Perylenetetracarboxylic Diimide Composite Electrodes as Organic Cathode Materials for Rechargeable Sodium-Ion Batteries: A Joint Experimental and Theoretical Study
Ontology highlight
ABSTRACT:
SUBMITTER: Liebl S
PROVIDER: S-EPMC10870290 | biostudies-literature | 2024 Jan
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Aromatic diimides such as naphthalene diimide (NDI) and pyromellitic diimide (MDI) are important building blocks for organic electrode materials. They feature a two-electron redox mechanism that allows for energy storage. Due to the smaller size of MDI compared to NDI its theoretical capacity is higher. Studies on MDI-based small molecule and linear polymer electrodes indicate that MDI is unstable, yet the origin of instability remains unclear. Herein, two cross-linked networks of NDI and MDI are designed. The polymers, termed PNDI-EG and PMDI-EG, are synthesized via cationic polymerization of vinyl ethylene glycol-functionalized NDI and MDI monomers. The cross-linked structures preclude extrinsic degradation pathways (e.g., dissolution in the electrolyte), and thereby facilitate the investigation of intrinsic degradation mechanisms. PMDI-EG-based cathodes are less stable, and the performance of PMDI-EG/Li half cells is markedly inferior compared to PNDI-EG/Li cells. Our comprehensive experimental and quantum-chemical investigation reveals that PMDI-EG undergoes irreversible diimide ring opening upon prolonged charge-discharge cycles, while PNDI-EG remains intact. It is hypothesized that the smaller ring size of the five-membered imide renders MDI more susceptible to side reactions with nucleophiles in the electrolyte, causing rapid loss of capacity during the first cycles.
| S-EPMC11925328 | biostudies-literature
Project description:V2O5 based materials are attractive cathode alternatives due to the many oxidation state switches of vanadium bringing about a high theoretical specific capacity. However, significant capacity losses are eminent for crystalline V2O5 phases related to the irreversible phase transformations and/or vanadium dissolution starting from the first discharge cycle. These problems can be circumvented if amorphous or glassy vanadium oxide phases are employed. Here, we demonstrate vanadate-borate glasses as high capacity cathode materials for rechargeable Li-ion batteries for the first time. The composite electrodes of V2O5 - LiBO(2) glass with reduced graphite oxide (RGO) deliver specific energies around 1000 Wh/kg and retain high specific capacities in the range of ~ 300 mAh/g for the first 100 cycles. V2O5 - LiBO(2) glasses are considered as promising cathode materials for rechargeable Li-ion batteries fabricated through rather simple and cost-efficient methods.
| S-EPMC5382707 | biostudies-literature
Project description:Development of metal-anode rechargeable batteries is a challenging issue. Especially, magnesium rechargeable batteries are promising in that Mg metal can be free from dendrite formation upon charging. However, in case of oxide cathode materials, inserted magnesium tends to form MgO-like rocksalt clusters in a parent phase even with another structure, which causes poor cyclability. Here, a design concept of high-performance cathode materials is shown, based on: i) selecting an element to destabilize the rocksalt-type structure and ii) utilizing the defect-spinel-type structure both to avoid the spinel-to-rocksalt reaction and to secure the migration path of Mg cations. This theoretical and experimental work substantiates that a defect-spinel-type ZnMnO3 meets the above criteria and shows excellent cycle performance exceeding 100 cycles upon Mg insertion/extraction with high potential (≈2.5 V vs Mg2+ /Mg) and capacity (≈100 mAh g-1 ). Thus, this work would provide a design guideline of cathode materials for various multivalent rechargeable batteries.
| S-EPMC11469171 | biostudies-literature
Project description:Recent years have seen an intense and renewed interest in the Mg battery research, naming Mg-S the ≫Holy Grail≪ battery, and expectations that Mg battery system will be able to compete and surpass Li-ion batteries in a matter of years. Considerable progress has been achieved in the field of Mg electrolytes, where several new electrolytes with improved electrochemical performance and favorable chemical properties (non-corrosive, non-nucleophilic) were synthesized. Development in the field of cathodes remains a bit more elusive, with inorganic, sulfur, and organic cathodes all showing their upsides and downsides. This review highlights the recent progress in the field of Mg battery cathodes, paying a special attention to the performance and comparison of the different types of the cathodes. It also aims to define advantages and key challenges in the development of each type of cathodes and finally specific questions that should be addressed in the future research.
| S-EPMC6305455 | biostudies-literature
Project description:One of the most effective cost reduction and green engineering projects is to introduce organic compounds to electrode materials instead of expensive inorganic-based materials. In this work, derivatives of perylene diimide substituted with amino acids (PDI_AAs) showed the characteristics of redox-active organic compounds and were, therefore, used as cathode materials of lithium-ion batteries (LIBs). Among the as-synthesized PDI_AAs, the L-alanine-substituted PDI (PDI_A) showed the most improved cycling performances of 86 mAhg-1 over 150 cycles with retention of 95% at 50 mAg-1. Furthermore, at a high current density of 500 mAg-1, PDI_A exhibited a long-term cycling performance of 47 mAhg-1 (retention to 98%) over 5000 cycles. In addition, ex situ attenuated total reflection Fourier-transform infrared spectroscopy (ATR FT-IR) analysis of electrodes at various charging states showed the mechanism of the charge-discharge process of PDI_A.
| S-EPMC9861502 | biostudies-literature
Project description:Vanadium-oxide-based materials exist with various vanadium oxidation states having rich chemistry and ability to form layered structures. These properties make them suitable for different applications, including energy conversion and storage. Magnesium vanadium oxide materials obtained using simple preparation route were studied as potential cathodes for rechargeable aqueous magnesium ion batteries. Structural characterization of the synthesized materials was performed using XRD and vibrational spectroscopy techniques (FTIR and Raman spectroscopy). Electrochemical behavior of the materials, observed by cyclic voltammetry, was further explained by BVS calculations. Sluggish Mg2+ ion kinetics in MgV2O6 was shown as a result of poor electronic and ionic wiring. Complex redox behavior of the studied materials is dependent on phase composition and metal ion inserted/deinserted into/from the material. Among the studied magnesium vanadium oxides, the multiphase oxide systems exhibited better Mg2+ insertion/deinsertion performances than the single-phase ones. Carbon addition was found to be an effective dual strategy for enhancing the charge storage behavior of MgV2O6.
| S-EPMC9412870 | biostudies-literature
Project description:LiV₃O₈/polytriphenylamine composites are synthesized by a chemical oxidative polymerization process and applied as cathode materials for rechargeable lithium batteries (RLB). The structure, morphology, and electrochemical performances of the composites are characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, galvanostatic discharge/charge tests, and electrochemical impedance spectroscopy. It was found that the polytriphenylamine particles were composited with LiV₃O₈ nanorods which acted as a protective barrier against the side reaction of LiV₃O₈, as well as a conductive network to reduce the reaction resistance among the LiV₃O₈ particles. Among the LiV₃O₈/polytriphenylamine composites, the 17 wt % LVO/PTPAn composite showed the largest d100 spacing. The electrochemical results showed that the 17 wt % LVO/PTPAn composite maintained a discharge capacity of 271 mAh·g-1 at a current density of 60 mA·g-1, as well as maintaining 236 mAh·g-1 at 240 mA·g-1 after 50 cycles, while the bare LiV₃O₈ sample retained only 169 and 148 mAh·g-1, respectively. Electrochemical impedance spectra (EIS) results implied that the 17 wt % LVO/PTPAn composite demonstrated a decreased charge transfer resistance and increased Li⁺ ion diffusion ability, therefore manifesting better rate capability and cycling performance compared to the bare LiV₃O₈ sample.
| S-EPMC5506961 | biostudies-other
Project description:In this work 3,4,9,10-perylenetetracarboxylic diimide (PTCDI) is investigated as electrode material for organic Na-ion batteries. Since PTCDI is a widely used industrial pigment, it may turn out to be a cost-effective, abundant, and environmentally benign cathode material for secondary Na-ion batteries. Among other carbonyl pigments, PTCDI is especially interesting due to its high Na-storage capacity in combination with remarkable high rate capabilities. The detailed analysis of cyclic voltammetry measurements reveals a diffusion-less mechanism, suggesting that Na-ion storage in the PTCDI film allows for exceptionally fast charging/discharging rates. This finding is further corroborated by galvanostatic sodiation measurements at high rates of 17 C (2.3 A g-1 ), showing that 57 % of the theoretically possible capacity of PTCDI, or 78 mAh g-1 , are attained in only 3.5 min charging time.
| S-EPMC7839514 | biostudies-literature
Project description:Multivalent cation rechargeable batteries are expected to perform well as high-capacity storage devices. Rechargeable magnesium batteries have an advantage in terms of resource utilization and safety. Here, we report on sulfur-doped vanadium pentoxide (S-V₂O₅) as a potential material for the cathodes of such a battery; S-V₂O₅ showed a specific capacity of 300 mAh·g-1. S-V₂O₅ was prepared by a method using a low-temperature plasma generated by carbon felt and a 2.45 GHz microwave generator. This study investigates the ability of S-V₂O₅ to achieve high capacity when added to metal oxide. The highest recorded capacity (420 mAh·g-1) was reached with MnO₂ added to composite SMn-V₂O₅, which has a higher proportion of included sulfur than found in S-V₂O₅. Results from transmission electron microscopy, energy-dispersive X-ray spectroscopy, Micro-Raman spectroscopy, and X-ray photoelectron spectroscopy show that the bulk of the SMn-V₂O₅ was the orthorhombic V₂O₅ structure; the surface was a xerogel-like V₂O₅ and a solid solution of MnO₂ and sulfur.
| S-EPMC5452843 | biostudies-other
Project description:Organic materials with the 5,10-dihydrophenazine motif are superior cathode materials for lithium-ion batteries. However, the difficult accessibility and low capacity of such cathodes materials are obstacles to their practical applications. Herein, two novel oligomers, termed poly(5-methyl-10-(2-methacryloxypropyl)-5,10-dihydrophenazine) (PMPPZ) and poly(5-methyl-10-(2-methacryloxyethyl)-5,10-dihydrophenazine) (PMEPZ), were effectively synthesized from an industrial waste phenazine. Both oligomers were exploited successfully as excellent cathode materials for sustainable lithium-ion batteries. PMPPZ and PMEPZ exhibited good electrochemical stability and high initial discharge specific capacities of 88 mA h g-1 and 152 mA h g-1, respectively. Furthermore, upon in situ composition with MWCNTs, a composite material, named PMEPZ-MWCNTs, was achieved with enhanced stability and superior specific discharge capacity with the active-site utilization rate of up to 99%. PMEPZ-MWCNTs delivers high initial discharge capacity of up to 303 mA h g-1 and even 252 mA h g-1 after 300 cycles. Both oligomers exhibit double-electron transfer mechanisms. This work affords an alternative approach to utilizing phenazine as a useful material, circumventing the emission of vast environment harmful gases.
| S-EPMC10119675 | biostudies-literature