Dataset Information

Prototyping a low-cost residential air quality device using ultraviolet germicidal irradiation (UVGI) light.

ABSTRACT: Many New Zealand residential dwellings suffer from dampness and fungi during the winter, which can cause respiratory health problems. This can be due to poor insulation and ventilation, and the situation worsens when residents cannot afford to heat the dwelling. The main aim of this paper is to modify an existing dehumidifier so that it can remove moisture, heat the living space and reduce fungi growth and bacteria. To achieve that, we installed ultraviolet germicidal lights (UVGI) in an existing dehumidifier with a total cost of USD $150.7 (NZD $213.76). The UVGI lights are known to be efficient in destroying the DNA of fungi and bacteria. The results show that the device reduced the fungi growth and did increase the room temperature because the dehumidifier captured two litres of water over 24 h of testing. The proposed device did achieve a reduction in particulate matters, from 0.9 μg/m3 to 0.14 μg/m3 and an acceptable range of relative humidity below 50%, which reduces the favourable conditions for fungi growth. Therefore, our proposed low-cost device does improve the indoor air quality (IAQ) in the living space.

SUBMITTER: Al-Rawi M

PROVIDER: S-EPMC9058593 | biostudies-literature | 2022 Apr

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Prototyping a low-cost residential air quality device using ultraviolet germicidal irradiation (UVGI) light.

Al-Rawi Mohammad M Lazonby Annette A Smith Callan C

HardwareX 20211216

Many New Zealand residential dwellings suffer from dampness and fungi during the winter, which can cause respiratory health problems. This can be due to poor insulation and ventilation, and the situation worsens when residents cannot afford to heat the dwelling. The main aim of this paper is to modify an existing dehumidifier so that it can remove moisture, heat the living space and reduce fungi growth and bacteria. To achieve that, we installed ultraviolet germicidal lights (UVGI) in an existin ...[more]

PMID: 35509924

Similar Datasets

Project description:Ambulances are frequently contaminated with infectious microorganisms shed by patients during transport that can be transferred to subsequent patients and emergency medical service workers. Manual decontamination is tedious and time-consuming, and persistent contamination is common even after cleaning. Ultraviolet germicidal irradiation (UVGI) has been proposed as a terminal disinfection method for ambulance patient compartments. However, no published studies have tested the use of UVGI in ambulances. The objectives of this study were to investigate the efficacy of a UVGI system in an ambulance patient compartment and to examine the impact of UVGI fixture position and the UV reflectivity of interior surfaces on the time required for disinfection. A UVGI fixture was placed in the front, middle, or back of an ambulance patient compartment, and the UV irradiance was measured at 49 locations. Aluminum sheets and UV-reflective paint were added to examine the effects of increasing surface reflectivity on disinfection time. Disinfection tests were conducted using Bacillus subtilis spores as a surrogate for pathogens. Our results showed that the UV irradiance varied considerably depending upon the surface location. For example, with the UVGI fixture in the back position and without the addition of UV-reflective surfaces, the most irradiated location received a dose of UVGI sufficient for disinfection in 16 s, but the least irradiated location required 15 hr. Because the overall time required to disinfect all of the interior surfaces is determined by the time required to disinfect the surfaces receiving the lowest irradiation levels, the patient compartment disinfection times for different UVGI configurations ranged from 16.5 hr to 59 min depending upon the UVGI fixture position and the interior surface reflectivity. These results indicate that UVGI systems can reduce microbial surface contamination in ambulance compartments, but the systems must be rigorously validated before deployment. Optimizing the UVGI fixture position and increasing the UV reflectivity of the interior surfaces can substantially improve the performance of a UVGI system and reduce the time required for disinfection.

Dataset Information

Prototyping a low-cost residential air quality device using ultraviolet germicidal irradiation (UVGI) light.

Publications

Prototyping a low-cost residential air quality device using ultraviolet germicidal irradiation (UVGI) light.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets