(Mg,Mn)-dual doping synergism towards luminescence and electrical properties of ZnO/p-Si heterojunction diodes† † Electronic supplementary information (ESI) available. See DOI: https://doi.org/10.1039/d3ra06140j
Ontology highlight
ABSTRACT:
SUBMITTER: V. S. G
PROVIDER: S-EPMC10620645 | biostudies-literature | 2023 Nov
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The fabrication, by an all electrochemical process, of porous Si/ZnO nanostructures with engineered structural defects, leading to strong and broadband deep level emission from ZnO, is presented. Such nanostructures are fabricated by a combination of metal-assisted chemical etching of Si and direct current electrodeposition of ZnO. It makes the whole fabrication process low-cost, compatible with Complementary Metal-Oxide Semiconductor technology, scalable and easily industrialised. The photoluminescence spectra of the porous Si/ZnO nanostructures reveal a correlation between the lineshape, as well as the strength of the emission, with the morphology of the underlying porous Si, that control the induced defects in the ZnO. Appropriate fabrication conditions of the porous Si lead to exceptionally bright Gaussian-type emission that covers almost the entire visible spectrum, indicating that porous Si/ZnO nanostructures could be a cornerstone material towards white-light-emitting devices.
| S-EPMC5934408 | biostudies-literature
Project description:This paper addressed the effect of post-annealed treatment on the electroluminescence (EL) of an n-ZnO/p-GaN heterojunction light-emitting diode (LED). The bluish light emitted from the 450 °C-annealed LED became reddish as the LED annealed at a temperature of 800 °C under vacuum atmosphere. The origins of the light emission for these LEDs annealed at various temperatures were studied using measurements of electrical property, photoluminescence, and Auger electron spectroscopy (AES) depth profiles. A blue-violet emission located at 430 nm was associated with intrinsic transitions between the bandgap of n-ZnO and p-GaN, the green-yellow emission at 550 nm mainly originating from the deep-level transitions of native defects in the n-ZnO and p-GaN surfaces, and the red emission at 610 nm emerging from the Ga-O interlayer due to interdiffusion at the n-ZnO/p-GaN interface. The above-mentioned emissions also supported the EL spectra of LEDs annealed at 700 °C under air, nitrogen, and oxygen atmospheres, respectively.
| S-EPMC5458876 | biostudies-other
Project description:Silicon heterojunction (SHJ) solar cells, as one of the most promising passivated contact solar cell technologies of the next generation, have the advantages of high conversion efficiency, high open-circuit voltage, low-temperature coefficient, and no potential-induced degradation. For the single-side rear-emitter SHJ solar cells, the n-type carrier selective layer, which serves as the light-incident side, plays a pivotal role in determining the performance of heterojunction devices. Consequently, a superior n-doped layer should exhibit high optical transmittance and minimal optical absorption, along with a substantial effective doping level to guarantee the formation of dark conductivity (σd) and electron-transport capacity. In this work, we investigated the optical and electrical properties of different n-type monolayers and stacked gradient multilayers, including monolayer, bilayer, and trilayer Si-based thin films, acting as electron-transport layers (ETL) prepared by plasma-enhanced chemical vapor deposition, and studied the influences of these above layers on the performance of SHJ solar cells. The experimental results demonstrate that the ETL with an n-nc-Si:H/n-nc-SiOx:H/n+-nc-Si:H trilayer structure exhibits the potential to boost highly efficient solar cells. The bottom highly crystallized, lightly phosphorus-doped n-nc-Si:H film promotes rapid nucleation of the intermediate n-nc-SiOx:H film and thus reduces the thickness of the incubation layer, as well as improves the passivation contact. The n-nc-SiOx:H film in the middle layer provides excellent optical properties and reduces parasitic absorption, thereby increasing the short-circuit current density. Furthermore, the highly doped n+-nc-Si:H at the top offers an optimal ohmic contact with the reactive plasma deposition-grown TCO layer, which ultimately enhances the fill factor. Ultimately, a conversion efficiency of 20.41%, with an open-circuit voltage of 720 mV, a short-circuit current density of 39.34 mA/cm2, and a filling factor of 72.05%, was achieved in the SHJ solar cell using a typical trilayer structure. This kind of trilayer structure has a particular significance for potential industrialized applications as it allows for efficient utilization of solar energy.
| S-EPMC11656382 | biostudies-literature
Project description:The incorporation of doping elements in ZnO nanostructures plays an important role in adjusting the optical and electrical properties in optoelectronic devices. In the present study, we fabricated 1-D ZnO nanorods (NRs) doped with different In contents (0% ~ 5%) on p-GaN films using a facile hydrothermal method, and investigated the effect of the In doping on the morphology and electronic structure of the NRs and the electrical and optical performances of the n-ZnO NRs/p-GaN heterojunction light emitting diodes (LEDs). As the In content increased, the size (diameter and length) of the NRs increased, and the electrical performance of the LEDs improved. From the electroluminescence (EL) spectra, it was found that the broad green-yellow-orange emission band significantly increased with increasing In content due to the increased defect states (oxygen vacancies) in the ZnO NRs, and consequently, the superposition of the emission bands centered at 415 nm and 570 nm led to the generation of white-light. These results suggest that In doping is an effective way to tailor the morphology and the optical, electronic, and electrical properties of ZnO NRs, as well as the EL emission property of heterojunction LEDs.
| S-EPMC4437377 | biostudies-literature
Project description:Gas sensors based on semiconductors have outstanding sensitivity compared with the oxide-based devices; however, the high operation temperature greatly hinders its development in practical applications. Chronic obstructive pulmonary disease (COPD) is one of the leading causes of death worldwide, and the patients with severe COPD with or without exacerbation tend to have airflow obstruction, which results in an increase of CO2 concentration and subsequent hypercapnic respiratory failure. At present, COPD detection relies on professional operation; however, the patients suffer great discomfort during the arterial blood sampling. All these facts reduce patient's willingness to test their physical health. Thus, noninvasive monitoring of CO2 levels is crucial for the early diagnosis of high-risk COPD patients. A nitrogen-incorporated ultrananocrystalline diamond (NUNCD) film exhibits excellent properties in biosensing and polyetherimide-polyethylene glycol (PEI-PEG) polymer possesses a great capability of CO2 capturing. By incorporating NUNCD into PEI-PEG film, this work focuses on ameliorating the sensitivity and selectivity of the present semiconductor CO2 sensor. From the theoretical regression analyses of the experimental results, it is found that the excellent performance of the PEI-PEG/ZnO/NUNCD/Si electrode is contributed by two main reaction layers, the adsorption layer (PEI-PEG) and the electric transfer layer (ZnO/NUNCD). The selectivity is dominated by the PEI-PEG adsorption layer and the sensitivity is directly related to the changes in the work function of the ZnO/NUNCD interface. The high aspect ratio (>10) of the flower-like ZnO structure, growth from ZnO nanoparticles, can provide a more active adsorption area, as a result, extremely enhancing the sensitivity of the CO2 sensor.
| S-EPMC9097207 | biostudies-literature
Project description:Li-rich Mn-based layered oxides are among the most promising cathode materials for next-generation lithium-ion batteries, yet they suffer from capacity fading and voltage decay during cycling. The electrochemical performance of the material can be improved by doping with Mg. However, the effect of Mg doping at different positions (lithium or transition metals) remains unclear. Li1.2Mn0.54Ni0.13Co0.13O2 (LR) was synthesized by coprecipitation followed by a solid-state reaction. The coprecipitation stage was used to introduce Mg in TM layers (sample LR-Mg), and the solid-state reaction (st) was used to dope Mg in Li layers (LR-Mg(st)). The presence of magnesium at different positions was confirmed by XRD, XPS, and electrochemical studies. The investigations have shown that the introduction of Mg in TM layers is preferable in terms of the electrochemical performance. The sample doped with Mg at the TM positions shows better cyclability and higher discharge capacity than the undoped sample. The poor electrochemical properties of the sample doped with Mg at Li positions are due to the kinetic hindrance of oxidation of the manganese-containing species formed after activation of the Li2MnO3 component of the composite oxide. The oxide LR-Mg(st) demonstrates the lowest lithium-ion diffusion coefficient and the greatest polarization resistance compared to LR and LR-Mg.
| S-EPMC8746697 | biostudies-literature
Project description:Various concentrations of Mg-doped ZnO nanorods (NRs) were prepared using co-precipitation technique. The objective of this study was to improve the photocatalytic properties of ZnO. The effect of Mg doping on the structure, phase constitution, functional groups presence, optical properties, elemental composition, surface morphology and microstructure of ZnO was evaluated with XRD, FTIR, UV-Vis spectrophotometer, EDS, and HR-TEM, respectively. Optical absorption spectra obtained from the prepared samples showed evidence of blueshift upon doping. XRD results revealed hexagonal wurtzite phase of nanocomposite with a gradual decrease in crystallite size with Mg addition. PL spectroscopy showed trapping efficiency and migration of charge carriers with electron-hole recombination behavior, while HR-TEM estimated interlayer d-spacing. The presence of chemical bonding, vibration modes and functional groups at the interface of ZnO was revealed by FTIR and Raman spectra. In this study, photocatalytic, sonocatalytic and sonophotocatalytic performance of prepared NRs was systematically investigated by degrading a mixture of methylene blue and ciprofloxacin (MBCF). Experimental results suggested that improved degradation performance was shown by Mg-doped ZnO NRs. We believe that the product synthesized in this study will prove to be a beneficial and promising photocatalyst for wastewater treatment. Conclusively, Mg-doped ZnO exhibited substantial (p < 0.05) efficacy against gram-negative (G-ve) as compared to gram-positive (G+ve) bacteria. In silico molecular docking studies of Mg-doped ZnO NRs against DHFR (binding score: - 7.518 kcal/mol), DHPS (binding score: - 6.973 kcal/mol) and FabH (- 6.548 kcal/mol) of E. coli predicted inhibition of given enzymes as possible mechanism behind their bactericidal activity.
| S-EPMC8088420 | biostudies-literature
Project description:Density Functional Theory (DFT) calculations have been performed to investigate the structural and electronic properties of the ZnO(wurtzite)-ATiO2(anatase) heterojunction in the absence and presence of substitutional, interstitial nitrogen (N) doping and oxygen vacancies (OV). We report a detailed study of the interactions between the two nonpolar ZnO and TiO2 surfaces and on the role of N-doping and oxygen vacancies, which are decisive for improving the photocatalytic activity of the heterojunction. Our calculations show that substitutional N-doping is favored in the ATiO2 portion, whereas the interstitial one is favored in the ZnO region of the interface. Both substitutional and interstitial N-doped sites (i) induce gap states that act as deep electronic traps improving the charge separation and delaying electron-hole recombination, (ii) facilitate the OV formation causing a decrease in the formation energy (E FORM), and (iii) do not affect the band alignment when compared to the undoped analogue system. The presented results shed light on the N-doping effect on the electronic structure of the ZnO(100)-TiO2(101) heterojunction and how N-doping improves its photocatalytic properties.
| S-EPMC9946291 | biostudies-literature
Project description:We report here the fabrication of highly efficient and long-lasting quantum-dot light emitting diodes (QLEDs) by blending various alkali metal carbonate in magnesium (Mg) doped zinc oxide (ZnO) (MZO) electron transport layer (ETL). Alkali metal carbonates blending in MZO, X2CO3:MZO, control the band-gap, electrical properties, and thermal stability. This can therefore enhance the operational lifetime of QLEDs. It is found that the conductivity of X2CO3:MZO film can be controlled and the thermal stability of ETLs could be improved by X2CO3 blending in MZO. The inverted red QLEDs (R-QLEDs) with Cs2CO3:MZO, Rb2CO3:MZO, and K2CO3:MZO ETLs exhibited the operational lifetime of 407 h for the R-QLEDs with Cs2CO3:MZO, 620 h with Rb2CO3:MZO and 94 h with K2CO3:MZO ETLs at T95 with the initial luminance of 1000 cd/m2. Note that all red QLEDs showed the high brightness over 150,000 cd/m2. But the R-QLEDs with Na2CO3:MZO and Li2CO3:MZO ETLs exhibited shorter operational lifetime and poor brightness than the R-QLED with pristine MZO ETL.
| S-EPMC7761844 | biostudies-literature
Project description:Sb-doped p-type ZnO microwires with zigzag rough surfaces were synthesized by two zone chemical vapor deposition. The zigzag morphology characteristics analyzed by high resolution scanning electron microscopy and transmission electron microscopy show the existence of surface defects caused by Sb doping. The incorporation of Sb into a ZnO lattice induces lattice imperfection, which is the origin of the zigzag rough surface. Photoluminescence and electrical properties of the obtained Sb-doped ZnO microwires were determined. The crossed structure microwire-based p-n homojunction device was fabricated by applying as-synthesized Sb-doped p-type ZnO microwires and undoped n-type ZnO microwires. The doped microwires demonstrate reproducible p-type conduction and enhanced rectifying behavior with increasing Sb doping concentration. The results demonstrated that the optimizable optical and electrical characteristics, controlled by increasing the doping concentration, are reflected in the surface morphology changes which would be helpful for characterizing the doping effects in micro/nanoscale materials.
| S-EPMC9087441 | biostudies-literature