Magnetic Nanoparticles with Fe-N and Fe-C Cores and Carbon Shells Synthesized at High Pressures
Ontology highlight
ABSTRACT:
SUBMITTER: Bagramov R
PROVIDER: S-EPMC10672696 | biostudies-literature | 2023 Nov
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:We sintered bulk trigonal ε-Fe2N (space group: P312) with the high-pressure and high-temperature method. Structural refinements by the Rietveld method result in a trigonal unit cell with parameters of a = 4.7767(1) Å and c = 4.4179(3) Å. ε-Fe2N is ferromagnetic with a Curie temperature of ∼250 K, a saturation magnetization (M s) value of up to 1.2 μB/formula units (f.u.), and comparatively low coercive field. The Vickers hardness was measured, and the results showed that the asymptotic hardness of bulk ε-Fe2N is about 6.5 GPa with a load of 1000 g. Thermogravimetric (TG) analysis shows that ε-Fe2N is thermally stable below 670 K. ε-Fe2N exhibits good metal conductivity, and the electron transport measurements show that the resistivity of it is 172 μΩ cm at room temperature. The theoretical calculations suggest that the conducting states are mainly derive from Fe-3d states.
| S-EPMC8154168 | biostudies-literature
Project description:Magnetic Induction Heating (MIH) of magnetite nanoparticles is employed as a novel synthesis procedure of carbon based magnetic nanocomposites. Magnetic nanoparticles (Fe3O4) and fructose (1:2 weight ratio) were mechanically mixed and submitted to a RF magnetic field (305 kHz). The heat generated by the nanoparticles leads to the decomposition of the sugar and to the formation of an amorphous carbon matrix. Two sets of nanoparticles, with mean diameter sizes of 20 and 100 nm, are comparatively analysed. Structural (X-ray diffraction, Raman spectroscopy, Transmission Electron Microscopy (TEM)), electrical and magnetic (resistivity, SQUID magnetometry) characterizations confirm the nanoparticle carbon coating through the MIH procedure. The percentage of the carbonaceous fraction is suitably increased controlling the magnetic heating capacity of the magnetic nanoparticles. The procedure enables the synthesis of multifunctional nanocomposites with optimized properties to be applied in different technological fields. Particularly, Cr (VI) removal from aqueous media is presented employing the carbon nanocomposite with 20 nm Fe3O4 nanoparticles.
| S-EPMC10160050 | biostudies-literature
Project description:Iron oxide magnetic nanoparticles (NPs) are excellent systems in catalysis and in nanomedicine, where they are mostly immersed in aqueous media. Even though the NP solvation by water is expected to play an active role, the detailed structural insight at the nanostructure oxide/water interface is still missing. Here, based on our previous efforts to obtain accurate models of dehydrated Fe3O4 NPs and of their magnetic properties and through multiscale molecular dynamics simulations combining the density functional tight binding method and force field, we unravel the atomistic details of the short range (chemical) and long range (physical) interfacial effects when magnetite nanoparticles are immersed in water. The influence of the first hydration shell on the structural, electronic and magnetic properties of Fe3O4 NPs is revealed by high-level hybrid density functional calculations. Hydrated Fe3O4 NPs possess larger magnetic moment than dehydrated ones. This work bridges the large gap between experimental studies on solvated Fe3O4 NPs and theoretical investigations on flat Fe3O4 surfaces covered with water and paves the way for further study of Fe3O4 NPs in biological environments.
| S-EPMC8230581 | biostudies-literature
Project description:Undoped and Fe-doped NiO nanoparticles were successfully synthesized using a lyophilization method and systematically characterized through magnetization techniques over a wide temperature range, with varying intensity and frequency of the applied magnetic fields. The Ni1-xFexO nanoparticles can be described by a core-shell model, which reveals that Fe doping enhances exchange interactions in correlation with nanoparticle size reduction. The nanoparticles exhibit a superparamagnetic blocking transition, primarily attributed to their cores, at temperatures ranging from above room temperature to low temperatures, depending on the Fe-doping level and sample synthesis temperature. The nanoparticle shells also exhibit a transition at low temperatures, in this case to a cluster-glass-like state, caused by the dipolar magnetic interactions between the net magnetic moments of the clusters. Their freezing temperature shifts to higher temperatures as the Fe-doping level increases. The existence of an exchange bias interaction was observed, thus validating the core-shell model proposed.
| S-EPMC10746408 | biostudies-literature
Project description:Plasmon-resonant gold nanostars (NSTs) with magnetic cores were synthesized by a multistep sequence from superparamagnetic Fe3O4 nanoparticles (NPs) and evaluated as optical contrast agents under magnetomotive (MM) imaging conditions. Core-shell Fe3O4@Au NPs were prepared in nonpolar organic solvents with nanometer control over shell thickness and with good epitaxy to the Fe3O4 surface. Anisotropic growth was performed in micellar solutions of cetyltrimethylammonium bromide (CTAB) under mildly reducing conditions, resulting in NSTs with physical features similar to those produced from colloidal gold seeds. NSTs could be produced below 100 nm from tip to tip, but seed size had a significant impact on growth habit, with larger seed particles producing submicrometer-sized "morning stars". Both NSTs and aggregated core-shell NPs are responsive to in-plane magnetic field gradients and can provide enhanced near-infrared (NIR) contrast under MM conditions, but do so by different mechanisms. NSTs can modulate polarized NIR scattering with minimal translational motion, giving the appearance of a periodic but stationary "blinking", whereas core-shell NP aggregates require lateral displacement for signal modulation. The polarization-sensitive MM imaging modality offers the dual advantage of enhanced signal quality and reduced background signal and can be applied toward the detection of magnetomotive NSTs in heterogeneous biological samples, as illustrated by their detection inside of granular cells such as macrophages.
| S-EPMC2947563 | biostudies-literature
Project description:In this work, we report a nonaqueous one-step method to synthesize polystyrene macroporous magnetic nanocomposites through high internal phase emulsions (HIPEs) formulated with the deep eutectic solvent (DES) composed of urea:choline chloride (U:ChCl, in a 2:1 molar ratio) as the internal phase and co-stabilized with mixtures of Span 60 surfactant and non-functionalized magnetite nanoparticles (Fe3O4 NPs). The porous structure and the magnetic and lipophilic properties of the nanocomposite materials were easily tailored by varying the amount of Fe3O4 NPs (0, 2, 5 and 10 wt %) and the surfactant Span 60 (0, 5, 10, and 20 wt %) used in the precursor emulsion. The resultant nanocomposite polyHIPEs exhibit high sorption capacity toward different oils (hexane, gasoline, and vegetable oil) due to their high porosity, interconnectivity, and hydrophobic surface. It was observed that the oil sorption capacity was improved when the amount of surfactant decreased and Fe3O4 NPs increased in HIPE formulation. Therefore, polyHIPE formulated with 5 and 10 wt % Span 60 and Fe3O4 NPs, respectively, showed the highest oil sorption capacities of 4.151, 3.556, and 3.266 g g-1 for gasoline, hexane, and vegetable oil, respectively. In addition, the magnetic monoliths were reused for more than ten sorption/desorption cycles without losing their oil sorption capacity.
| S-EPMC9245104 | biostudies-literature
Project description:We have synthesized a novel ferromagnetic material by coating α-Fe2O3 nanoparticles with N-doped carbon matrix using a simple combustion method. Expired paracetamol drugs are used as nitrogen and carbon source. This α-Fe2O3/NC shows ferromagnetic property due to the incorporation of oxygen defects. When used as the Li-ion battery anode, α-Fe2O3/NC shows higher capacity compared to commercial α-Fe2O3 due to the occurrence of both intercalation and conversion reaction. Further, application of magnetic field at the anode of the freshly assembled cell at the first charge-discharge cycle, results in ~two-fold enhancement in specific capacity. For the cycled cell also, increase in the capacity from 80 mAh. g-1 to 150 mAh. g-1 at 5 A. g-1 is observed during the application of magnetic field at the 501st charging cycle. This improved performance is attributed to the field-dependent enhancement of diffusion and convection due to the magnetohydrodynamic effect. Further, application of the magnetic field at 1001st, 1501st and 1751st charging cycles shows improved LIB performance. We can show that not only the magnetic field, magnetic properties of the anode α-Fe2O3/NC also play a crucial role in influencing the battery performance. Moreover, utilization of expired drug helps in dramatically reducing pollution caused by its disposal.
| S-EPMC7305126 | biostudies-literature
Project description:Advanced quantitative TEM/EDXS methods were used to characterize different ultrastructures of magnetic Fe-Au core-shell nanoparticles formed by laser ablation in liquids. The findings demonstrate the presence of Au-rich alloy shells with varying composition in all structures and elemental bcc Fe cores. The identified structures are metastable phases interpreted by analogy to the bulk phase diagram. Based on this, we propose a formation mechanism of these complex ultrastructures. To show the magnetic response of these magnetic core nanoparticles protected by a noble metal shell, we demonstrate the formation of nanostrands in the presence of an external magnetic field. We find that it is possible to control the lengths of these strands by the iron content within the alloy nanoparticles.
| S-EPMC9417649 | biostudies-literature
Project description:A series of triple hierarchical micro-meso-macroporous N-doped carbon shells with hollow cores have been successfully prepared via etching N-doped hollow carbon spheres with CO2 at high temperatures. The surface areas, total pore volumes and micropore percentages of the CO2-activated samples evidently increase with increasing activation temperature from 800 to 950 °C, while the N contents show a contrary trend from 7.6 to 3.8 at%. The pyridinic and graphitic nitrogen groups are dominant among various N-containing groups in the samples. The 950 °C-activated sample (CANHCS-950) has the largest surface area (2072 m2 g-1), pore volume (1.96 cm3 g-1), hierarchical micro-mesopore distributions (1.2, 2.6 and 6.2 nm), hollow macropore cores (~91 nm) and highest relative content of pyridinic and graphitic N groups. This triple micro-meso-macropore system could synergistically enhance the activity because macropores could store up the reactant, mesopores could reduce the transport resistance of the reactants to the active sites, and micropores could be in favor of the accumulation of ions. Therefore, the CANHCS-950 with optimized structure shows the optimal and comparable oxygen reduction reaction (ORR) activity but superior methanol tolerance and long-term durability to commercial Pt/C with a 4e--dominant transfer pathway in alkaline media. These excellent properties in combination with good stability and recyclability make CANHCSs among the most promising metal-free ORR electrocatalysts reported so far in practical applications.
| S-EPMC6199056 | biostudies-literature
Project description:We report the synthesis of magnetite nanoparticles (IOMNPs) using the polyol method performed at elevated temperature (300 °C) and high pressure. The ferromagnetic polyhedral IOMNPs exhibited high saturation magnetizations at room temperature (83 emu/g) and a maximum specific absorption rate (SAR) of 2400 W/gFe in water. The uniform dispersion of IOMNPs in solid matrix led to a monotonous increase of SAR maximum (3600 W/gFe) as the concentration decreased. Cytotoxicity studies on two cell lines (cancer and normal) using Alamar Blues and Neutral Red assays revealed insignificant toxicity of the IOMNPs on the cells up to a concentration of 1000 μg/mL. The cells internalized the IOMNPs inside lysosomes in a dose-dependent manner, with higher amounts of IOMNPs in cancer cells. Intracellular hyperthermia experiments revealed a significant increase in the macroscopic temperatures of the IOMNPs loaded cell suspensions, which depend on the amount of internalized IOMNPs and the alternating magnetic field amplitude. The cancer cells were found to be more sensitive to the intracellular hyperthermia compared to the normal ones. For both cell lines, cells heated at the same macroscopic temperature presented lower viability at higher amplitudes of the alternating magnetic field, indicating the occurrence of mechanical or nanoscale heating effects.
| S-EPMC7285148 | biostudies-literature