Facile sulfation of cellulose via recyclable ternary deep eutectic solvents for low-cost cellulose nanofibril preparation† † Electronic supplementary information (ESI) available. See DOI: https://doi.org/10.1039/d2na00769j
Ontology highlight
ABSTRACT:
SUBMITTER: Ma G
PROVIDER: S-EPMC9846476 | biostudies-literature | 2022 Nov
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Deep eutectic solvents (DESs), featured as promising green solvents, were applied to examine their effectiveness in pretreating raw ramie fibers (RFs) for cellulose nanofibril (CNF) production. The pretreatment performance of three DESs, i.e., choline chloride-urea (CU), choline chloride-oxalic acid dihydrate (CO), and choline chloride-glycerol (CG), was evaluated based on chemical composition analysis and structural and morphological changes. CO attained the most dramatic morphological changes of RFs, followed by CG and CU. Its high structural disruption of RFs during the pretreatment process, shown in the results from scanning electron microscopy and atomic force microscopy, could be due to an outstanding ability to remove amorphous cellulose and noncellulosic components from raw RFs, confirmed by the results of chemical composition analysis, Fourier transform infrared spectroscopy, and X-ray diffractometry. Overall, this study provided an innovative and effective pretreatment process for fractionating raw cellulosic fibers, so as to promote the subsequent preparation of CNFs.
| S-EPMC7081644 | biostudies-literature
Project description:Deep eutectic solvents (DES) are potentially greener solvents obtained through the complexation of simple precursors which, among other applications, have been investigated in recent years for their ability to support the self-assembly of amphiphilic molecules. It is crucial to understand the factors which influence surfactant solubility and self-assembly with respect to the interaction of the surfactant molecule with the DES components. In this work, small-angle neutron scattering (SANS) has been used to investigate the micellization of cationic (CnTAB) and anionic (SDS) surfactants in a ternary DES comprising choline chloride, urea, and glycerol, where the hydrogen bond donors are mixed in varying molar ratios. The results show that in each case either globular or rodlike micelles are formed with the degree of elongation being directly dependent on the composition of the DES. It is hypothesized that this composition dependence arises largely from the poor solubility of the counterions in the DES, especially at low glycerol content, leading to a tighter binding of the counterion to the micelle surface and giving rise to micelles with a high aspect ratio. This potential for accurate control over micelle morphology presents unique opportunities for rheology control or to develop templated syntheses of porous materials in DES, utilizing the solvent composition to tailor micelle shape and size, and hence the pore structure of the resulting material.
| S-EPMC7467713 | biostudies-literature
Project description:Because of its non-toxic, pollution-free, and low-cost advantages, environmentally-friendly packaging is receiving widespread attention. However, using simple technology to prepare environmentally-friendly packaging with excellent comprehensive performance is a difficult problem faced by the world. This paper reports a very simple and environmentally-friendly method. The hydroxyl groups of cellulose nanofibrils (CNFs) were modified by introducing malic acid and the silane coupling agent KH-550, and the modified CNF were added to cassava starch as a reinforcing agent to prepare film with excellent mechanical, hydrophobic, and barrier properties. In addition, due to the addition of malic acid and a silane coupling agent, the dispersibility and thermal stability of the modified CNFs became significantly better. By adjusting the order of adding the modifiers, the hydrophobicity of the CNFs and thermal stability were increased by 53.5% and 36.9% ± 2.7%, respectively. At the same time, the addition of modified CNFs increased the tensile strength, hydrophobicity, and water vapor transmission coefficient of the starch-based composite films by 1034%, 129.4%, and 35.95%, respectively. This material can be widely used in the packaging of food, cosmetics, pharmaceuticals, and medical consumables.
| S-EPMC7221531 | biostudies-literature
Project description:In this experiment, the influence of the morphology and surface characteristics of cellulosic nanoparticles (i.e., cellulose nanocrystals [CNCs] and cellulose nanofibers [CNFs]) on oil-in-water (o/w) emulsion stabilization was studied using non-modified or functionalized nanoparticles obtained following deep eutectic solvent (DES) pre-treatments. The effect of the oil-to-water ratio (5, 10, and 20 wt.-% (weight percent) of oil), the type of nanoparticle, and the concentration of the particles (0.05⁻0.2 wt.-%) on the oil-droplet size (using laser diffractometry), o/w emulsion stability (via analytical centrifugation), and stabilization mechanisms (using field emission scanning electron microscopy with the model compound-i.e., polymerized styrene in water emulsions) were examined. All the cellulosic nanoparticles studied decreased the oil droplet size in emulsion (sizes varied from 22.5 µm to 8.9 µm, depending on the nanoparticle used). Efficient o/w emulsion stabilization against coalescence and an oil droplet-stabilizing web-like structure were obtained only, however, with surface-functionalized CNFs, which had a moderate hydrophilicity level. CNFs without surface functionalization did not prevent either the coalescence or the creaming of emulsions, probably due to the natural hydrophobicity of the nanoparticles and their instability in water. Moderately hydrophilic CNCs, on the other hand, distributed evenly and displayed good interaction with both dispersion phases. The rigid structure of CNCs meant, however, that voluminous web structures were not formed on the surface of oil droplets; they formed in flat, uniform layers instead. Consequently, emulsion stability was lower with CNCs, when compared with surface-functionalized CNFs. Tunable cellulose nanoparticles can be used in several applications such as in enhanced marine oil response.
| S-EPMC6278293 | biostudies-literature
Project description:Daidzein, which is scarce in nature, has gained significant attention due to its superior biological activity and bioavailability compared with daidzin. So far, it has been widely used in the medicine and health care products industries. The enzymatic approach for the preparation of daidzein has prevailed, benefitted by its high efficiency and eco-friendly nature. Our present research aimed at providing a preparation method of daidzein by enzymatic hydrolysis of daidzin in a new "green" reaction medium-deep eutectic solvents (DESs). Herein, the DESs were screened via evaluating enzyme activity, enzyme stability and the substrate solubility, and the DES (ChCl/EG 2:1, 30 vol %) was believed to be the most appropriate co-solvent to improve the bioconversion efficiency. Based on the yield of daidzein, response surface methodology (RSM) was employed to model and optimize the reaction parameters. Under these optimum process conditions, the maximum yield of 97.53% was achieved and the purity of daidzein crude product reached more than 70%, which is more efficient than conversions in DESs-free buffer. Importantly, it has been shown that DESs medium could be reused for six batches of the process with a final conversion of above 50%. The results indicated that this procedure could be considered a mild, environmentally friendly, highly efficient approach to the economical production of daidzein, with a simple operation process and without any harmful reagents being involved.
| S-EPMC6155624 | biostudies-literature
Project description:This study investigates the effect of using water as a low-viscosity component in ternary amine-based deep eutectic solvents (DESs) on the physicochemical properties, thermal stability, and CO2 absorption capacity of the resulting DESs. It should be emphasized that water is a component of the ternary DES. The effect of water content in the DES, type of hydrogen bond acceptors (HBAs), hydrogen bond donors (HBDs), and HBA:HBD ratio on the above parameters was investigated. Moreover, the effect of temperature and pressure on the CO2 absorption capacity of DESs was predicted using the predictive model COSMO-RS. This model was also used to predict the CO2 solubility in the DESs and the results were compared with the experimental values. The results showed that the addition of small amounts of water, e.g., 5 and 10 wt% during preparation, can significantly decrease the viscosity of the resulting DESs, up to 25% at room temperature, while maintaining the high CO2 absorption capacity and high thermal stability. The ternary DESs based on MEA exhibited a high CO2 absorption capacity of 0.155-0.170 g CO2 / g DES. The ternary DESs were found to be thermally stable with a decomposition temperature of 125°C, which promotes the use of such solvents in post-combustion capture processes. Finally, COSMO-RS proved to be a suitable tool for qualitative prediction of CO2 solubility in DESs and demonstration of trends related to the effects of temperature, pressure, molar ratio, water content, HBD and HBA on CO2 solubility.
| S-EPMC10289352 | biostudies-literature
Project description:Ionogels offer huge potential for a number of applications including wearable electronics and soft sensors. However, their synthesis has been limited and often relies on non-renewable or non-biocompatible components. Here we present a novel two-component ionogel made using just deep eutectic solvents (DESs) and cellulose. DESs offer a non-volatile alternative to hydrogels with highly tuneable properties including conductivity and solvation of compounds with widely varying hydrophobicity. DESs can be easily made from cheap, biodegradable and biocompatible components. This research presents the characterisation of a series of soft conductive gels made from deep eutectic solvents (DESs), specifically choline chloride-urea and choline chloride-glycerol, with the sole addition of TEMPO-oxidised cellulose nanofibrils (OCNF). A more liquid-like rather than gel-like conductive material could be made by using the DES betaine-glycerol. OCNF are prepared from sustainable sources, and are non-toxic, and mild on the skin, forming gels without the need for surfactants or other gelling agents. These DES-OCNF gels are shear thinning with conductivities up to 1.7 mS cm-1 at ∼26 °C. Given the thousands of possible DESs, this system offers unmatched tunability and customisation for properties such as viscosity, conductivity, and yield behaviour.
| S-EPMC9419570 | biostudies-literature
Project description:Deep eutectic solvents (DESs) hold the potential to serve as a sustainable and environmentally friendly substitute for supercritical fluids, ionic liquids, and organic solvents. Moreover, DESs have been demonstrated to assist in stabilizing the structure of enzyme. The enzymatic synthesis of epoxy vegetable oil in a DES-system was developed in this study, and the influence of DESs viscosity on the epoxidation system was investigated for the first time. The results demonstrated that the epoxy value reached 8.97, and the double bond conversion rate was 82.48%. The viscosity of the reaction system decreased from 209.32 to 91.35 (mPa·s). The application of DES in epoxidation was confirmed through structural characterization, indicating that eutectic solvents could serve as substitutes for toxic and volatile organic solvents in synthesizing high-epoxide vegetable oils using an enzymatic method, thus facilitating the production of environmentally friendly plasticizers.
| S-EPMC11913718 | biostudies-literature
Project description:A method was developed in which cellulose (CEL) and/or chitosan (CS) were added to keratin (KER) to enable [CEL/CS+KER] composites formed to have better mechanical strength and wider utilization. Butylmethylimmidazolium chloride ([BMIm+Cl-]), an ionic liquid, was used as the sole solvent, and because the majority of [BMIm+Cl-] used (at least 88%) was recovered, the method is green and recyclable. FTIR, XRD, 13C CP-MAS NMR and SEM results confirm that KER, CS and CEL remain chemically intact and distributed homogeneously in the composites. We successfully demonstrate that the widely used method based on the deconvolution of the FTIR bands of amide bonds to determine secondary structure of proteins is relatively subjective as the conformation obtained is strongly dependent on the choice of parameters selected for curve fitting. A new method, based on the partial least squares regression analysis (PLSR) of the amide bands, was developed, and proven to be objective and can provide more accurate information. Results obtained with this method agree well with those by XRD, namely they indicate that although KER retains its second structure when incorporated into the [CEL+CS] composites, it has relatively lower α-helix, higher β-turn and random form compared to that of the KER in native wool. It seems that during dissolution by [BMIm+Cl-], the inter- and intramolecular forces in KER were broken thereby destroying its secondary structure. During regeneration, these interactions were reestablished to reform partially the secondary structure. However, in the presence of either CEL or CS, the chains seem to prefer the extended form thereby hindering reformation of the α-helix. Consequently, the KER in these matrices may adopt structures with lower content of α-helix and higher β-sheet. As anticipated, results of tensile strength and TGA confirm that adding CEL or CS into KER substantially increase the mechanical strength and thermal stability of the [CS/CEL+KER] composites.
| S-EPMC4889018 | biostudies-literature
Project description:Lewis/Brønsted acidic deep eutectic solvents (LBDESs) are a recent class of solvents that combine the two types of acidity. In some cases, this synergy leads to enhanced catalytic properties for many reactions and applications. For this reason, it is important to discover more LBDESs. In this work, we prepared and characterized four different zinc(II)-based LBDESs, mixing ZnCl2 and various Brønsted acids: acetic, glycolic, levulinic, and formic acids. Apart from the latter, for which the corresponding DES is not thermally stable, the samples have been characterized in terms of density, viscosity, and conductivity. Notably, as zinc(II) is a diamagnetic metal, all of them are suitable for NMR spectroscopy, for example, for kinetic and mechanistic studies.
| S-EPMC10745514 | biostudies-literature