UV-induced syntheses of surfactant-free precious metal nanoparticles in alkaline methanol and ethanol.
Ontology highlight
ABSTRACT:
SUBMITTER: Quinson J
PROVIDER: S-EPMC9417515 | biostudies-literature | 2020 Jun
REPOSITORIES: biostudies-literature
Publications
UV-induced syntheses of surfactant-free precious metal nanoparticles in alkaline methanol and ethanol.
Quinson Jonathan J Kacenauskaite Laura L Schröder Johanna J Simonsen Søren B SB Theil Kuhn Luise L Vosch Tom T Arenz Matthias M
Nanoscale advances 20200511 6
Surfactant-free UV-induced syntheses of Pt and Ir nanoparticles in alkaline methanol and ethanol are presented. Small size nanoparticles <i>ca.</i> 2 nm in diameter are obtained without surfactants in a wide range of base concentration. ...[more]
Similar Datasets
Project description:Direct methanol fuel cells (DMFCs) hold great promise for applications ranging from portable power for electronics to transportation. However, apart from the high costs, current Pt-based cathodes in DMFCs suffer significantly from performance loss due to severe methanol crossover from anode to cathode. The migrated methanol in cathodes tends to contaminate Pt active sites through yielding a mixed potential region resulting from oxygen reduction reaction and methanol oxidation reaction. Therefore, highly methanol-tolerant cathodes must be developed before DMFC technologies become viable. The newly developed reduced graphene oxide (rGO)-based Fe-N-C cathode exhibits high methanol tolerance and exceeds the performance of current Pt cathodes, as evidenced by both rotating disk electrode and DMFC tests. While the morphology of 2D rGO is largely preserved, the resulting Fe-N-rGO catalyst provides a more unique porous structure. DMFC tests with various methanol concentrations are systematically studied using the best performing Fe-N-rGO catalyst. At feed concentrations greater than 2.0 m, the obtained DMFC performance from the Fe-N-rGO cathode is found to start exceeding that of a Pt/C cathode. This work will open a new avenue to use nonprecious metal cathode for advanced DMFC technologies with increased performance and at significantly reduced cost.
| S-EPMC5102660 | biostudies-literature
Project description:A surfactant-free synthesis of precious metal nanoparticles (NPs) performed in alkaline low-boiling-point solvents has been recently reported. Monoalcohols are here investigated as solvents and reducing agents to obtain colloidal Os nanoparticles by using low-temperature (<100 °C) surfactant-free syntheses. The effect of the precursor (OsCl3 or H2OsCl6), precursor concentration (up to 100 mM), solvent (methanol or ethanol), presence or absence of a base (NaOH), and addition of water (0 to 100 vol %) on the resulting nanomaterials is discussed. It is found that no base is required to obtain Os nanoparticles as opposed to the case of Pt or Ir NPs. The robustness of the synthesis for a precursor concentration up to 100 mM allows for the performance of X-ray total scattering with pair distribution function (PDF) analysis, which shows that 1-2 nm hexagonal close packed (hcp) NPs are formed from chain-like [OsO x Cl y ] complexes.
| S-EPMC8895034 | biostudies-literature
Project description:Gold nanoparticles (Au NPs) and gold-based nanomaterials combine unique properties relevant for medicine, imaging, optics, sensing, catalysis, and energy conversion. While the Turkevich-Frens and Brust-Schiffrin methods remain the state-of-the-art colloidal syntheses of Au NPs, there is a need for more sustainable and tractable synthetic strategies leading to new model systems. In particular, stabilizers are almost systematically used in colloidal syntheses, but they can be detrimental for fundamental and applied studies. Here, a surfactant-free synthesis of size-controlled colloidal Au NPs stable for months is achieved by the simple reduction of HAuCl4 at room temperature in alkaline solutions of low-viscosity mono-alcohols such as ethanol or methanol and water, without the need for any other additives. Palladium (Pd) and bimetallic Au x Pd y NPs, nanocomposites and multimetallic samples, are also obtained and are readily active (electro)catalysts. The multiple benefits over the state-of-the-art syntheses that this simple synthesis bears for fundamental and applied research are highlighted.
| S-EPMC10018736 | biostudies-literature
Project description:SignificanceWe present a groundbreaking advance in completely nonprecious hydrogen fuel cell technologies achieving a record power density of 200 mW/cm2 with Ni@CNx anode and Co-Mn cathode. The 2-nm CNx coating weakens the O-binding energy, which effectively mitigates the undesirable surface oxidation during hydrogen oxidation reaction (HOR) polarization, leading to a stable fuel cell operation for Ni@CNx over 100 h at 200 mA/cm2, superior to a Ni nanoparticle counterpart. Ni@CNx exhibited a dramatically enhanced tolerance to CO relative to Pt/C, enabling the use of hydrogen gas with trace amounts of CO, critical for practical applications. The complete removal of precious metals in fuel cells lowers the catalyst cost to virtually negligible levels and marks a milestone for practical alkaline fuel cells.
| S-EPMC9060468 | biostudies-literature
Project description:Surfactant-free colloidal syntheses in aqueous media are attractive to develop nanomaterials relevant for various applications, e. g. catalysis or medicine. However, controlled green syntheses without surfactants of metal nanoparticles in aqueous media remain scarce. Here, room temperature syntheses of gold (Au) nanoparticles (NPs) that require only HAuCl4, alkaline water and an alcohol, i. e. relatively benign chemicals and mild reaction conditions, are developed. The findings of a comprehensive multi-parameters screening performed in small volumes (<3 mL) over 1000+ experiments pave the way to greener high throughput screenings of large parametric spaces and lead to scalable (100 mL) synthetic strategies. A rational selection of the alcohol is proposed. The influence of lights with defined wavelengths (222-690 nm) is investigated. It is found that lights with lower wavelengths favor the formation of smaller 5 nm NPs. Different kinetics and formation pathways are observed for different alcohols and for lights with different wavelengths. The sensitivity to various experimental parameters increases with the alcohol used in the order glycerol<ethylene glycol<ethanol<methanol. New strategies for a rational fine size control, and to some extend shape control, are identified. The results lead to more sustainable and reproducible surfactant-free colloidal syntheses of NPs.
| S-EPMC11789972 | biostudies-literature
Project description:Four benzothiazolium crown ether-containing styryl dyes were prepared through an optimized synthetic procedure. Two of the dyes (4b and 4d) having substituents in the 5-position of the benzothiazole ring are newly synthesized compounds. They demonstrated a higher degree of trans-cis photoisomerization and a longer life time of the higher energy forms in comparison with the known analogs. The chemical structures of all dyes in the series were characterized by NMR, UV-vis, IR spectroscopy and elemental analysis. The steady-state photophysical properties of the dyes were elucidated. The stability constants of metal complexes were determined and are in good agreement with the literature data for reference dyes. The temporal evolution of trans-to-cis isomerization was observed in a real-time regime. The dyes demonstrated a low intrinsic fluorescence of their Ba2+ complexes and high yield of E/Z photoisomerization with lifetimes of the higher energy form longer than 500 seconds. Density functional theory (DFT) calculations at the B3LYP/6-31+G(d,p) level were performed in order to predict the enthalpies (H) of the cis and trans isomers and the storage energies (ΔH) for the systems studied.
| S-EPMC6541326 | biostudies-literature
Project description:Intermetallics are long-range-ordered alloys traditionally synthesized by annealing nanoparticles of a random alloy, which results in the sintering of the nanoparticles and leads to the formation of polydispersed samples. It thus remains a challenge to achieve a monodispersion of tiny intermetallics. In the current work, ultra-small monodisperse intermetallic NiZn nanoparticles were synthesized based on a low-temperature solution chemistry route involving the chemical conversion of metal nanoparticles into an ordered alloy using an organometallic zinc precursor. During the transformation of single metal nanoparticles into the corresponding alloy, the particles retained their morphology. The resulting ordered alloy made up of earth-abundant materials demonstrated high electrocatalytic performance for the oxygen evolution reaction (OER) with a low overpotential of 283 mV at a current density of 10 mA cm-2 and a small Tafel slope of 73 mV dec-1, along with excellent stability and durability. The prepared intermetallic NiZn exhibited outstanding OER efficacy, better than those of a Ni0.7Zn0.3 alloy, pure Ni nanoparticles and even state-of-the art RuO2. The atomic ordering as well as the modification of the electronic structure of Ni upon becoming alloyed with Zn, together with an atomic-scale synergistic effect produced from Ni and Zn, led to the enhanced intrinsic catalytic activity. The present findings point to a general route to produce nanoscale tiny alloys and also provide excellent electrocatalysts having exceptional energy conversion efficiency.
| S-EPMC9419544 | biostudies-literature
Project description:Accumulation of reactive oxygen and nitrogen species (RONS) can induce cell damage and even cell death. RONS are short-lived species, which makes direct, precise, and real-time measurement difficult. Biologically-relevant RONS levels are in the nM-μM scale; hence, there is a need for highly sensitive RONS probes. We previously used hybrid gold-core silver-shell nanoparticles with mM sensitivity to H2O2. These particles reported the presence of RONS via spectral shifts which could easily be quantified via photoacoustic imaging. Here, we used halide doping to tune the electrochemical properties of these materials to better match the oxidation potential of RONS. This work describes the synthesis, characterization, and application of these AgI-coated gold nanorods (AgI/AuNR). The I : Ag molar ratio, pH, and initial Ag shell thickness were optimized for good RONS detection limits. Halide doping lowers the reduction potential of Ag from to resulting in a 1000-fold increase in H2O2 and 100 000-fold increase in ONOO- sensitivity. The AgI/AuNR system also etches 45-times faster than undoped Ag/AuNR. The AgI/AuNR easily reported the endogenously produced RONS in established cells lines as well as murine models.
| S-EPMC7331795 | biostudies-literature
Project description:Innovative and facile methods for the preparation of metal nanoparticles (MNPs) with A highly uniform distribution and anchored on a unique substrate are receiving increasing interest for the development of efficient and low-cost catalysts in the field of alternative and sustainable energy technologies. In this study, we report a novel and facile metal-ions adsorption-pyrolysis method based on a hydrogel nanocomposite for the preparation of well-distributed nickel nanoparticles on 3D porous carbon frameworks (Ni@PCFs). The pyrolysis temperature effect on electrocatalytic activity toward methanol oxidation and catalyst stability was investigated. Physicochemical characterizations (SEM, TEM, and XRD) were used to determine the morphology and composition of the prepared electrocatalyst, which were then linked to their electrocatalytic activity. The experimental results indicate that the catalyst synthesized by pyrolysis at 800 °C (Ni@PCFs-8) exhibits the highest electrocatalytic activity for oxidation of methanol in alkaline media. Additionally, prepared Ni@PCFs-8 displays a remarkable increase in electrocatalytic activity after activation in 1 M KOH and excellent stability. The adsorption-pyrolysis pathway ensures that the Ni NPs are trapped in the PCFs, which can provide highly reactive surface sites. This work may provide a facile and effective strategy for preparing uniformly distributed metallic NPs on a 3D PCF substrate with high catalytic activity for energy applications.
| S-EPMC9498779 | biostudies-literature
Project description:This study presents a straightforward approach for the in situ polymerization of poly(N-isopropylacrylamide) (PNIPAM) chains within the one-dimensional (1D) pores of the five-coordinated zinc-based metal-organic framework DMOF in order to obtain new MOF-based composites. The loading amount of PNIPAM within DMOF ⊃ PNIPAM composites can be tuned by changing the initial weight ratio between NIPAM, which is the monomer of PNIPAM, and DMOF. The guest PNIPAM chains in the composites block partially the 1D pores of DMOF, thus leading to a narrowed nanospace. The water adsorption studies reveal that the water uptake increased by increasing the loading of PNIPAM in the final DMOF ⊃ PNIPAM composites, indicating that the exposed amide groups of PNIPAM gradually alter the hydrophobicity of pristine DMOF and lead to hydrophilic DMOF ⊃ PNIPAM composites. The composite with the highest loading of PNIPAM displays a selective adsorption for water and methanol over ethanol when using equimolar mixtures of methanol-ethanol and water-ethanol. This is confirmed by the single-component adsorption measurements as well as ideal adsorbed solution theory molecular simulations. Additionally, the water stability of pristine DMOF has been greatly improved after the incorporation of PNIPAM in its pores. PNIPAM can undergo a phase transition between hydrophobic and hydrophilic phases in response to a low temperature change. This property is used in order to control the desorption of water and methanol molecules, thus enabling an efficient and cost-effective regeneration process.
| S-EPMC6838788 | biostudies-literature