Simultaneous quantification of lead, cadmium and zinc in superficial marine sediments using a carbon-fiber microelectrode modified with bismuth film
Ontology highlight
ABSTRACT:
SUBMITTER: Fernandez L
PROVIDER: S-EPMC10658076 | biostudies-literature | 2023 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In this paper we report a two octave spanning supercontinuum generation in a bandwidth of 700-3000 nm in a single-mode photonic crystal fiber made of lead-bismuth-gallate glass. To our knowledge this is the broadest supercontinuum reported in heavy metal oxide glass based fibers. The fiber was fabricated using an in-house synthesized glass with optimized nonlinear, rheological and transmission properties in the range of 500-4800 nm. The photonic cladding consists of 8 rings of air holes. The fiber has a zero dispersion wavelength (ZDW) at 1460 nm. Its dispersion is determined mainly by the first ring of holes in the cladding with a relative hole size of 0.73. Relative hole size of the remaining seven rings is 0.54, which allows single mode performance of the fiber in the infrared range and reduces attenuation of the fundamental mode. The fiber is pumped into anomalous dispersion with 150 fs pulses at 1540 nm. Observed spectrum of 700-3000 nm was generated in 2 cm of fiber with pulse energy below 4 nJ. A flatness of 5 dB was observed in 950-2500 nm range.
| S-EPMC5455900 | biostudies-other
Project description:The detection of neuroelectrophysiology while performing optogenetic modulation can provide more reliable and useful information for neural research. In this study, an optical fiber and a microelectrode array were integrated through hot-melt adhesive bonding, which combined optogenetics and electrophysiological detection technology to achieve neuromodulation and neuronal activity recording. We carried out the experiments on the activation and electrophysiological detection of infected neurons at the depth range of 900-1250 μm in the brain which covers hippocampal CA1 and a part of the upper cortical area, analyzed a possible local inhibition circuit by combining opotogenetic modulation and electrophysiological characteristics and explored the effects of different optical patterns and light powers on the neuromodulation. It was found that optogenetics, combined with neural recording technology, could provide more information and ideas for neural circuit recognition. In this study, the optical stimulation with low frequency and large duty cycle induces more intense neuronal activity and larger light power induced more action potentials of neurons within a certain power range (1.032 mW-1.584 mW). The present study provided an efficient method for the detection and modulation of neurons in vivo and an effective tool to study neural circuit in the brain.
| S-EPMC7472634 | biostudies-literature
Project description:Farmland soil typical for the Polish rural environment was used in pot experiment to estimate the impact of cadmium and zinc on the manganese, lead and copper uptake by lemon balm (Melissa officinalis L). Bioavailable and total forms of investigated metals in soil and metal concentrations in plants were determined by atomic absorption spectrometry. The plant photosynthesis indicators were also examined. Intensification of photosynthesis upon the high zinc and cadmium soil supplementation was observed. This effect was not detected at low metal concentrations. ANOVA proved that cadmium and zinc treatments influenced manganese, lead and copper transfer from soil and their concentration in plants. Zinc uptake and accumulation in either roots or above-ground parts in plant was inversely proportional to cadmium concentration in soil. Manganese concentration in roots decreased upon the soil supplementation with either zinc or cadmium. It suggests that the latter ions are transported via symplastic pathways and compete with manganese for similar transporters. The opposite situation was observed for lead and copper. Soil supplementation with cadmium and zinc affects manganese, lead and copper concentrations and photosynthesis intensity in lemon balm plant. The following combined interactions in either normal or stress conditions are important indicators of the migration pathways.
| S-EPMC6997233 | biostudies-literature
Project description:Atmospheric deposition samples were collected over 15 mo at several locations near an operating smelter and an abandoned Pb smelter to investigate the contribution of Pb smelting to depositional fluxes and potential local air quality degradation. Samples were analyzed for As, Cd, Cu, Pb, and Zn and subjected to scanning electron microscopy (SEM)-energy dispersive spectroscopy (EDS). Concentrations of Cd and Pb at both sites were greater than at the control site (p < .05), and significant correlations existed between Cd and Pb concentrations at both sites (p < .05). Monthly depositional flux variations at both sites were similar, with greater deposition during cold and dry periods. Heavy metal(loid)s deposition during these periods was correlated with wind speed. Greater Cd depositional flux differences were found between the smelter and control sites compared with other elements. The SEM images suggested that some particles at the operating smelter site were from Pb smelting material. However, most particles at both sites had no characteristics of smelting, suggesting reactions occurred between the smelter-emitted particles and soil components. The EDS results indicated that atmospheric deposition from both sites had lower Pb concentrations than smelting material or ash. The main atmospheric deposition source at the operating and abandoned sites was likely from the resuspension of heavy metal(loid)-enriched soil particles. Greater risk of air pollution from historical Pb smelting facilities exists years after closing down. Reducing soil wind erosional losses may help reduce heavy metal(loid)s dispersion across environments.
| S-EPMC7963641 | biostudies-literature
Project description:To assess if they were within the safety limits for human consumption, the Cd, Cu, Pb, and Zn contents of fish muscles, bought from separate stalls of the fish markets of nine cities of NW Mexico, were determined by atomic absorption spectrophotometry. Considering all fish and markets, the mean contents were Zn: 23.23 ± 5.83, Cu: 1.72 ± 0.63, Cd: 0.27 ± 0.07, and Pb: 0.09 ± 0.04 µg/g (dry weight). Cu, Zn, and Pb did not reach levels of concern for human consumption, but the high Cd values determined in Mazatlán (Mugil cephalus: 0.48 ± 0.15; Diapterus spp.: 0.57 ± 0.33; Lutjanus spp.: 0.72 ± 0.12; small shark: 0.87 ± 0.19 µg/g dry weight) indicate that this was the only metal of concern for human health because the daily individual consumption of fish muscle to reach the PTDI would be within 0.27 and 0.41 kg.
| S-EPMC3913528 | biostudies-other
Project description:The fabrication of Nano-based shielding materials is an advancing research area in material sciences and nanotechnology. Although bulky lead-based products remain the primary choice for radiation protection, environmental disadvantages and high toxicity limit their potentials, necessitating less costly, compatible, eco-friendly, and light-weight alternatives. The theme of the presented investigation is to compare the ionization radiation shielding potentialities of the lead acetate (LA), lead nitrate (LN), and bismuth nitrate (BN)-doped zinc oxide nanorods-based thin films (ZONRs-TFs) produced via the chemical bath deposition (CBD) technique. The impact of the selected materials' doping content on morphological and structural properties of ZONRs-TF was investigated. The X-ray diffractometer (XRD) analyses of both undoped and doped TFs revealed the existence of hexagonal quartzite crystal structures. The composition analysis by energy dispersive (EDX) detected the corrected elemental compositions of the deposited films. Field emission scanning electronic microscope (FESEM) images of the TFs showed highly porous and irregular surface morphologies of the randomly aligned NRs with cracks and voids. The undoped and 2 wt.% BN-doped TFs showed the smallest and largest grain size of 10.44 nm and 38.98 nm, respectively. The linear attenuation coefficient (µ) values of all the optimally doped ZONRs-TFs measured against the X-ray photon irradiation disclosed their excrement shielding potency. The measured µ values of the ZONRs-TFs displayed the trend of 1 wt.% LA-doped TF > 1 wt.% LN-doped TF > 3 wt.% BN-doped TF > undoped TFs). The values of μ of the ZONRs-TFs can be customized by adjusting the doping contents, which in turn controls the thickness and morphology of the TFs. In short, the proposed new types of the LA-, LN- and BN-doped ZONRs-TFs may contribute towards the development of the prospective ionization radiation shielding materials.
| S-EPMC8746144 | biostudies-literature
Project description:Different aminonaphetalenesulphonic acid derivatives like 5-aminonaphthalene-1-sulphonic acid (5AN1SA), 2-aminonaphthalene-1-sulphonic acid (2AN1SA), 8-aminonaphthalene-2-sulphonic acid (8AN2SA) and 4-amino-3-hydroxynaphthalene-1-sulphonic acid (4A3HN1SA) were used to construct polymer/bismuth film modified electrode for simultaneous determination of Pb(II) and Cd(II) ions with the aim of developing a cheaper and sensitive electrode that could possibly replace Nafion. Among the different modified electrodes, poly (8AN2SA)/bismuth film modified electrodes showed the highest electrochemical response for both ions. These electrochemical results were also supported by density functional theory (DFT) calculations. Based on these experimental and theoretical results, poly (8AN2SA)/bismuth film glassy carbon modified electrode was further investigated to develop a simple and sensitive electrochemical method for the simultaneous determination of Pb(II) and Cd(II) ions. After optimizing the different experimental parameters, the proposed method gave a linear range of 1-40 μg/L with the detection limit of 0.38 and 0.08 μg/L for the simultaneous determination of Pb(II) and Cd(II) ions, respectively.
| S-EPMC8648549 | biostudies-literature
Project description:Lead-zinc deposits are often difficult to classify because clear criteria are lacking. In recent years, new tools, such as Cd and Zn isotopes, have been used to better understand the ore-formation processes and to classify Pb-Zn deposits. Herein, we investigate Cd concentrations, Cd isotope systematics and Zn/Cd ratios in sphalerite from nine Pb-Zn deposits divided into high-temperature systems (e.g., porphyry), low-temperature systems (e.g., Mississippi Valley type [MVT]) and exhalative systems (e.g., sedimentary exhalative [SEDEX]). Our results showed little evidence of fractionation in the high-temperature systems. In the low-temperature systems, Cd concentrations were the highest, but were also highly variable, a result consistent with the higher fractionation of Cd at low temperatures. The δ(114/110)Cd values in low-temperature systems were enriched in heavier isotopes (mean of 0.32 ± 0.31‰). Exhalative systems had the lowest Cd concentrations, with a mean δ(114/110)Cd value of 0.12 ± 0.50‰. We thus conclude that different ore-formation systems result in different characteristic Cd concentrations and fraction levels and that low-temperature processes lead to the most significant fractionation of Cd. Therefore, Cd distribution and isotopic studies can support better understanding of the geochemistry of ore-formation processes and the classification of Pb-Zn deposits.
| S-EPMC4848528 | biostudies-literature
Project description:Colorimetric measurement is a versatile, low-cost method for bio-/chemical sensing and that has importance in biomedical applications. General carbon dioxide (CO2) sensors based on colorimetric change of a pH indicator report only one parameter at a time and are cross-sensitive to relative humidity (RH). This work describes a novel optical fiber sensor with a thin film on the distal end of the fiber, combining colorimetric measurement and a white light Fabry-Pérot interferometer (FPI) for the simultaneous measurement of CO2 and RH. The CO2 sensitive dye ion-pair: thymol blue and tetramethylammonium hydroxide are encapsulated inside organically modified silica forming an extrinsic FPI cavity (refractive index of 1.501 ± 0.02 and thickness of 5.83 ± 0.09 μm). The sensor reversibly responds to 0-6% CO2 and 0-90% RH with negligible cross-sensitivity and allows measurement of both parameters simultaneously. A sensitivity of ∼0.19 nm/%RH is obtained for RH measurement based on the wavelength shift of the FPI and there is a polynomial correlation between the average intensity of selected wavelengths and the concentration of CO2. The applicability of the sensor is demonstrated by measuring the CO2 and RH exhaled from human breath with a percent error of 3.1% and 2.2% respectively compared to a commercial datalogger. A simulation model is provided for the dye-encapsulated FPI sensor allowing simulation of spectra of sensors with different film thicknesses.
| S-EPMC8689145 | biostudies-literature
Project description:Cadmium (Cd) and lead (Pb) are classified as category one toxicants. The provisional guideline values, according to the World Health Organization (WHO), for Cd and Pb are 3 and 10 ppb, respectively. An easy, quick, and cheap analytical technique is in demand for the determination of these toxic heavy metals in water. Hence, a novel electrochemical sensing platform is developed by modifying the glassy carbon electrode with ethylenediaminetetraacetic acid (EDTA)-functionalized reduced graphene oxide (ErGO) for the low-cost simultaneous quantitation of toxic heavy-metal ions, lead and cadmium, in real water samples. EDTA is grafted to the surface of graphene oxide, via amine linkage, and the oxygen functionality is reduced by a green agent, tyrosine. Various physical and electrochemical characterizations of the as-prepared electrocatalytic material were performed by X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, thermogravimetric analysis (TGA), ζ-potential, ultraviolet diffuse reflectance spectroscopy (UV-DRS), cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), etc. The glassy carbon electrode (GCE) is modified with ErGO by a simple drop-casting method for simultaneous metal-ion quantitation by differential pulse voltammetry (DPV). EDTA functionalization of graphene oxide and its further reduction using the green agent enhance the stability and sensitivity of the electrode substrate. The limits of detection for cadmium and lead ions calculated for ErGO/GCE are 1.02 and 2.52 ppb, while the limits of quantification for lead and cadmium ions are 3.41 and 8.4 ppb, and their sensitivities are 0.8 and 0.6 nA/ppb, respectively. Real river water contains 200.2 ± 0.38 ppb of Pb2+ ions (mean ± stdev, n = 3) by the DPV technique, which is validated by ICP-OES analysis.
| S-EPMC9753498 | biostudies-literature