Solid-state synthesis of silver nanowires using biopolymer thin films
Ontology highlight
ABSTRACT:
SUBMITTER:
PROVIDER: S-EPMC10554915 | biostudies-literature | 2018 Mar
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Noble metal nanoparticles (NPs) are important in many applications, including light trapping of photovoltaic cells, photoelectrochemical applications, etc. The present study reports the formation of silver NPs from the as-deposited silver coatings on fused silica substrates by solid-state dewetting induced by high-current intense pulsed ion beam (IPIB) irradiation. We described the effects of IPIB irradiation with different ion beam current densities and numbers of pulses on NP morphology and compared the results with conventional rapid thermal annealing (RTA). IPIB irradiation enables superfast heating (higher than 109 K/s) and cooling, providing a superfast annealing solid-state dewetting mechanism. Our results demonstrate that the sphericity of silver NPs is enhanced after IPIB irradiation relative to RTA-annealed silver NPs. Our results suggest further possibilities of shape and sphericity control of silver NPs with very fast heating/cooling annealing rates.
| S-EPMC10483687 | biostudies-literature
Project description:Stable chitosan thin films can be promising substrates for creating nanometric peptide-bound polyglucosamine layers. Those are of scientific interest since they can have certain structural similarities to bacterial peptidoglycans. Such films were deposited by spin coating from chitosan solutions and modified by acetylation and N-protected amino acids. The masses of deposited materials and their stability in aqueous solutions at different pH values and water interaction were determined with a quartz crystal microbalance with dissipation (QCM-D). The evolution of the surface composition was followed by X-ray photoelectron (XPS) and attenuated total reflectance infrared (ATR-IR) spectroscopy. Morphological changes were measured by atomic force microscopy (AFM), while the surface wettability was monitored by by static water contact angle measurements. The combination of the characterization techniques enabled an insight into the surface chemistry for each treatment step and confirmed the acetylation and coupling of N-protected glycine peptides. The developed procedures are seen as first steps toward preparing thin layers of acetylated chitin, potentially imitating the nanometric peptide substituted glycan layers found in bacterial cell walls.
| S-EPMC8924862 | biostudies-literature
Project description:There is a great need for viable alternatives to today's transparent conductive film using largely indium tin oxide. We report the fabrication of a new type of flexible transparent conductive film using silver nanowires (AgNW) and single-walled carbon nanotube (SWCNT) networks which are fully embedded in a UV curable resin substrate. The hybrid SWCNTs-AgNWs film is relatively flat so that the RMS roughness of the top surface of the film is 3 nm. Addition of SWCNTs networks make the film resistance uniform; without SWCNTs, sheet resistance of the surface composed of just AgNWs in resin varies from 20 Ω/sq to 107 Ω/sq. With addition of SWCNTs embedded in the resin, sheet resistance of the hybrid film is 29 ± 5 Ω/sq and uniform across the 47 mm diameter film discs; further, the optimized film has 85% transparency. Our lamination-transfer UV process doesn't need solvent for sacrificial substrate removal and leads to good mechanical interlocking of the nano-material networks. Additionally, electrochemical study of the film for supercapacitors application showed an impressive 10 times higher current in cyclic voltammograms compared to the control without SWCNTs. Our fabrication method is simple, cost effective and enables the large-scale fabrication of flat and flexible transparent conductive films.
| S-EPMC5144093 | biostudies-literature
Project description:A combination of solid-state mechanochemical and green approaches for the synthesis of silver nanoparticles (AgNPs) is explored in this study. Thymus serpyllum L. (SER), Sambucus nigra L. (SAM) and Thymus vulgaris L. (TYM) plants were successfully applied to reduce AgNO3 to AgNPs, as confirmed by X-ray diffraction analysis, with SER being the best reducing agent, and TYM being the worst. The experiments were performed via a one-step planetary milling process, where various AgNO3:plant mass ratios (1:1, 1:10, 1:50 and 1:100) were investigated. Atomic absorption spectrometry indicated that the stability of the mechanochemically produced AgNPs increased markedly when a sufficiently large quantity of the reducing plant was used. Furthermore, when larger quantities of plant material were employed, the crystallite size of the AgNPs decreased. TEM analysis revealed that all AgNPs produced from both AgNO3:plant ratios 1:1 and 1:10 exhibit the bimodal size distribution with the larger fraction with size in tens of nm and the smaller one below 10 nm in size. The antibacterial activity of the produced AgNPs was observed only for AgNO3:plant ratio 1:1, with the AgNPs prepared using SER showing the greatest antibacterial properties.
| S-EPMC7692266 | biostudies-literature
Project description:Synthetic porous materials continue to garner attention as platforms for solid-state chemistry and as designer heterogeneous catalysts. Applications in photochemistry and photocatalysis, however, are plagued by poor light harvesting efficiency due to light scattering resulting from sample microcrystallinity and poor optical penetration that arises from inner filter effects. Here we demonstrate the layer-by-layer growth of optically transparent, photochemically active thin films of porous salts. Films are grown by sequential deposition of cationic Zr-based porous coordination cages and anionic Mn porphyrins. Photolysis facilitates the efficient reduction of Mn(III) sites to Mn(II) sites, which can be observed in real-time by transmission UV-vis spectroscopy. Film porosity enables substrate access to the Mn(II) sites and facilitates reversible O2 activation in the solid state. These results establish optically transparent, porous salt thin films as versatile platforms for solid-state photochemistry and in operando spectroscopy.
| S-EPMC10863064 | biostudies-literature
Project description:This paper demonstrates a facile strategy for the development of nanosilver decorated polyaniline coated (PAg) paper-based electrodes for the fabrication of solid-state symmetrical supercapacitors. PAg based printing paper was developed through a two-step process involving initial silver nucleation and growth on the paper followed by aniline polymerization. The developed electrically conductive paper exhibited a highly porous structure and excellent mechanical stability. Further symmetrical supercapacitors having the configuration PAg/electrolyte/PAg were fabricated and evaluated for electrochemical performance such as specific capacitance (483 F g-1 and 613 F g-1 in aqueous 1 M H2SO4 and PVA-H2SO4 gel electrolytes respectively), energy density (69.56 and 85.13 W h kg-1), and power density (243.44 and 405.375 W kg-1) and cycling stability (90% of its capacitance retention even after 2000 cycles), exhibiting excellent performance under various bending conditions. All these exciting results suggest that the developed paper-based flexible solid-state energy device can serve as an efficient, sustainable, and low-cost energy storage system for portable microelectronic devices which are expected to revolutionize the perception of energy-storage devices in the electronics industry.
| S-EPMC9088673 | biostudies-literature
Project description:This work reports a facile wafer-level fabrication for nanogap-rich gold nanoislands for highly sensitive surface enhanced Raman scattering (SERS) by repeating solid-state thermal dewetting of thin gold film. The method provides enlarged gold nanoislands with small gap spacing, which increase the number of electromagnetic hotspots and thus enhance the extinction intensity as well as the tunability for plasmon resonance wavelength. The plasmonic nanoislands from repeated dewetting substantially increase SERS enhancement factor over one order-of-magnitude higher than those from a single-step dewetting process and they allow ultrasensitive SERS detection of a neurotransmitter with extremely low Raman activity. This simple method provides many opportunities for engineering plasmonics for ultrasensitive detection and highly efficient photon collection.
| S-EPMC4606563 | biostudies-literature
Project description:We assemble semiconductor CdSe nanoplatelets (NPs) at the air/liquid interface into 2D monolayers several micrometers wide, distinctly displaying nematic order. We show that this configuration is the most favorable energetically and that the edge-to-edge distance between neighboring NPs can be tuned by ligand exchange without disrupting film topology and nanoparticle orientation. We explore the rich assembly phase space by using depletion interactions to direct the formation of 1D nanowires from stacks of NPs. The improved control and understanding of the assembly of semiconductor NPs offers opportunities for the development of cheaper optoelectronic devices that rely on 1D or 2D charge delocalization throughout the assembled monolayers and nanowires.
| S-EPMC10501200 | biostudies-literature
Project description:To date, silver nanowires (AgNWs) are routinely synthesized.
| S-EPMC9979360 | biostudies-literature
Project description:Silver nanowires have attracted much attention for use in flexible transparent conductive films (TCFs) due to their low sheet resistance and flexibility. However, the haze was too high for replacing indium-tin-oxide in high-quality display devices. Herein, we report flexible TCFs, which were prepared using a scalable bar-coating method, with a low sheet resistance (24.1 Ω/sq at 96.4% transmittance) and a haze (1.04%) that is comparable to that of indium-tin-oxide TCFs. To decrease the haze and maintain a low sheet resistance, small diameter silver nanowires (~20 nm) were functionalized with low-temperature surface-sintering silver nanoparticles (~5 nm) using bifunctional cysteamine. The silver nanowire-nanoparticle ink stability was excellent. The sheet resistance of the TCFs was decreased by 29.5% (from 34.2 to 24.1 Ω/sq) due to the functionalization at a low curing temperature of 85 °C. The TCFs were highly flexible and maintained their stability for more than 2 months and 10,000 bending cycles after coating with a protective layer.
| S-EPMC4648094 | biostudies-literature