Influence of geographical location and outdoor meteorological parameters on indoor humidity environment in rural residential buildings during the Plum Rains Season in the hot summer and cold winter region
Ontology highlight
ABSTRACT:
SUBMITTER: He Y
PROVIDER: S-EPMC10593243 | biostudies-literature | 2023 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:BackgroundNumerous mechanisms link outdoor weather and climate conditions to human health. It is likely that many health conditions are more directly affected by indoor rather than outdoor conditions. Yet, the relationship between indoor temperature and humidity conditions to outdoor variability, and the heterogeneity of the relationship among different indoor environments are largely unknown.MethodsWe use 5-14 day measures of indoor temperature and relative humidity from 327 dwellings in New York City for the years 2008-2011 to investigate the relationship between indoor climate, outdoor meteorological conditions, socioeconomic conditions, and building descriptors. Study households were primarily middle-income and located across the boroughs of Brooklyn, Queens, Bronx, and Manhattan.ResultsIndoor temperatures are positively associated with outdoor temperature during the warm season and study dwellings in higher socioeconomic status neighborhoods are significantly cooler. During the cool season, outdoor temperatures have little effect on indoor temperatures; however, indoor temperatures can range more than 10 °C between dwellings despite similar outdoor temperatures. Apartment buildings tend to be significantly warmer than houses and dwellings on higher floors are also significantly warmer than dwellings on lower floors. Outdoor specific humidity is positively associated with indoor specific and relative humidity, but there is no consistent relationship between outdoor and indoor relative humidity.ConclusionsIn New York City, the relationship between indoor and outdoor temperature and humidity conditions vary significantly between dwellings. These results can be used to inform studies of health outcomes for which temperature or humidity is an established factor affecting human health and highlights the need for more research on the determinants of indoor climate.
| S-EPMC3784267 | biostudies-literature
Project description:Moderate indoor relative humidity (RH) levels (i.e., 40%-60%) may minimize transmission and viability of some viruses, maximize human immune function, and minimize health risks from mold, yet uncertainties exist about typical RH levels in offices globally and about the potential independent impacts of RH levels on workers' health. To examine this, we leveraged one year of indoor RH measurements (which study participants could view in real time) in 43 office buildings in China, India, Mexico, Thailand, the United Kingdom, and the United States, and corresponding self-report symptom data from 227 office workers in a subset of 32 buildings. In the buildings in this study, 42% of measurements during 9:00 - 17:00 on weekdays were less than 40% RH and 7% exceeded 60% RH. Indoor RH levels tended to be lower in less tropical regions, in winter months, when outdoor RH or temperature was low, and late in the workday. Furthermore, we also found statistically significant evidence that higher indoor RH levels across the range of 14%-70% RH were associated with lower odds of reporting dryness or irritation of the throat and skin among females and unusual fatigue among males in models adjusted for indoor temperature, country, and day of year.
| S-EPMC10924614 | biostudies-literature
Project description:Exposure to air pollutants has been associated with adverse health effects. However, analyses of the effects of season and ambient parameters such as ozone have not been fully conducted. Residential indoor and outdoor air levels of polycyclic aromatic hydrocarbons (PAH), black carbon (measured as absorption coefficient [Abs]), and fine particulate matter <2.5 ?m (PM)(2.5) were measured over two-weeks in a cohort of 5-6 year old children (n=334) living in New York City's Northern Manhattan and the Bronx between October 2005 and April 2010. The objectives were to: 1) characterize seasonal changes in indoor and outdoor levels and indoor/outdoor (I/O) ratios of PAH (gas + particulate phase; dichotomized into ?(8)PAH(semivolatile) (MW 178-206), and ?(8)PAH(nonvolatile) (MW 228-278)), Abs, and PM(2.5); and 2) assess the relationship between PAH and ozone. Results showed that heating compared to nonheating season was associated with greater ?(8)PAH(nonvolatile) (p<0.001) and Abs (p<0.05), and lower levels of ?(8)PAH(semivolatile) (p<0.001). In addition, the heating season was associated with lower I/O ratios of ?(8)PAH(nonvolatile) and higher I/O ratios of ?(8)PAH(semivolatile) (p<0.001) compared to the nonheating season. In outdoor air, ?(8)PAH(nonvolatile) was correlated negatively with community-wide ozone concentration (p<0.001). Seasonal changes in emission sources, air exchanges, meteorological conditions and photochemical/chemical degradation reactions are discussed in relationship to the observed seasonal trends.
| S-EPMC2951607 | biostudies-literature
Project description: Not available
| S-EPMC7786394 | biostudies-literature
Project description:Indoor air in residential dwellings can contain a variety of chemicals, sometimes present at concentrations or in combinations which can have a negative impact on human health. Indoor Air Quality (IAQ) surveys are often required to characterize human exposure or to investigate IAQ concerns and complaints. Such surveys should include sufficient contextual information to elucidate sources, pathways, and the magnitude of exposures. The aim of this review was to investigate and describe the parameters that affect IAQ in residential dwellings: building location, layout, and ventilation, finishing materials, occupant activities, and occupant demography. About 180 peer-reviewed articles, published from 01/2013 to 09/2021 (plus some important earlier publications), were reviewed. The importance of the building parameters largely depends on the study objectives and whether the focus is on a specific pollutant or to assess health risk. When considering classical pollutants such as particulate matter (PM) or volatile organic compounds (VOCs), the building parameters can have a significant impact on IAQ, and detailed information of these parameters needs to be reported in each study. Research gaps and suggestions for the future studies together with recommendation of where measurements should be done are also provided.
| S-EPMC9828800 | biostudies-literature
Project description:The COVID-19 pandemic has resulted in increased usage of ethanol-based disinfectants for surface inactivation of SARS-CoV-2 in buildings. Emissions of volatile organic compounds (VOCs) and particles from ethanol-based disinfectant sprays were characterized in real-time (1 Hz) via a proton transfer reaction time-of-flight mass spectrometer (PTR-TOF-MS) and a high-resolution electrical low-pressure impactor (HR-ELPI+), respectively. Ethanol-based disinfectants drove sudden changes in the chemical composition of indoor air. VOC and particle concentrations increased immediately after application of the disinfectants, remained elevated during surface contact time, and gradually decreased after wiping. The disinfectants produced a broad spectrum of VOCs with mixing ratios spanning the sub-ppb to ppm range. Ethanol was the dominant VOC emitted by mass, with concentrations exceeding 103 μg m-3 and emission factors ranging from 101 to 102 mg g-1. Listed and unlisted diols, monoterpenes, and monoterpenoids were also abundant. The pressurized sprays released significant quantities (104-105 cm-3) of nano-sized particles smaller than 100 nm, resulting in large deposited doses in the tracheobronchial and pulmonary regions of the respiratory system. Inhalation exposure to VOCs varied with time during the building disinfection events. Much of the VOC inhalation intake (>60 %) occurred after the disinfectant was sprayed and wiped off the surface. Routine building disinfection with ethanol-based sprays during the COVID-19 pandemic may present a human health risk given the elevated production of volatile chemicals and nano-sized particles.
| S-EPMC8423670 | biostudies-literature
Project description:While working in the heat is a common practice within the Australian mining industry, it can lead to adverse effects on cognitive function, productivity, and physical health. This study aimed to compare the thermal strain experienced by maintenance workers and service workers in the mining industry during summer. Psycho-physiological parameters, manual dexterity, and cognitive function were assessed in maintenance workers (n = 12) and service workers (n = 12) employed at mine site villages in north-west Australia. Maintenance workers had the freedom to self-select their work intensity and predominantly worked outdoors (33.9±4.2°C, 38±18% RH), whereas service workers had to work to a fixed schedule and worked intermittently indoors (∼64% of work shift; 29.5±3.4°C, 48±8% RH) and outdoors (∼36%; 35.4±4.6°C, 47±21% RH). All workers underwent assessment at the beginning (day 2/3), middle (day 7/8), and end of their swing (day 13/14), at various time points throughout their 11-12 h shift. Service workers completed more steps (11282±1794 vs. 7774±2821; p<0.001), experienced a higher heart rate (p = 0.049) and reported higher ratings of perceived exertion (p<0.001), thermal discomfort (p<0.001), thermal sensation (p<0.001), and fatigue (p<0.012) compared to maintenance workers. Urinary specific gravity values were higher (less hydrated) in service workers (1.024±0.007) compared to maintenance workers (1.018±0.006; p = 0.007), with USG being overall higher post- compared to pre-shift (1.022±0.008 vs. 1.020±0.006; p<0.05). Core temperature, working memory capacity, processing speed and manual dexterity did not differ between occupations. Workers in hot environments who cannot self-select their work intensity should be educated about the importance of hydration before, during, and after their work-shifts and provided with more scheduled rest breaks during their shift. Employers should closely monitor workers for symptoms of heat illness, discomfort, and fatigue to ensure the health and safety of the workers.
| S-EPMC10553273 | biostudies-literature
Project description:Particulate matter with an aerodynamic diameter less than 2.5μm (PM2.5) is currently a major air pollutant that has been raising public attention. Studies have found that short/long-term exposure to PM2.5 lead detrimental health effects. Since people in most region of the world spend a large proportion of time in dwellings, personal exposure to PM2.5 in home microenvironment should be carefully investigated. The objective of this review is to investigate and summary studies in terms of personal exposure to indoor PM2.5 pollutants from the literature between 2000 and 2021. Factors from both outdoor and indoor environment that have impact on indoor PM2.5 levels were explicated. Exposure studies were verified relating to individual activity pattern and exposure models. It was found that abundant investigations in terms of personal exposure to indoor PM2.5 is affected by factors including concentration level, exposure duration and personal diversity. Personal exposure models, including microenvironment model, mathematical model, stochastic model and other simulation models of particle deposition in different regions of human airway are reviewed. Further studies joining indoor measurement and simulation of PM2.5 concentration and estimation of deposition in human respiratory tract are necessary for individual health protection.
| S-EPMC9434053 | biostudies-literature
Project description:This data article relates to the research paper Energy consumption and efficiency technology measures in European non-residential buildings (D'Agostino et al., 2017) [1]. The reported data have been collected in the framework of the Green Building Programme that ran from 2006 to 2014. The project has encouraged the adoption of efficiency measures to boost energy savings in European non-residential buildings. Data focus on the one-thousand buildings that joined the Programme allowing to save around 985 GWh/year. The main requirement to join the Programme was the reduction of at least 25% primary energy consumption in a new or retrofitted building. Energy consumption before and after the renovation are provided for retrofitted buildings while, in new constructions, a building had to be designed using at least 25% less energy than requested by the country's building codes. The following data are linked within this article: energy consumption, absolute and relative savings related to primary energy, saving percentages, implemented efficiency measures and renewables. Further information is given about each building in relation to geometry, envelope, materials, lighting and systems.
| S-EPMC5596327 | biostudies-literature
Project description:NO₂ and particulate matter are the air pollutants of most concern in Ireland, with possible links to the higher respiratory and cardiovascular mortality and morbidity rates found in the country compared to the rest of Europe. Currently, air quality limits in Europe only cover outdoor environments yet the quality of indoor air is an essential determinant of a person's well-being, especially since the average person spends more than 90% of their time indoors. The modelling conducted in this research aims to provide a framework for epidemiological studies by the use of publically available data from fixed outdoor monitoring stations to predict indoor air quality more accurately. Predictions are made using two modelling techniques, the Personal-exposure Activity Location Model (PALM), to predict outdoor air quality at a particular building, and Artificial Neural Networks, to model the indoor/outdoor relationship of the building. This joint approach has been used to predict indoor air concentrations for three inner city commercial buildings in Dublin, where parallel indoor and outdoor diurnal monitoring had been carried out on site. This modelling methodology has been shown to provide reasonable predictions of average NO₂ indoor air quality compared to the monitored data, but did not perform well in the prediction of indoor PM2.5 concentrations. Hence, this approach could be used to determine NO₂ exposures more rigorously of those who work and/or live in the city centre, which can then be linked to potential health impacts.
| S-EPMC4690911 | biostudies-literature