Low-Cost and Environmental-Friendly Route for Synthesizing Nano-Rod Aluminosilicate MAZ Zeolite
Ontology highlight
ABSTRACT:
SUBMITTER: Zhang F
PROVIDER: S-EPMC9693496 | biostudies-literature | 2022 Nov
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Developing sustainable routes for the synthesis of zeolites is still a vital and challenging task in zeolite scientific community. One of the typical examples is sustainable synthesis of aluminosilicate EU-1 zeolite, which is not very efficient and environmental-unfriendly under hydrothermal condition due to the use of a large amount of water as solvent. Herein, we report a sustainable synthesis route for aluminosilicate EU-1 zeolite without the use of solvent for the first time. The physicochemical properties of the obtained EU-1 zeolite are characterized by powder X-ray diffraction (XRD), scanning electron microscopy (SEM), thermogravimetry-differential thermal analysis (TG-DTA), N2 sorption, inductively coupled plasma (ICP) analysis, and solid nuclear magnetic resonance (NMR), which show the product has high crystallinity, uniform morphology, large BET surface area, and four-coordinated aluminum species. Moreover, the impact of synthesis conditions is investigated in detail. The sustainable synthesis of aluminosilicate EU-1 zeolite under solvent-free.
| S-EPMC7962662 | biostudies-literature
Project description:Various synthesis methods for zeolites have been developed to date; however, precise control over aluminum (Al) content remains a significant challenge. For instance, in the case of CON-type zeolites, it is especially difficult to obtain a Si/Al ratio below a value of approximately 100 by direct synthesis, and below approximately 30 by post-treatment. In this study, we have developed a novel direct synthesis method of the CON-type zeolite having desired Al content by applying the interzeolite conversion/interzeolite transformation, wherein precursor zeolites that possess common composite building units (CBUs) with the target zeolite are employed as the Al and Si source. Initially, a single zeolite was utilized as a precursor, resulting in the successful synthesis of a high Al CON-type zeolite (Si/Al=40). Finally, we developed a novel synthesis method of the CON-type zeolite; blending of two types of zeolites, MFI and Beta, as starting material in the IZC method led to the direct crystallization of the CON-type aluminosilicate with high Al content (Si/Al=20).
| S-EPMC11891624 | biostudies-literature
Project description:BackgroundTetramates or tetramic acid-containing compounds (TACs) are a group of bioactive natural products featuring a pyrrolidine-2,4-dione ring acknowledged being closed via Dieckmann cyclization. The cariogenic Streptococcus mutans strains bearing a muc biosynthetic gene cluster (BGC) can synthesize mutanocyclin (MUC), a 3-acetylated TAC that can inhibit both leukocyte chemotaxis and filamentous development in Candida albicans. Some strains can also accumulate reutericyclins (RTCs), the intermediates of MUC biosynthesis with antibacterial activities. However, the formation mechanism of the pyrrolidine-2,4-dione ring of MUC and the distribution of muc-like BGCs along with their ecological functions has not been explored extensively.ResultsWe demonstrated that a key intermediate of MUC biosynthesis, M-307, is installed by a hybrid nonribosomal peptide synthetase-polyketide synthase assembly line and its pyrrolidine-2,4-dione ring is closed via an unprecedented lactam bond formation style. Subsequent C-3 acetylation will convert M-307 to RTCs, which is then hydrolyzed by a deacylase, MucF, to remove the N-1 fatty acyl appendage to generate MUC. Distribution analysis showed that the muc-like BGCs distribute predominantly in human-associated bacteria. Interestingly, most of the muc-like BGCs possessing a mucF gene were isolated from human or livestock directly, indicating their involvement in alleviating the host's immune attacks by synthesizing MUC; while those BGCs lacking mucF gene distribute mainly in bacteria from fermented products, suggesting that they tend to synthesize RTCs to compete with neighboring bacteria. It is noteworthy that many bacteria in the same habitats (e.g., the oral cavity) lack the muc-like BGC, but possess functional MucF homologues to "detoxify" RTCs to MUC, including several competitive bacteria of S. mutans. We also comparably studied the distribution of TAS1, a fungal enzyme responsible for the production of phytotoxic tenuazonic acids (TeAs), a class of 3-acetylated TACs with similar structure but distinct biosynthetic mechanism to MUC, and found that it mainly exists in plants or crops.ConclusionsThe in vivo and in vitro experiments revealed that the pyrrolidine-2,4-dione ring of MUC is closed via lactam bond formation, which may be adopted by many TACs without 3-acyl decorations. Besides, we found that muc-like BGCs are widespread in human-associated bacteria and their shapes and main products can be influenced by the habitat environment and vice versa. By comparing with TeAs, we provided thought-provoking insights into how ecological and evolutionary forces drive bacteria and fungi to construct a common 3-acetylated pyrrolidine-2,4-dione core through different routes, and how the biosynthetic processes are delicately controlled to generate diverse 3-acetylated TACs for environmental adaptation. Video Abstract.
| S-EPMC10161427 | biostudies-literature
Project description:We present a simple and cost-efficient route for the preparation of sulfonated dihalo-monomers for the synthesis of hydrocarbon ionomers. After conventional monomer sulfonation, excess sulfuric acid is quantitatively removed by neutralization with BaCO3. This leads to the precipitation of excess H2SO4 as insoluble BaSO4, which is easily separated from the sulfonated monomers in their soluble Ba-forms by filtration. Compared to conventional methods, the proposed approach leads to higher yields, drastically reduces the number of purification steps, and can easily be expanded to the preparation of other sulfonated monomers. The specific monomers presented here are suitable for the preparation of sulfonated polyarylenes and sulfonated polyphenylenes.
| S-EPMC11580002 | biostudies-literature
Project description:A new aluminosilicate zeolite, denoted EMM-28, has been successfully synthesized on a large scale using 1,1-(3,3-(1,3-phenylene)bis(propane-3,1-diyl))bis(1-methylpyrrolidinium) hydroxide as an organic structure directing agent (OSDA), which was scaled up to an ∼20 g scale with a yield of 77%. It crystallizes as thin plates (40-100 nm in thickness), and the corresponding powder X-ray diffraction (PXRD) pattern shows significant peak broadening which makes it insufficient for structure determination. Continuous rotation electron diffraction (cRED) data collected from 13 crystals were successfully used to solve and refine the structure of EMM-28. This illustrates that cRED data are capable of performing structure determination despite limited PXRD data quality. EMM-28 has a unique framework structure containing supercavities, >21 Å in size, connected by one-dimensional 10-ring channels. High-resolution transmission electron microscopy (HRTEM) confirmed the structure model. The structure of EMM-28 is related to several known zeolite structures with large cavities.
| S-EPMC9490810 | biostudies-literature
Project description:The SWY-type aluminosilicate zeolite, STA-30, has been synthesized via different routes to understand its defect chemistry and solid acidity. The synthetic parameters varied were the gel aging, the Al source, and the organic structure directing agent. All syntheses give crystalline materials with similar Si/Al ratios (6-7) that are stable in the activated K,H-form and closely similar by powder X-ray diffraction. However, they exhibit major differences in the crystal morphology and in their intracrystalline porosity and silanol concentrations. The diDABCO-C82+ (1,1'-(octane-1,8-diyl)bis(1,4-diazabicyclo[2.2.2]octan)-1-ium)-templated STA-30 samples (but not those templated by bisquinuclidinium octane, diQuin-C82+) possess hierarchical microporosity, consisting of noncrystallographic extra-large micropores (13 Å) that connect with the characteristic swy and gme cages of the SWY structure. This results in pore volumes up to 30% greater than those measured in activated diQuin-C8_STA-30 as well as higher concentrations of silanols and fewer Brønsted acid sites (BASs). The hierarchical porosity is demonstrated by isopentane adsorption and the FTIR of adsorbed pyridine, which shows that up to 77% of the BASs are accessible (remarkable for a zeolite that has a small-pore crystal structure). A structural model of single can/d6r column vacancies is proposed for the extra-large micropores, which is revealed unambiguously by high-resolution scanning transmission electron microscopy. STA-30 can therefore be prepared as a hierarchically porous zeolite via direct synthesis. The additional noncrystallographic porosity and, subsequently, the amount of SiOHs in the zeolites can be enhanced or strongly reduced by the choice of crystallization conditions.
| S-EPMC10571081 | biostudies-literature
Project description:Zeolites catalyze some reactions in their molecular-sized pores, but large molecules can react only on their external surface. Zeolite-nanosheets (NSs) have been developed as catalysts for large molecules. The previously reported methods to synthesize zeolite-NSs are specialized for each zeolite type. Here we propose a new method to synthesize various zeolite-NSs from the same amorphous aluminosilicate NSs (AAS-NSs) as a universal precursor. We successfully synthesized the unprecedented AAS-NSs in the hydrophilic space of the stable hyperswollen lyotropic lamellar (HL) phase. The four zeolite types could be obtained from the single-species AAS-NSs. These results imply that this method enables us to synthesize almost all types of zeolite-NSs. Moreover, the synthesized CHA-NSs have great potential for various applications because of their thickness and large external surface area.
| S-EPMC9828233 | biostudies-literature
Project description:Plasmonic nanostructures are important across diverse applications from sensing to renewable energy. Periodic porous array structures are particularly attractive because such topography offers a means to encapsulate or capture solution phase species and combines both propagating and localised plasmonic modes offering versatile addressability. However, in analytical spectroscopic applications, periodic pore arrays have typically reported weaker plasmonic signal enhancement compared to particulate structures. This may be addressed by introducing additional nano-structuring into the array to promote plasmonic coupling that promotes electric field-enhancement, whilst retaining pore structure. Introducing nanoparticle structures into the pores is a useful means to promote such coupling. However, current approaches rely on either expensive top-down methods or on bottom-up methods that yield random particle placement and distribution. This report describes a low cost, top-down technique for preparation of nano-sub-structured plasmonic pore arrays in a highly reproducible manner that can be applied to build arrays extending over macroscopic areas of mm2 to cm2. The method exploits oxygen plasma etching, under controlled conditions, of the cavity encapsulated templating polystyrene (PS) spheres used to create the periodic array. Subsequent metal deposition leads to reproducible nano-structuring within the wells of the pore array, coined in-cavity nanoparticles (icNPs). This approach was demonstrated across periodic arrays with pore/sphere diameters ranging from 500 nm to 3 μm and reliably improved the plasmonic properties of the substrate across all array dimensions compared to analogous periodic arrays without the nano-structuring. The enhancement factors achieved for metal enhanced emission and surface enhanced Raman spectroscopy depended on the substrate dimensions, with the best performance achieved for nanostructured 2 μm diameter pore arrays, where a more than 104 improvement over Surface Enhanced Raman Spectroscopy (SERS) and 200-fold improvement over Metal Enhanced Fluorescence (MEF) were observed for these substrates compared with analogous unmodified pore arrays. The experiments were supported by Finite-Difference Time-Domain (FDTD) calculations used to simulate the electric field distribution as a function of pore nano-structuring.
| S-EPMC9417107 | biostudies-literature
Project description:This work demonstrates the fabrication of silicide/silicon based solar cell towards the development of low cost and environmental friendly photovoltaic technology. A heterostructure solar cells using metallic alpha phase (α-phase) aluminum alloyed iron silicide (FeSi(Al)) on n-type silicon is fabricated with an efficiency of 0.8%. The fabricated device has an open circuit voltage and fill-factor of 240 mV and 60%, respectively. Performance of the device was improved by about 7 fold to 5.1% through the interface engineering. The α-phase FeSi(Al)/silicon solar cell devices have promising photovoltaic characteristic with an open circuit voltage, short-circuit current and a fill factor (FF) of 425 mV, 18.5 mA/cm(2), and 64%, respectively. The significant improvement of α-phase FeSi(Al)/n-Si solar cells is due to the formation p(+-)n homojunction through the formation of re-grown crystalline silicon layer (~5-10 nm) at the silicide/silicon interface. Thickness of the regrown silicon layer is crucial for the silicide/silicon based photovoltaic devices. Performance of the α-FeSi(Al)/n-Si solar cells significantly depends on the thickness of α-FeSi(Al) layer and process temperature during the device fabrication. This study will open up new opportunities for the Si based photovoltaic technology using a simple, sustainable, and los cost method.
| S-EPMC4668570 | biostudies-literature
Project description:Single-walled zeolite nanotubes (ZNT) were recently synthesized in a narrow compositional window. ZNT structural features-thin zeolitic walls and large mesopores-can allow for easy access of small molecules to zeolite micropores, but they also impart processing limitations for these materials, such as challenges with conventional aqueous ion-exchange conditions. Conventional solid- and liquid-phase ion exchange of calcined NaOH-derived ZNT (NaH-ZNT) results in structural degradation to either 2D sheet-like phases, 3D nanocrystals, or amorphous phases, motivating different direct synthesis routes and unconventional ion-exchange procedures of uncalcined ZNT precursors. Here, a modified synthesis route for ZNT synthesis is introduced that facilitates facile ion exchange as well as incorporation of additional non-Al heteroatoms in the zeolite framework. Tetrabutylammonium hydroxide (TBAOH) is used as a hydroxide source and co-OSDA, enabling synthesis of new compositions of ZNT, otherwise unachievable by post-modification of previously reported NaH-ZNT. By varying the gel composition, synthesis temperature, crystallization time, hydroxide source, silicon source, and aluminum source, productive conditions for the new TBAOH synthesis are developed, leading to increased strong acid site density in the ZNT. The collected results demonstrate the sensitivity of the ZNT synthesis to many key parameters and show that the ZNT forms only when Si/(Al + T) ∼ 30 in these synthesis gels and with specific Si and Al sources, and always in the presence of trace Na+. Catalytic testing, via the tandem CO2 hydrogenation to methanol and methanol to aromatics reaction, shows that ZNTs provide adequate catalytic activity (acidity), relative to their conventional 3D counterparts in converting methanol to aromatic compounds.
| S-EPMC11393933 | biostudies-literature