Visible Light-Driven Photocatalytic Degradation of Methylene Blue Dye Using a Highly Efficient Mg–Al LDH@g-C3N4@Ag3PO4 Nanocomposite
Ontology highlight
ABSTRACT:
SUBMITTER: Salehi G
PROVIDER: S-EPMC10831848 | biostudies-literature | 2024 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:This paper deals with the preparation of a novel nanocomposite consisted of magnesium-aluminum layered double hydroxide (Mg-Al LDH) and ethylenediaminetetraacetic acid (EDTA) as well as melamine (MA) as an adsorbent. This nanocomposite was utilized to adsorb different dyes such as rhodamine B (RhB) and methylene blue (MB) from water. The prepared adsorbent was characterized using FT-IR, EDS, XRD, TGA, and FE-SEM analyses. The effects of various parameters such as concentration, time, adsorbent dosage, temperature, and pH were tested to investigate their influence on adsorption conditions. Both methylene blue and rhodamine B dyes showed pseudo-second-order adsorption kinetics, and their adsorption followed the Langmuir isotherm. Moreover, the maximum adsorption capacities for methylene blue and rhodamine B were found to be 1111.103 mg/g at 45 °C and 232.558 mg/g at 60 °C, respectively. Additionally, the adsorption processes were found to be spontaneous (ΔG°< 0, for both dyes) and exothermic (ΔH° = -12.42 kJ/mol for methylene blue and ΔH° = -25.84 kJ/mol for rhodamine B) for both dyes. Hydrogen bonding and electrostatic forces are responsible for the interactions occur between the nanocomposite and the functional groups in the dyes. The experimental findings demonstrated a greater adsorption rate of MB than RhB, suggesting the adsorbent's stronger affinity for MB. This preference is likely due to MB's size, specific functional groups, and smaller molecule size, enabling stronger interactions and more efficient access to adsorption sites compared to RhB. Even after recycling 4 times, the dye adsorption percentages of the adsorbent for MB and RhB dyes were 90 % and 87 %, but the desorption percentages of the adsorbate dyes were 85 % and 80 %, respectively. The prepared adsorbent boasts several unique properties, such as the swift and effortless adsorption of MB and RhB dyes, straightforward synthesis, mild adsorption conditions, remarkable efficiency, and the ability to be recycled up to 4 times without a significant decrease in activity.
| S-EPMC11237852 | biostudies-literature
Project description:In the present study, we explored the effectiveness of PES-Ag3PO4/g-C3N4 film photocatalyst in degrading methyl orange dye under visible light irradiation. The PES-Ag3PO4/g-C3N4 film photocatalyst was prepared via a non-solvent-induced phase inversion process and characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), laser scanning microscopy (LSM), X-ray photoelectron spectra (XPS), UV-diffuse reflectance (DRS), and water contact angle. The incorporation of the Ag3PO4/g-C3N4 composite into the PES matrix improved the pristine PES film's hydrophilicity, as evidenced by the reduction of water contact angle from 79.03° to 54.33° for a film containing 15 wt % of Ag3PO4/g-C3N4 composite. The film's photoactivity showed that 13 wt % was the best loading of Ag3PO4/g-C3N4 composite, and the degradation performance was maintained up to three cycles. The •O2- and h+ were the predominant species responsible for the methyl orange degradation.
| S-EPMC8198369 | biostudies-literature
Project description:Decorating photocatalysts with noble metal nanoparticles (e.g., Pt) often increases the catalysts' photocatalytic activity and biomedical properties. Here, a simple and inexpensive method has been developed to prepare a Pt-Ag3PO4/CdS/chitosan composite, which was characterized and used for the visible light-induced photocatalytic and antibacterial studies. This synthesized composite showed superior photocatalytic activity for methylene blue degradation as a hazardous pollutant (the maximum dye degradation was observed in 90 min of treatment) and killing of Gram positive bacterial (Staphylococcus aureus and Bacillus cereus) as well as Gram negative bacteria (Klebsiella pneumoniae, Salmonella typhimurium, Escherichia coli, and Pseudomonas aeruginosa) under visible light irradiation. The antibacterial activity of CdS, CdS/Ag3PO4, and Pt-Ag3PO4/CdS/chitosan against E. coli, Pseudomonas aeruginosa, Salmonella typhimurium, Klebsiella pneumoniae, Staphylococcus aureus, and Bacillus cereus showed the zone of inhibition (mm) under visible light and under dark conditions at a concentration of 20 µg mL-1. Furthermore, the cell viability of the CdS/chitosan, Ag3PO4, Ag3PO4/CdS/chitosan, and Pt-Ag3PO4/CdS/chitosan were investigated on the human embryonic kidney 293 cells (HEK-293), Henrietta Lacks (HeLa), human liver cancer cell line (HepG2), and pheochromocytoma (PC12) cell lines. In addition, the results indicated that the photodegradation rate for Pt-Ag3PO4/CdS/chitosan is 3.53 times higher than that of CdS and 1.73 times higher than that of the CdS/Ag3PO4 composite. Moreover, Pt-Ag3PO4/CdS/chitosan with an optimal amount of CdS killed large areas of different bacteria and different cells separately in a shorter time period under visible-light irradiation, which shows significantly higher efficiency than pure CdS and other CdS/Ag3PO4 composites. The superb performances of this composite are attributed to its privileged properties, such as retarded recombination of photoinduced electron/hole pairs and a large specific surface area, making Pt-Ag3PO4/CdS/chitosan a valuable composite that can be deployed for a range of important applications, such as visible light-induced photocatalysis and antibacterial activity.
| S-EPMC7700689 | biostudies-literature
Project description:Reduced graphene oxide (rGO) was synthesized from a simple, cost-effective, and eco-friendly method by using Capsicum annuum (CA) as reducing agent. The rGO was mixed with SnO2 to synthesize a nanocomposite. The synthesized materials were characterized by Fourier transform infrared spectroscopy, X-ray diffraction, scanning electron microscopy, and UV-visible spectroscopy techniques. The SnO2-C. annuum reduced graphene oxide (CRGO) nanocomposite exhibited a photodegradation efficiency of 97.4% when employed to remove methylene green (MG) dye. The synthesized nanocomposite showed improved photodegradation ability due to its high charge transfer and separation and owing to the presence of the large surface area of the CRGO network system. Degraded water was used in the plant and animal survival study, in which the dye solution treated with CRGO nanocomposite exhibited better growth compared to that of untreated MG solution. Likewise, in the ecotoxicity study, Artemia salina and zebra fish (Danio rerio) survival was found to be enhanced with CRGO nanocomposite-treated dye solution. This finding supports the effectiveness of CRGO/SnO2 nanocomposite for the treatment of MG dye-contaminated effluent samples.
| S-EPMC6963968 | biostudies-literature
Project description: Not available
| S-EPMC10620881 | biostudies-literature
Project description:As the world faces water shortage and pollution crises, the development of novel visible light photocatalysts to purify water resources is urgently needed. Over the past decades, most of the reported photocatalysts have been in powder or granular forms, creating separation and recycling difficulties. To overcome these challenges, a flexible and recyclable heterostructured TiO2/polyvinylidene fluoride/graphitic carbon nitride (TiO2/PVDF/g-C3N4) composite was developed by combining electrospinning, sintering and hydrothermal methods. In the composite, PVDF was used as a support template for removing and separating the photocatalyst from solution. Compared with pure TiO2, the TiO2/PVDF/g-C3N4 composite exhibited the extended light capture range of TiO2 into the visible light region. The photogenerated carriers were efficiently transferred and separated at the contact interface between TiO2 and g-C3N4 under visible light irradiation, which consequently increased the photocatalytic activity of the photocatalyst. In addition, the flexible composites exhibited excellent self-cleaning properties, and the dye on the photocatalysts was completely degraded by the as-prepared materials. Based on the intrinsic low cost, recyclability, absorption of visible light, facile synthesis, self-cleaning properties and good photocatalytic performances of the composite, the photocatalyst is expected to be used for water treatment.
| S-EPMC7023571 | biostudies-literature
Project description:Ag3PO4/g-C3N4 heterojunctions, with different g-C3N4 dosages, were synthesized using an in situ deposition method, and the photocatalytic performance of g-C3N4/Ag3PO4 heterojunctions was studied under simulated sunlight conditions. The results revealed that Ag3PO4/g-C3N4 exhibited excellent photocatalytic degradation activity for rhodamine B (Rh B) and phenol under the same light conditions. When the dosage of g-C3N4 was 30%, the degradation rate of Rh B at 9 min and phenol at 30 min was found to be 99.4% and 97.3%, respectively. After five cycles of the degradation experiment for Rh B, g-C3N4/Ag3PO4 still demonstrated stable photodegradation characteristics. The significant improvement in the photocatalytic activity and stability of g-C3N4/Ag3PO4 was attributed to the rapid charge separation between g-C3N4 and Ag3PO4 during the Z-scheme charge transfer and recombination process.
| S-EPMC8038389 | biostudies-literature
Project description:The design and synthesis of a Z-schematic photocatalytic heterostructure with an intimate interface is of great significance for the migration and separation of photogenerated charge carriers, but still remains a challenge. Here, we developed an efficient Z-scheme organic/inorganic g-C3N4/LDH heterojunction by in situ growing of inorganic CoAl-LDH firmly on organic g-C3N4 nanosheet (NS). Benefiting from the two-dimensional (2D) morphology and the surface exposed pyridine-like nitrogen atoms, the g-C3N4 NS offers efficient trap sits to capture transition metal ions. As such, CoAl-LDH NS can be tightly attached onto the g-C3N4 NS, forming a strong interaction between CoAl-LDH and g-C3N4 via nitrogen-metal bonds. Moreover, the 2D/2D interface provides a high-speed channel for the interfacial charge transfer. As a result, the prepared heterojunction composite exhibits a greatly improved photocatalytic H2 evolution activity, as well as considerable stability. Under visible light irradiation of 4 h, the optimal H2 evolution rate reaches 1952.9 μmol g-1, which is 8.4 times of the bare g-C3N4 NS. The in situ construction of organic/inorganic heterojunction with a chemical-bonded interface may provide guidance for the designing of high-performance heterostructure photocatalysts.
| S-EPMC8539041 | biostudies-literature
Project description:The sulfate removal from acid mine drainage (AMD) water (initial concentration: 5301 mg/L) was investigated by precipitation and/or adsorption using calcium hydroxide (Ca(OH)2) and synthetic layered double hydroxide (LDH) of the Mg/Al type. The exclusive use of LDH efficiently removed sulfates (64.2% reduction); however, alteration of its structure was observed due to low pH. The use of Ca(OH)2 in different doses calculated in relation to gypsum stoichiometry allowed to achieve an 86% removal of sulfates. Depending on the equilibrium pH, gypsum or ettringite were the main identified phases. The two-step removal, involving the use of Ca(OH)2 followed by LDH, was less efficient than the use of the Ca(OH)2/LDH mixture when the stoichiometric amount of Ca(OH)2 in relation to gypsum was applied. The application of mixture resulted in a fast pH increase, which prevented destruction of the LDH structure. Most importantly, the use of mixture significantly reduced the sludge volume and enhanced its settling velocity.
| S-EPMC6679161 | biostudies-literature
Project description:A metal-free C60/CNTs/g-C3N4 nanoheterostructure with excellent visible-light photocatalysis for rhodamine B (Rh B) degradation has been reported. Via a convenient low-temperature solution-phase method, g-C3N4 nanosheets can serve as substrate for dispersion of C60/CNTs. The loading of C60/CNTs onto g-C3N4 nanosheets surfaces significantly enhanced visible-light-driven photocatalytic activity of g-C3N4 catalyst, for oxidation of organic pollutant (Rh B, 100%). Excellent photocatalytic properties of C60/CNTs/g-C3N4 can be predominantly attributed to the intimate interfacial contact among constructing compounds, increased specific surface area and enhanced light adsorption efficiency resulted from C60/CNTs carbon materials. Particularly, the synergistic heterostructure interaction remarkably hinders the electron-hole pairs recombination, giving rise to significantly enhanced photocatalytic performance of C60/CNTs/g-C3N4 in comparison with other counterparts.
| S-EPMC5990724 | biostudies-literature