Project description:A novel multifunctional chitinase (CmChi3)-encoding gene was cloned from Chitinolyticbacter meiyuanensis and actively expressed in Escherichia coli. Sequence analysis showed that CmChi3 contains two glycoside hydrolase family 18 (GH18) catalytic domains and exhibited low identity with well-characterized chitinases. The optimum pH and temperature of purified recombinant CmChi3 were 6.0 and 50°C, respectively. CmChi3 exhibited strict substrate specificity of 4.1 U/mg toward colloidal chitin (CC) and hydrolyzed it to yield N-acetyl-D-glucosamine (GlcNAc) as the sole end product. An analysis of the hydrolysis products toward N-acetyl chitooligosaccharides (N-acetyl COSs) and CC substrates revealed that CmChi3 exhibits endochitinase, N-acetyl-β-d-glucosaminidase (NAGase), and transglycosylase (TGase) activities. Further studies revealed that the N-terminal catalytic domain of CmChi3 exhibited endo-acting and NAGase activities, while the C-terminal catalytic domain showed exo-acting and TGase activities. The hydrolytic properties and favorable environmental adaptations indicate that CmChi3 holds potential for commercial GlcNAc production from chitin.
Project description:Chemoenzymatic synthesis of N-acetyl-d-neuraminic acid from N-acetyl-d-glucosamine using the spore surface-displayed N-acetyl-d-neuraminic acid aldolase at a high concentration (53.9 g liter(-1)) was achieved in this study. Thus, displaying a target enzyme on the surface of spores might be an alternative for integration of biocatalytic conversion into chemical synthesis.
Project description:BackgroundN-acetyl-β-D-glucosamine (GlcNAc) is widely used as a valuable pharmacological agent and a functional food additive. The traditional chemical process for GlcNAc production has some problems such as high production cost, low yield, and acidic pollution. Hence, to identify a novel chitinase that is suitable for bioconversion of chitin to GlcNAc is of great value.ResultsA novel chitinase gene (PbChi74) from Paenibacillus barengoltzii was cloned and heterologously expressed in Escherichia coli as an intracellular soluble protein. The gene has an open reading frame (ORF) of 2,163 bp encoding 720 amino acids. The recombinant chitinase (PbChi74) was purified to apparent homogeneity with a purification fold of 2.2 and a recovery yield of 57.9%. The molecular mass of the purified enzyme was estimated to be 74.6 kDa and 74.3 kDa by SDS-PAGE and gel filtration, respectively. PbChi74 displayed an acidic pH optimum of 4.5 and a temperature optimum of 65°C. The enzyme showed high activity toward colloidal chitin, glycol chitin, N-acetyl chitooligosaccharides, and p-nitrophenyl N-acetyl β-glucosaminide. PbChi74 hydrolyzed colloidal chitin to yield N-acetyl chitobiose [(GlcNAc)2] at the initial stage, which was further converted to its monomer N-acetyl glucosamine (GlcNAc), suggesting that it is an exochitinase with β-N-acetylglucosaminidase activity. The purified PbChi74 coupled with RmNAG (β-N-acetylglucosaminidase from Rhizomucor miehei) was used to convert colloidal chitin to GlcNAc, and GlcNAc was the sole end product at a concentration of 27.8 mg mL(-1) with a conversion yield of 92.6%. These results suggest that PbChi74 may have great potential in chitin conversion.ConclusionsThe excellent thermostability and hydrolytic properties may give the exochitinase great potential in GlcNAc production from chitin. This is the first report on an exochitinase with N-acetyl-β-D-glucosaminidase activity from Paenibacillus species.
Project description:Poly(furfuryl alcohol) (PFA) is a bioresin synthesized from furfuryl alcohol (FA) that is derived from renewable saccharide-rich biomass. In this study, we compounded this bioresin with polycaprolactone (PCL) for the first time, introducing new functional polymer blends. Although PCL is biodegradable, its production relies on petroleum precursors such as cyclohexanone oils. With the method proposed herein, this dependence on petroleum-derived precursors/monomers is reduced by using PFA without significantly modifying some important properties of the PCL. Polymer blend films were produced by simple solvent casting. The blends were characterized in terms of surface topography by atomic force microscopy (AFM), chemical interactions between PCL and PFA by attenuated total reflection-Fourier transform infrared (ATR-FTIR), crystallinity by XRD, thermal properties by differential scanning calorimetry (DSC), and mechanical properties by tensile tests and biocompatibility by direct and indirect toxicity tests. PFA was found to improve the gas barrier properties of PCL without compromising its mechanical properties, and it demonstrated sustained antioxidant effect with excellent biocompatibility. Our results indicate that these new blends can be potentially used in diverse applications ranging from food packing to biomedical devices.
Project description:A quantitative determination method of N-acetyl-d-glucosamine (GlcNAc) and N,N'-diacetylchitobiose (GlcNAc)(2) is proposed using a proton nuclear magnetic resonance experiment. N-acetyl groups of GlcNAc and (GlcNAc)(2) are chosen as target signals, and the deconvolution technique is used to determine the concentration of the corresponding compound. Compared to the HPLC method, (1)H-NMR spectroscopy is simple and fast. The method can be used for the analysis of chitin hydrolyzed products with real-time analysis, and for quantifying the content of products using internal standards without calibration curves. This method can be used to quickly evaluate chitinase activity. The temperature dependence of (1)H-NMR spectra (VT-NMR) is studied to monitor the chemical shift variation of acetyl peak. The acetyl groups of products are involved in intramolecular H-bonding with the OH group on anomeric sites. The rotation of the acetyl group is closely related to the intramolecular hydrogen bonding pattern, as suggested by the theoretical data (molecular modeling).
Project description:The catalytic transfer hydrogenation of biomass-derived furfural to furfuryl alcohol under mild conditions is an attractive topic in biorefinery. Herein, mesoporous Zr-containing hybrids (Zr-hybrids) with a high surface area (281.9-291.3 m2/g) and large pore volume (0.49-0.74 cm3/g) were prepared using the biomass-derived 5-sulfosalicylic acid as a ligand, and they were proven to be highly efficient for the Meerwein-Ponndorf-Verley reduction of furfural to furfuryl alcohol at 110 °C, with the highest furfuryl alcohol yield reaching up to 97.8%. Characterizations demonstrated that sulfonic and carboxyl groups in 5-sulfosalicylic acid molecules were coordinated with zirconium ions, making zirconium ions fully dispersed, thus leading to the formation of very fine zirconia particles with the diameter of <2 nm in mesoporous Zr-hybrids. The interaction between the 5-sulfosalicylic acid ligands and zirconium ions endowed mesoporous Zr-hybrids with relatively higher acid strength but lower base strength, which was beneficial for the selective reduction of furfural to furfuryl alcohol. A recycling study was performed over a certain mesoporous Zr-hybrid, namely meso-Zr-SA15, demonstrating that the yield and selectivity of furfuryl alcohol remained almost unchanged during the five consecutive reaction cycles. This study provides an optional method to prepare hybrid catalysts for biomass refining by using biomass-derived feedstock.
Project description:Chitinolyticbacter meiyuanensis SYBC-H1, a bacterium capable of hydrolyzing chitin and shrimp shell to N-acetyl glucosamine (GlcNAc) as the only product, was isolated previously. Here, the hydrolysis mechanism of this novel strain toward chitin was investigated. Sequencing and analysis of the complete genome of SYBC-H1 showed that it encodes 32 putatively chitinolytic enzymes including 30 chitinases affiliated with the glycoside hydrolase (GH) families 18 (26) and 19 (4), one GH family 20 β-N-acetylglucosaminidase (NAGase), and one Auxiliary Activities (AA) family 10 lytic polysaccharide monooxygenase (LPMO). However, only eight GH18 chitinases, one AA10 LPMO, and one GH20 NAGase were detected in the culture broth of the strain, according to peptide mass fingerprinting (PMF). Of these, genes encoding chitinolytic enzymes including five GH18 chitinases (Cm711, Cm3636, Cm3638, Cm3639, and Cm3769) and one GH20 NAGase (Cm3245) were successfully expressed in active form in Escherichia coli. The hydrolysis of chitinous substrates showed that Cm711, Cm3636, Cm3638, and Cm3769 were endo-chitinases and Cm3639 was exo-chitinase. Moreover, Cm3639 and Cm3769 can convert the GlcNAc dimer and colloidal chitin (CC) into GlcNAc, which showed that they also possess NAGase activity. In addition, NAGase Cm3245 possesses a very high exo-acting activity of hydrolyzing GlcNAc dimer. These results suggest that chitinases and NAGase from SYBC-H1 both play important roles in conversion of N-acetyl chitooligosaccharides to GlcNAc, resulting in the accumulation of the final product GlcNAc. To our knowledge, this is the first report of the complete genome sequence and chitinolytic enzyme genes discovery of this strain.
Project description:A novel route for the production of the versatile chemical building block phthalide from biorenewable furfuryl alcohol and acrylate esters is presented. Two challenges that limit sustainable aromatics production via Diels-Alder (DA) aromatisation-an unfavourable equilibrium position and undesired regioselectivity when using asymmetric addends-were addressed using a dynamic kinetic trapping strategy. Activated acrylates were used to speed up the forward and reverse DA reactions, allowing for one of the four DA adducts to undergo a selective intramolecular lactonisation reaction in the presence of a weak base. The adduct is removed from the equilibrium pool, pulling the system completely to the product with a fixed, desired regiochemistry. A single 1,2-regioisomeric lactone product was formed in up to 86 % yield and the acrylate activating agent liberated for reuse. The lactone was aromatised to give phthalide in almost quantitative yield in the presence of Ac2 O and a catalytic amount of strong acid, or in 79 % using only catalytic acid.
Project description:The nitration of chitin monomer in a mixture of nitric acid and acetic anhydride was conducted and a highly nitrated (3R,4R,6R)-3-acetamido-6-((nitrooxy)methyl)tetrahydro-2H-pyran-2,4,5-triyl trinitrate (1) was obtained. Its structure was fully characterized using infrared spectroscopy, NMR spectroscopy, elemental analysis, and X-ray diffraction. Compound 1 possesses good density (ρ: 1.721 g·cm-3) and has comparable detonation performance (Vd: 7717 m·s-1; P: 25.6 GPa) to that of nitrocellulose (NC: Vd: 7456 m·s-1; P: 23 GPa; Isp = 239 s) and microcrystalline nitrocellulose (MCNC; Vd: 7683 m·s-1; P: 25 GPa; Isp = 250 s). However, Compound 1 has much lower impact sensitivity (IS: 15 J) than the regular nitrocellulose (NC; IS: 3.2 J) and MCNC (IS: 2.8 J). Compound 1 was calculated to exhibit a good specific impulse (Isp: 240 s), which is comparable with NC (Isp: 239 s) and MCNC (Isp: 250 s). By replacing the nitrocellulose with Compound 1 in typical propellants JA2, M30, and M9, the specific impulse was improved by up to 4 s. These promising properties indicate that Compound 1 has a significant potential as an energetic component in solid propellants.
Project description:The racemic synthesis of new carbocyclic nucleoside methylphosphonate analogues bearing purine bases (adenine and guanine) was accomplished using bio-sourced furfuryl alcohol derivatives. All compounds were prepared using a Mitsunobu coupling between the heterocyclic base and an appropriate carbocyclic precursor. After deprotection, the compounds were evaluated for their activity against a large number of viruses. However, none of them showed significant antiviral activity or cytotoxicity.