Project description:Oxygen solute strengthening is an effective strategy to harden alloys, yet, it often deteriorates the ductility. Ordered oxygen complexes (OOCs), a state between random interstitials and oxides, can simultaneously enhance strength and ductility in high-entropy alloys. However, whether this particular strengthening mechanism holds in other alloys and how these OOCs are tailored remain unclear. Herein, we demonstrate that OOCs can be obtained in bcc (body-centered-cubic) Ti-Zr-Nb medium-entropy alloys via adjusting the content of Nb and oxygen. Decreasing the phase stability enhances the degree of (Ti, Zr)-rich chemical short-range orderings, and then favors formation of OOCs after doping oxygen. Moreover, the number density of OOCs increases with oxygen contents in a given alloy, but adding excessive oxygen (>3.0 at.%) causes grain boundary segregation. Consequently, the tensile yield strength is enhanced by ~75% and ductility is substantially improved by ~164% with addition of 3.0 at.% O in the Ti-30Zr-14Nb MEA.
Project description:Pyroelectricity plays a crucial role in modern sensors and energy conversion devices. However, obtaining materials with large and nearly constant pyroelectric coefficients over a wide temperature range for practical uses remains a formidable challenge. Attempting to discover a solution to this obstacle, we combined molecular design of labile electronic structure with the crystal engineering of the molecular orientation in lattice. This combination results in electronic pyroelectricity of purely molecular origin. Here, we report a polar crystal of an [FeCo] dinuclear complex exhibiting a peculiar pyroelectric behavior (a substantial sharp pyroelectric current peak and an unusual continuous pyroelectric current at higher temperatures) which is caused by a combination of Fe spin crossover (SCO) and electron transfer between the high-spin Fe ion and redox-active ligand, namely valence tautomerism (VT). As a result, temperature dependence of the pyroelectric behavior reported here is opposite from conventional ferroelectrics and originates from a transition between three distinct electronic structures. The obtained pyroelectric coefficient is comparable to that of polyvinylidene difluoride at room temperature.
Project description:Magnetoelectric coupling at room temperature in multiferroic materials, such as BiFeO3, is one of the leading candidates to develop low-power spintronics and emerging memory technologies. Although extensive research activity has been devoted recently to exploring the physical properties, especially focusing on ferroelectricity and antiferromagnetism in chemically modified BiFeO3, a concrete understanding of the magnetoelectric coupling is yet to be fulfilled. We have discovered that La substitutions at the Bi-site lead to a progressive increase in the degeneracy of the potential energy landscape of the BiFeO3 system exemplified by a rotation of the polar axis away from the 〈111〉pc towards the 〈112〉pc discretion. This is accompanied by corresponding rotation of the antiferromagnetic axis as well, thus maintaining the right-handed vectorial relationship between ferroelectric polarization, antiferromagnetic vector and the Dzyaloshinskii-Moriya vector. As a consequence, La-BiFeO3 films exhibit a magnetoelectric coupling that is distinctly different from the undoped BiFeO3 films.
Project description:The use of fast closed-loop adaptive optics has improved the performance of optical systems since its first application. Here we demonstrate the amplitude and carrier-envelope phase stabilization of a high energy IR optical parametric amplifier devoted to Attosecond Science exploiting two high speed adaptive optical systems for the correction of static and dynamic instabilities. The exploitation of multi actuator adaptive lenses allowed for a minimal impact on the optical setup.
Project description:Manipulating the energy flow of light is at the heart of modern information and communication technologies. Because photons are uncharged, it is still difficult to effectively control them by electrical means. Here, we propose a graphene plasmonic (GP) lens to efficiently manipulate energy flow by elaborately designing the thickness of the dielectric spacer beneath the graphene sheet. Different from traditional metal-based lenses, the proposed graphene plasmonic lens possesses the advantages of tunability and excellent confinement of surface plasmons. It is found that the proposed lens can be utilized to focus and collimate the GP waves propagating along the graphene sheet. Particularly, the lens is dispersionless over a wide frequency range and the performance of lens can be flexibly tuned by adjusting the bias voltage. As an application of such a lens, the image transfer of two point sources with a separation of λ₀/30 is demonstrated.
Project description:New strategies for the design and synthesis of stable organic radicals without additives are highly desirable. Herein, we design a series of donor-acceptor structured triarylphosphines and disclose the fast color change triggered by UV-irradiation in the crystalline state. Photoinduced organic radicals are undoubtedly verified and proved to be the reason for the color change by time-dependent and quantitative electron paramagnetic resonance analysis, X-ray crystallographic analysis, and theoretical calculations. It is revealed that the intrinsic symmetry breaking of peripheral architecture helps to form continuous molecular chains by donor-acceptor counterpart pairing. Intermolecular electron-transfer occurs among molecular chains and results in radical ion pairs upon photoirradiation.
Project description:Supramolecular systems may be used to stabilize otherwise unstable isomers to find alternative synthetic pathways. It has been reported that cucurbit[8]uril can stabilize trans-I and trans-II CuII cyclam, whereas trans-III is the only non-substituted trans CuII cyclam diastereoisomer found outside of the host molecule experimentally. Quantum chemistry methods can provide valuable insight into the intermolecular interactions involved in these inclusion complexes. All five possible trans diastereoisomers of CuII cyclam were studied within the host molecule to calculate the interaction energy and free energy of association for each complex. The relative free energies of the five free cyclams confirm that trans-I and trans-II are the most energetically accessible diastereoisomers from the initial trans-III starting point. Energy decomposition analysis was used to identify the attractive and repulsive interactions between cyclam and cucurbit[8]uril and showed that trans-II encounters repulsive forces almost three times greater than trans-I, which may explain the 7:3 ratio of trans-I to trans-II within cucurbit[8]uril that occurs experimentally. Optimized complex geometries with trans-III, IV, and V show that the cyclams protrude out of cucurbit[8]uril, whereas trans-I and trans-II become more encapsulated and elongate the host, suggesting that the position of the cyclam is extremely important when forming non-covalent interactions. Our results agree with the experimental findings and provide greater insight into why the most stable isolated cyclam diastereoisomer, trans-III, does not form a complex.Supplementary informationThe online version contains supplementary material available at 10.1007/s00214-023-03077-7.
Project description:Bovine granulosa cells are often exposed to energy stress, due to the energy demands of lactation, and exposed to lipopolysaccharide from postpartum bacterial infections. Granulosa cells mount innate immune responses to lipopolysaccharide, including the phosphorylation of mitogen-activated protein kinases and production of pro-inflammatory interleukins. Cellular energy depends on glycolysis, and energy stress activates intracellular AMPK (AMP-activated protein kinase), which in turn inhibits mTOR (mechanistic target of rapamycin). Here, we tested the hypothesis that manipulating glycolysis, AMPK or mTOR to mimic energy stress in bovine granulosa cells limits the inflammatory responses to lipopolysaccharide. We inhibited glycolysis, activated AMPK or inhibited mTOR in granulosa cells isolated from 4-8mm and from > 8.5 mm diameter ovarian follicles, and then challenged the cells with lipopolysaccharide and measured the production of interleukins IL-1α, IL-1β, and IL-8. We found that inhibiting glycolysis with 2-deoxy-d-glucose reduced lipopolysaccharide-stimulated IL-1α > 80%, IL-1β > 90%, and IL-8 > 65% in granulosa cells from 4-8 mm and from > 8.5 mm diameter ovarian follicles. Activating AMPK with AICAR also reduced lipopolysaccharide-stimulated IL-1α > 60%, IL-1β > 75%, and IL-8 > 20%, and shortened the duration of lipopolysaccharide-stimulated phosphorylation of the mitogen-activated protein kinase ERK1/2 and JNK. However, only the mTOR inhibitor Torin 1, and not rapamycin, reduced lipopolysaccharide-stimulated IL-1α and IL-1β. In conclusion, manipulating granulosa cell energy metabolism with a glycolysis inhibitor, an AMPK activator, or an mTOR inhibitor, limited inflammatory responses to lipopolysaccharide. Our findings imply that energy stress compromises ovarian follicle immune defences.
Project description:The practical applications of lithium metal anodes in high-energy-density lithium metal batteries have been hindered by their formation and growth of lithium dendrites. Herein, we discover that certain protein could efficiently prevent and eliminate the growth of wispy lithium dendrites, leading to long cycle life and high Coulombic efficiency of lithium metal anodes. We contend that the protein molecules function as a "self-defense" agent, mitigating the formation of lithium embryos, thus mimicking natural, pathological immunization mechanisms. When added into the electrolyte, protein molecules are automatically adsorbed on the surface of lithium metal anodes, particularly on the tips of lithium buds, through spatial conformation and secondary structure transformation from α-helix to β-sheets. This effectively changes the electric field distribution around the tips of lithium buds and results in homogeneous plating and stripping of lithium metal anodes. Furthermore, we develop a slow sustained-release strategy to overcome the limited dispersibility of protein in the ether-based electrolyte and achieve a remarkably enhanced cycling performance of more than 2000 cycles for lithium metal batteries.
Project description:The control of interfaces in engineered nanostructured materials has met limited success compared with that which has evolved in natural materials, where hierarchical structures with distinct interfacial states are often found. Such interface control could mitigate common limitations of engineering nanomaterials. For example, nanostructured metals exhibit extremely high strength, but this benefit comes at the expense of other important properties like ductility. Here, we report a technique for combining nanostructuring with recent advances capable of tuning interface structure, a complementary materials design strategy that allows for unprecedented property combinations. Copper-based alloys with both grain sizes in the nanometre range and distinct grain boundary structural features are created, using segregating dopants and a processing route that favours the formation of amorphous intergranular films. The mechanical behaviour of these alloys shows that the trade-off between strength and ductility typically observed for metallic materials is successfully avoided here.