Periarticular cocktail injection is more useful than nerve blocks for pain management after anterior cruciate ligament reconstruction
Ontology highlight
ABSTRACT:
SUBMITTER: Kanayama T
PROVIDER: S-EPMC10995970 | biostudies-literature | 2024 Apr
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Arthroscopic anterior cruciate ligament reconstruction is a common procedure that requires effective postoperative pain management for successful rehabilitation. Opioids are traditionally used for pain relief, but their side effects decrease their widespread use. Local anesthesia techniques have gained interest as an alternative to opioids. This Technical Note discusses the use of an anesthetic cocktail for pain relief at the hamstring's donor site in anterior cruciate ligament reconstruction. This approach may enhance early rehabilitation and patient satisfaction.
| S-EPMC10837842 | biostudies-literature
Project description:Knee arthroscopy has allowed us to continue performing surgeries that are minimally invasive and allow patients to have a quick recovery. Multiligamentous knee reconstruction with regards to the anterior cruciate ligament and posterior cruciate ligament can be done in a minimally invasive matter. Visualization is an issue during this surgery, especially looking in the posterior compartment of the knee. The NanoScope (Arthrex, Naples, FL) continues to provide increased possibilities for orthopaedic surgeons. Our technique provides a less-invasive way to observe the posterior compartment to assist the drilling of the tibial tunnel during the posterior cruciate ligament reconstruction. This technique provides distinct advantages over other treatments.
| S-EPMC8322670 | biostudies-literature
Project description:The outcomes of double-bundle anterior cruciate ligament (ACL) reconstruction leave room for improvement. We hope to augment double-bundle ACL reconstruction with the reconstruction of an ACL-mimicking anterolateral structure (ALS). Thus, we would like to introduce a combined double-bundle ACL reconstruction and ACL-mimicking ALS reconstruction technique. The main indication for this technique is ACL injury with a high degree of pivot shift test, general laxity, or near critical value of the posterior tibial slope. The main steps in this technique include preparation of an isolated graft for the anteromedial bundle of the ACL and a combined graft for the posterolateral bundle of the ACL and ALS, creation of three tibial tunnels and two femoral tunnels, graft placement, and final graft fixation at an adjustable loop. We have obtained promising clinical outcomes with this technique and consider that this report will provide new options in ACL reconstruction.
| S-EPMC7451438 | biostudies-literature
Project description:Anterior cruciate ligament (ACL) reconstruction with preservation of either the remnant or the tibial stump is performed with the hope of improving the vascularization and proprioceptive function of the graft. Remnant preservation is technically difficult because it hinders the visualization of the intra-articular tunnel site. Taking a cue from the concept of tibial stump preservation, we have modified our ACL reconstruction technique to preserve a sleeve of the soft tissue and ACL stump attached to the femoral condyle, in addition to tibial stump preservation, while still allowing adequate visualization of the femoral ACL insertion site. We describe our modification in this article and hypothesize that this should further improve graft vascularization and ligamentization.
| S-EPMC4246405 | biostudies-literature
Project description:Various degree of remnant tissues exists following anterior cruciate ligament (ACL) injury. Making use of these tissues may be helpful for the reconstructed ACL from many aspects. There are many methods of remnant preservation and use, as well as many types of combined ACL reconstruction. However, the most effective methods of remnant reuse as well as ACL reconstruction are still being pursued. We introduce an anatomical double-bundle transtibial ACL reconstruction with in-between remnant preservation technique named sandwich-style ACL reconstruction. The indication of this technique is complete ACL tear with a large volume of connectable remnant. The main tricks of this technique are proper ligation of the remnant, proper location of the anteromedial-bundle tibial tunnels, and passing the anteromedial bundle through the shallow side of the remnant. We believe the introduction of this technique will provide more options for remnant preservation and ACL reconstruction.
| S-EPMC8085440 | biostudies-literature
Project description:Despite technologic advances in the surgical technique for anterior cruciate ligament (ACL) reconstruction, some patients continue to have rotational instability postoperatively. Recently, authors have reported the anatomic and functional characteristics of the anterolateral ligament (ALL), a structure that originates near the lateral epicondyle on the femur and inserts on the tibia between the Gerdy tubercle and the fibular head. Recent biomechanical studies have shown the ALL is an important stabilizer against anterolateral tibial rotation, and its reconstruction has shown excellent initial clinical results. Several techniques have been developed to try to anatomically address this structure in the setting of an ACL reconstruction. This article details a simple anatomic technique to reconstruct the ACL and the ALL of the knee using hamstring tendon autograft and maintaining the semitendinosus insertion.
| S-EPMC5263705 | biostudies-literature
Project description:Arthroscopic anterior cruciate ligament reconstruction (ACL-R) is a technique that continues to evolve. Good results have been established with respect to reducing anteroposterior laxity. However, these results have come into question because nonanatomic techniques have been ineffective at restoring knee kinematics and raised concerns that abnormal kinematics may impact long-term knee health. Anatomic ACL-R attempts to closely reproduce the patient's individual anatomic characteristics. Measurements of the patient's anatomy help determine graft choice and whether anatomic reconstruction should be performed with a single- or double-bundle technique. The bony landmarks and insertions of the anterior cruciate ligament (ACL) are preserved to assist with anatomic placement of both tibial and femoral tunnels. An anatomic single- or double-bundle reconstruction is performed with a goal of reproducing the characteristics of the native ACL. Long-term outcomes for anatomic ACL reconstruction are unknown. By individualizing ACL-R, we strive to reproduce the patient's native anatomy and restore knee kinematics to improve patient outcomes.
| S-EPMC3678631 | biostudies-literature
Project description:The bone-tendon-bone (BTB) autograft is widely used for anterior cruciate ligament (ACL) reconstruction. However, the primary disadvantages of this technique include postoperative kneeling pain, the risk of perioperative patellar fracture, and graft-tunnel mismatch. Therefore, a single bone plug technique for ACL reconstructions was developed to mitigate the disadvantages of the BTB technique. To differentiate this graft, we have coined the term BTA, for bone-tendon-autograft. The middle third of the patellar tendon is used with a typical width of 10 to 11 mm. A standard tibial tubercle bone plug is harvested. The length of the patellar tendon and graft construct is then measured. If the tendon is >45 mm and the construct at least 70 mm, then we proceed with the BTA technique. At the inferior pole of the patella, electrocautery is used to harvest the tendon from the patella. The advantages of this technique include faster graft harvest and preparation. Obviating the patellar bone plug harvest should eliminate the risk of perioperative patellar fracture and theoretically will mitigate donor site morbidity and kneeling pain, 2 of the most commonly cited complications of the use of BTB autografts for ACL reconstruction. In conclusion, the BTA technique is a reliable technique for ACL reconstruction.
| S-EPMC7587499 | biostudies-literature
Project description:Fixation of the graft during anterior cruciate ligament reconstruction surgery has been the subject of numerous technical innovations but still remains a challenge. This article describes a novel technique of graft fixation for hamstring tendon reconstruction: the Cage For One system (Sacimex, Aix-en-Provence, France). The technique uses only the semitendinosus tendon, which is looped to create a 4-strand graft. Leaving the gracilis tendon intact probably reduces the loss of knee flexion strength. The graft is indirectly anchored into both tunnels with polyetheretherketone cages by use of polyethylene terephthalate tape strips. Both cages and strips are magnetic resonance imaging compatible and do not create artifacts. The tunnels are drilled by an outside-in method with minimal incisions. This type of fixation creates a 360° bone contact at 1.5 cm in each tunnel and is compatible with double-bundle reconstruction. This easy-to-use novel technique of fixation for anterior cruciate ligament reconstruction produces a strong 4-strand graft while harvesting only the semitendinosus tendon and leaving the gracilis tendon intact to reduce flexion strength loss and preserve rotatory stability of the knee. It creates an immediate solid fixation that is independent of graft integration in the early postoperative period, allowing the patient to start immediate rehabilitation without the use of a brace.
| S-EPMC3678617 | biostudies-literature
Project description:A double-bundle anterior cruciate ligament (ACL) reconstruction associated with an anterolateral ligament (ALL) reconstructions is performed. The semitendinosus and gracilis are harvested. At knee maximum flexion, the anteromedial (AM) femoral tunnel is performed in the AM footprint area. Through the anterolateral portal, the tip of the outside-in femoral guide is placed in the posterolateral footprint area. The guide sleeve is pushed onto the lateral femoral cortex at the ALL attachment. At 110° knee flexion, the posterolateral-ALL tunnel is performed. The tibial ACL tunnel is performed as usual. The tibial guide is placed between the ALL tibial attachment and the tibial ACL tunnel entrance to perform the ALL tibial tunnel. The gracilis graft is introduced from caudal to cranial, achieving fixation with a 6-mm diameter screw (outside-in). The AM femoral fixation is achieved with a suspension device. ACL tibial graft fixation is achieved with a screw. Afterward, the gracilis is passed under the fascia lata to the tibial entry point. A 6-mm diameter screw is placed from the external cortex into the tibial ALL tunnel. The biomechanical advantage of the double-bundle ACL reconstruction with the biomechanical advantage of the ALL anatomic reconstruction is achieved.
| S-EPMC6112256 | biostudies-literature