Two-Dimensional Nanoporous Cross-linked Polymer Networks as Emerging Candidates for Gas Adsorption
Ontology highlight
ABSTRACT:
SUBMITTER: Aliyev E
PROVIDER: S-EPMC10993420 | biostudies-literature | 2024 Mar
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Despite their level of refinement, micro-mechanical, stretch-based and invariant-based models, still fail to capture and describe all aspects of the mechanical properties of polymer networks for which they were developed. This is for an important part caused by the way the microscopic inhomogeneities are treated. The Elastic Network Model (ENM) approach of reintroducing the spatial resolution by considering the network at the level of its topological constraints, is able to predict the macroscopic properties of polymer networks up to the point of failure. We here demonstrate the ability of ENM to highlight the effects of topology and structure on the mechanical properties of polymer networks for which the heterogeneity is characterised by spatial and topological order parameters. We quantify the macro- and microscopic effects on forces and stress caused by introducing and increasing the heterogeneity of the network. We find that significant differences in the mechanical responses arise between networks with a similar topology but different spatial structure at the time of the reticulation, whereas the dispersion of the cross-link valency has a negligible impact.
| S-EPMC7957597 | biostudies-literature
Project description:Nanoporous membranes with two-dimensional materials such as graphene oxide have attracted attention in volatile organic compounds (VOCs) and H2 adsorption because of their unique molecular sieving properties and operational simplicity. However, agglomeration of graphene sheets and low efficiency remain challenging. Therefore, we designed hierarchical nanoporous membranes (HNMs), a class of nanocomposites combined with a carbon sphere and graphene oxide. Hierarchical carbon spheres, prepared following Murray's law using chemical activation incorporating microwave heating, act as spacers and adsorbents. Hierarchical carbon spheres preclude the agglomeration of graphene oxide, while graphene oxide sheets physically disperse, ensuring structural stability. The obtained HNMs contain micropores that are dominated by a combination of ultramicropores and mesopores, resulting in high VOCs/H2 adsorption capacity, up to 235 and 352 mg/g at 200 ppmv and 3.3 weight % (77 K and 1.2 bar), respectively. Our work substantially expands the potential for HNMs applications in the environmental and energy fields.
| S-EPMC7541071 | biostudies-literature
Project description:Photo-responsive nanoporous polymer films (AZOF-R(NC6)) have been developed by a template method based on a hydrogen-bonding supramolecular liquid crystal (LC) and a light-sensitive azobenzene LC crosslinker in this work. Anionic nanopores were obtained after the removal of template NC6 using KOH solution. The AZOF-R(NC6) demonstrates charge-selective dye adsorption and the maximum adsorption capacity for Rh6G is 504.6 mg g-1. The AZOF-R(NC6) film without UV light treatment shows a 32% higher adsorption capacity for Rh6G than the AZOF-R(NC6) film treated with UV light within the initial 10 min. In addition, UV light can trigger the release of the adsorbed dye from the polymer film due to the pore size change arising from the trans-cis isomerization. Besides, the used polymer film can be effectively regenerated using a HCl solution. Such functional polymer films with highly ordered nanopores and photo-responsive properties hold great promise in selective adsorption and mass separations.
| S-EPMC10759169 | biostudies-literature
Project description:We report here the nonlinear rheological properties of metallo-supramolecular networks formed by the reversible cross-linking of semi-dilute unentangled solutions of poly(4-vinylpyridine) (PVP) in dimethyl sulfoxide (DMSO). The reversible cross-linkers are bis-Pd(II) or bis-Pt(II) complexes that coordinate to the pyridine functional groups on the PVP. Under steady shear, shear thickening is observed above a critical shear rate, and that critical shear rate is experimentally correlated with the lifetime of the metal-ligand bond. The onset and magnitude of the shear thickening depend on the amount of cross-linkers added. In contrast to the behavior observed in most transient networks, the time scale of network relaxation is found to increase during shear thickening. The primary mechanism of shear thickening is ascribed to the shear-induced transformation of intrachain cross-linking to interchain cross-linking, rather than nonlinear high tension along polymer chains that are stretched beyond the Gaussian range.
| S-EPMC2869658 | biostudies-literature
Project description:Mechanically adaptive materials that soften upon exposure to physiological conditions are useful for biomedical applications, notably as substrates for implantable neural electrodes. So far, device fabrication efforts have largely relied on shaping such devices by laser cutting, but this process makes it difficult to produce complex electrode architectures and leads to ill-defined surface chemistries. Here, we report mechanically adaptive, physiologically responsive polymers that can be photopolymerized and thus patterned via soft lithography and photolithography. The adaptive polymer networks produced exhibit, in optimized compositions, a ca. 500-fold decrease of their storage modulus when exposed to simulated physiological conditions, for example, from 2.5 GPa to 5 MPa. This effect is caused by modest swelling (30% w/w), which in turn leads to plasticization so that the polymer network's glass transition temperature is reduced from 145 to 25 °C. The polymer networks can further be rendered pH-responsive by the incorporation of methacrylic acid. The dual stimuli-responsive materials thus made show promise as coatings or substrates for drug delivery devices.
| S-EPMC7034001 | biostudies-literature
Project description:The large amplitude oscillatory shear behavior of metallo-supramolecular polymer networks formed by adding bis-Pd(II) cross-linkers to poly(4-vinylpyridine) (PVP) in dimethyl sulfoxide (DMSO) solution is reported. The influence of scanning frequency, dissociation rate of cross-linkers, concentration of cross-linkers, and concentration of PVP solution on the large amplitude oscillatory shear behavior is explored. In semidilute unentangled PVP solutions, above a critical scanning frequency, strain hardening of both storage moduli and loss moduli is observed. In the semidilute entangled regime of PVP solution, however, strain softening is observed for samples with faster cross-linkers (k(d) ∼ 1450 s(-1)), whereas strain hardening is observed for samples with slower cross-linkers (k(d) ∼ 17 s(-1)). The mechanism of strain hardening is attributed primarily to a strain-induced increase in the number of elastically active chains, with possible contributions from non-Gaussian stretching of polymer chains at strains approaching network fracture. The divergent strain softening of samples with faster cross-linkers in semidilute entangled PVP solutions, relative to the strain hardening of samples with slower cross-linkers, is consistent with observed shear thinning/shear thickening behavior reported previously and is attributed to the fact that the average time that a cross-linker remains detached is too short to permit the local relaxation of polymer chain segments that is necessary for a net conversion of elastically inactive to elastically active cross-linkers. These and other observations paint a picture in which strain softening and shear thinning arise from the same set of molecular mechanisms, conceptually uniting the two nonlinear responses for this system.
| S-EPMC3203206 | biostudies-literature
Project description:Long-term (multiple-week or -month) release of small, water-soluble molecules from hydrogels remains a significant pharmaceutical challenge, which is typically overcome at the expense of more-complicated drug carrier designs. Such approaches are payload-specific and include covalent conjugation of drugs to base materials or incorporation of micro- and nanoparticles. As a simpler alternative, here we report a mild and simple method for achieving multiple-month release of small molecules from gel-like polymer networks. Densely cross-linked matrices were prepared through ionotropic gelation of poly(allylamine hydrochloride) (PAH) with either pyrophosphate (PPi) or tripolyphosphate (TPP), all of which are commonly available commercial molecules. The loading of model small molecules (Fast Green FCF and Rhodamine B dyes) within these polymer networks increases with the payload/network binding strength and with the PAH and payload concentrations used during encapsulation. Once loaded into the PAH/PPi and PAH/TPP ionic networks, only a few percent of the payload is released over multiple months. This extended release is achieved regardless of the payload/network binding strength and likely reflects the small hydrodynamic mesh size within the gel-like matrices. Furthermore, the PAH/TPP networks show promising in vitro cytocompatibility with model cells (human dermal fibroblasts), though slight cytotoxic effects were exhibited by the PAH/PPi networks. Taken together, the above findings suggest that PAH/PPi and (especially) PAH/TPP networks might be attractive materials for the multiple-month delivery of drugs and other active molecules (e.g., fragrances or disinfectants).
| S-EPMC4768684 | biostudies-literature
Project description:Magnetic carboxyl functional nanoporous polymer (MCFNP) was chemically fabricated by incorporation of magnetic Fe3O4 precursor into the carboxyl functional nanoporous polymer (CFNP). The as-synthesized MCFNP was characterized and used as an adsorbent for rapid adsorption removal of methylene blue (MB) from wastewater. Several experimental parameters affecting the adsorption efficiency were investigated including initial pH, adsorbent dosage, initial MB concentration, contact time and temperature. The adsorption behavior of MCFNP displayed that adsorption kinetics and isotherms could be well fitted to the pseudo-second-order and Langmuir models, respectively. The experimental results showed that MCFNP was an effective adsorbent with a maximum adsorption capacity of 57.74 mg g-1 for MB at 298 K. The negative free energy (ΔG) and positive enthalpy change (ΔH) confirmed that the adsorption reaction was a spontaneous and endothermic process. In addition, ethanol was used as an effective extractant for the regeneration of MCFNP, and the adsorption efficiency could remain 80% after the ninth regeneration cycle.
| S-EPMC5916890 | biostudies-literature
Project description:Adsorption of polymers from the solution phase has been extensively studied to cope with many demands not only for separation technologies, but also for the development of coatings, adhesives, and biocompatible materials. Most studies hitherto focus on adsorption on flat surfaces and mesoporous adsorbents with open frameworks, plausibly because of the preconceived notion that it is unlikely for polymers to enter a pore with a diameter that is smaller than the gyration diameter of the polymer in solution; therefore, sub-nanoporous materials are rarely considered as a polymer adsorption medium. Here we report that polyethylene glycols (PEGs) are adsorbed into sub-nanometer one-dimensional (1D) pores of metal-organic frameworks (MOFs) from various solvents. Isothermal adsorption experiments reveal a unique solvent dependence, which is explained by the balance between polymer solvation propensity for each solvent and enthalpic contributions that compensate for potential entropic losses from uncoiling upon pore admission. In addition, adsorption kinetics identify a peculiar molecular weight (MW) dependence. While short PEGs are adsorbed faster than long ones in single-component adsorption experiments, the opposite trend was observed in double-component competitive experiments. A two-step insertion process consisting of (1) an enthalpy-driven recognition step followed by (2) diffusion regulated infiltration in the restricted 1D channels explains the intriguing selectivity of polymer uptake. Furthermore, liquid chromatography using the MOFs as the stationary phase resulted in significant PEG retention that depends on the MW and temperature. This study provides further insights into the mechanism and thermodynamics behind the present polymer adsorption system, rendering it as a promising method for polymer analysis and separation.
| S-EPMC8494126 | biostudies-literature
Project description:The selective and efficient capture of phosphopeptides is critical for comprehensive and in-depth phosphoproteome analysis. Here we report a new switchable two-dimensional (2D) supramolecular polymer that serves as an ideal platform for the enrichment of phosphopeptides. A well-defined, positively charged metallacycle incorporated into the polymer endows the resultant polymer with a high affinity for phosphopeptides. Importantly, the stimuli-responsive nature of the polymer facilitates switchable binding affinity of phosphopeptides, thus resulting in an excellent performance in phosphopeptide enrichment and separation from model proteins. The polymer has a high enrichment capacity (165 mg/g) and detection sensitivity (2 fmol), high enrichment recovery (88%), excellent specificity, and rapid enrichment and separation properties. Additionally, we have demonstrated the capture of phosphopeptides from the tryptic digest of real biosamples, thus illustrating the potential of this polymeric material in phosphoproteomic studies.
| S-EPMC8193630 | biostudies-literature