016 | biostudies-literature
Project description:Transcriptomic response of tumoral and normal brain tissue, treated with the MRT irradiation or the BB irradiation, after 6 h, 48 h, 8 days, 15 days, using Affymetrix GeneChip® Rat 230_ 2.
2018-07-01 | GSE56113 | GEO
Project description:We present an operando study of a lithium ion battery combining scanning X-ray diffraction (SXRD) and synchrotron radiation X-ray tomographic microscopy (SRXTM) simultaneously for the first time. This combination of techniques facilitates the investigation of dynamic processes in lithium ion batteries containing amorphous and/or weakly attenuating active materials. While amorphous materials pose a challenge for diffraction techniques, weakly attenuating material systems pose a challenge for attenuation-contrast tomography. Furthermore, combining SXRD and SRXTM can be used to correlate processes occurring at the atomic level in the crystal lattices of the active materials with those at the scale of electrode microstructure. To demonstrate the benefits of this approach, we investigate a silicon powder electrode in lithium metal half-cell configuration. Combining SXRD and SRXTM, we are able to (i) quantify the dissolution of the metallic lithium electrode and the expansion of the silicon electrode, (ii) better understand the formation of the Li15Si4 phase, and (iii) non-invasively probe kinetic limitations within the silicon electrode. A simple model based on the 1D diffusion equation allows us to qualitatively understand the observed kinetics and demonstrates why high-capacity electrodes are more prone to inhomogeneous lithiation reactions.
| S-EPMC4914858 | biostudies-literature
Project description:Non-aqueous lithium-air batteries (LABs) attract attention as a candidate technology for next-generation energy storage devices. It is crucial to understand how the discharge product Li2O2 is formed and decomposed by the electrochemical reactions to improve the cycle performance and decrease the charge voltage, which are the most important subjects for LAB development. Here, operando X-ray diffraction with high-brilliant X-rays in a transmission mode was used to observe the intensity and structural changes of crystalline Li2O2 in an operating non-aqueous LAB in real time, and the Li-O2 electrochemical reaction involving Li2O2 formation and decomposition was clearly demonstrated. The electrochemically formed Li2O2, which had an anisotropic domain size of 10 nm in the c-direction and 40-70 nm in the ab-plane, grew due to the increase of the number of domains during the discharge process. No other reaction products with a crystalline phase such as LiOH were found in either the cathode or anode of the LAB, whereas the accelerated decomposition rate of the domains was accompanied with the change of the domain shape and lattice constant of the c-axis in the latter half of the charge process with voltage higher than 4 V.
| S-EPMC9082782 | biostudies-literature
Project description:The phenomena occurring in a weld seam during advancement of a laser beam over a metallic component are still under dispute. The occurrence and evolution of porosity and the occasional blowout of melt need to be understood. Here, a recently developed X-ray tomoscopy setup is applied, providing one hundred 3D images per second to capture the temporal evolution of the melt pool in an AlSi9Cu3(Fe) die-casting while a laser beam advances. The number of pores, their size, shape and distribution are quantified with 10 ms time resolution and reflect a complex dynamic pattern. Apart from conventional welding, a variant involving a dynamic beam modulation superimposed onto the linear motion is studied. Reductions of porosity and surface roughness are observed and explained by increased pore mobility and stepwise degassing as the beam repeatedly cuts through pores. The keyhole formed in the melt pool integrated over 10 ms is represented in 3D.
| S-EPMC11884564 | biostudies-literature
Project description:For the first time, protein microcrystallography has been performed with a focused synchrotron-radiation beam of 1 microm using a goniometer with a sub-micrometre sphere of confusion. The crystal structure of xylanase II has been determined with a flux density of about 3 x 10(10) photons s(-1) microm(-2) at the sample. Two sets of diffraction images collected from different sized crystals were shown to comprise data of good quality, which allowed a 1.5 A resolution xylanase II structure to be obtained. The main conclusion of this experiment is that a high-resolution diffraction pattern can be obtained from 20 microm(3) crystal volume, corresponding to about 2 x 10(8) unit cells. Despite the high irradiation dose in this case, it was possible to obtain an excellent high-resolution map and it could be concluded from the individual atomic B-factor patterns that there was no evidence of significant radiation damage. The photoelectron escape from a narrow diffraction channel is a possible reason for reduced radiation damage as indicated by Monte Carlo simulations. These results open many new opportunities in scanning protein microcrystallography and make random data collection from microcrystals a real possibility, therefore enabling structures to be solved from much smaller crystals than previously anticipated as long as the crystallites are well ordered.
| S-EPMC2467531 | biostudies-literature
Project description:Imaging morphological changes that occur during the lifetime of rechargeable batteries is necessary to understand how these devices fail. Since the advent of lithium-ion batteries, researchers have known that the lithium metal anode has the highest theoretical energy density of any anode material. However, rechargeable batteries containing a lithium metal anode are not widely used in consumer products because the growth of lithium dendrites from the anode upon charging of the battery causes premature cell failure by short circuit. Lithium dendrites can also form in commercial lithium-ion batteries with graphite anodes if they are improperly charged. We demonstrate that lithium dendrite growth can be studied using synchrotron-based hard X-ray microtomography. This non-destructive imaging technique allows researchers to study the growth of lithium dendrites, in addition to other morphological changes inside batteries, and subsequently develop methods to extend battery life.
| S-EPMC4692560 | biostudies-other
Project description:1D Ca3Co2-z M z O6 (M = Co z = 0, M = Mn z = 1, and M = Fe z = 0.4) were prepared and tested electrochemically. While the iron-containing phase was not found to be active, the iron- and manganese-containing phases were found to be potentially interesting as positive electrode materials for calcium metal-based high-energy battery technologies and were investigated by operando synchrotron X-ray diffraction. Results indicate that electrochemically driven calcium deintercalation from the crystal structure (ca. 0.7 mol per formula unit) takes place upon oxidation in both cases. The oxidized phases have incommensurate modulated crystal structures with the space group R 3m(00γ)0s and a = 9.127(1) Å, c 1 = 2.4226(3) Å and c 2 = 4.1857(3) Å, and γ = 0.579 (M = Co) and a = 9.217(1) Å, c 1 = 4.9076(4) Å and c 2 = 4.3387(4) Å, and γ = 1.139 (M = Mn), which exhibit differences due to the presence of manganese and Mn/Co ordering. The degree of calcium re-intercalation within the structure was found to be extremely limited, if any. Complementary experiments carried out in lithium cells did not show any reversibility either, thus pointing at intrinsic structural/migration constraints in the oxidized phase rather than slow kinetics of high desolvation energies associated with divalent ion charge carriers.
| S-EPMC8279016 | biostudies-literature
Project description:Energy storage science calls for techniques to elucidate ion transport over a range of conditions and scales. We introduce a new technique, pascalammetry, in which stress is applied to a solid-state electrochemical device and induced faradaic current transients are measured and analyzed. Stress-step pascalammetry measurements are performed on operando microbattery probes (Li2O/Li/W) and Si cathodes, revealing stress-assisted Li+ diffusion. We show how non-Cottrellian lithium diffusional kinetics indicates stress, a prelude to battery degradation. An analytical solution to a diffusion/activation equation describes this stress signature, with spatiotemporal characteristics distinct from Cottrell's classic solution for unstressed systems. These findings create an unprecedented opportunity for quantitative detection of stress in solid-state batteries through the current signature. Generally, pascalammetry offers a powerful new approach to study stress-related phenomena in any solid-state electrochemical system.
| S-EPMC5993470 | biostudies-literature