Properties of Exchange Coupled All-garnet Magneto-Optic Thin Film Multilayer Structures.
Ontology highlight
ABSTRACT:
SUBMITTER: Nur-E-Alam M
PROVIDER: S-EPMC5507030 | biostudies-other | 2015 Apr
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Lignin is one of the most abundant renewable materials on the earth. Despite possessing useful antioxidant and UV absorbing properties, its effective utilization in technology has been hampered by its relative insolubility and difficulty to process. In this work, a simple chemical derivatization process is utilized which yields water-soluble lignin possessing anionic carboxylate groups. These carboxylate groups give lignin polyanionic behavior and enable its utilization in the growth of a functional film via layer-by-layer (LbL) assembly with biologically sourced chitosan. The growth mechanism of this film is hypothesized to be a result of both hydrogen bonding and ionic interactions. The film demonstrates excellent UV-absorptive capability. A 100 nm thick chitosan/lignin coating was applied to a poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) film and shown to reduce its degradation sixfold over the course of a 1 hour exposure to harsh UV light. This is the first demonstration of lignin being utilized in a fully biologically derived LbL film. Utilization of lignin in LbL assembly is an important step in the development of renewable nanotechnology.
| S-EPMC9056636 | biostudies-literature
Project description:Yttrium iron garnet has a very high Verdet constant, is transparent in the infrared and is an insulating ferrimagnet leading to its use in optical and magneto-optical applications. Its high Q-factor has been exploited to make resonators and filters in microwave devices, but it also has the lowest magnetic damping of any known material. In this article we describe the structural and magnetic properties of single crystal thin-film YIG where the temperature dependence of the magnetisation reveals a decrease in the low temperature region. In order to understand this complex material we bring a large number of structural and magnetic techniques to bear on the same samples. Through a comprehensive analysis we show that at the substrate -YIG interface, an interdiffusion zone of only 4-6 nm exists. Due to the interdiffusion of Y from the YIG and Gd from the substrate, an addition magnetic layer is formed at the interface whose properties are crucially important in samples with a thickness of YIG less than 200 nm.
| S-EPMC5603596 | biostudies-literature
Project description:The behavior of bi- and trilayer coating systems for flexible a-Si:H based solar cells consisting of a barrier, an electrode, and an absorption layer is studied under mechanical load. First, the film morphology, stress, Young's modulus, and crack onset strain (COS) were analyzed for single film coatings of various thickness on polyethylene terephthalate (PET) substrates. In order to demonstrate the role of the microstructure of a single film on the mechanical behavior of the whole multilayer coating, two sets of InSnOx (indium tin oxide, ITO) conductive coatings were prepared. Whereas a characteristic grain-subgrain structure was observed in ITO-1 films, grain growth was suppressed in ITO-2 films. ITO-1 bilayer coatings showed two-step failure under tensile load with cracks propagating along the ITO-1/a-Si:H-interface, whereas channeling cracks in comparable bi- and trilayers based on amorphous ITO-2 run through all constituent layers. A two-step failure is preferable from an application point of view, as it may lead to only a degradation of the performance instead of the ultimate failure of the device. Hence, the results demonstrate the importance of a fine-tuning of film microstructure not only for excellent electrical properties, but also for a high mechanical performance of flexible devices (e.g., a-Si:H based solar cells) during fabrication in a roll-to-roll process or under service.
| S-EPMC5503339 | biostudies-literature
Project description:Malaria diagnosis relies on optical microscopy and/or rapid diagnostic tests based on detecting specific malaria antigens. The clinical sensitivity of these methods is highly dependent on parasite density, with low levels of detection at low parasite density, challenging the worldwide malaria elimination efforts. Therefore, there is a need for diagnostic methods with higher sensitivity, demanding innovative diagnostics devices able to detect malaria at low parasite density and at early stages of the disease. We propose an innovative optical device for malaria diagnosis, based on optical reflectance spectrophotometry, for the detection of parasites through the quantification of haemozoin. For this purpose, a set of eight thin-film optical filters, based on multilayer stacks of MgO/TiO2 and SiO2/TiO2 thin-films, with high transmittance and low full width at half maximum (FWHM) at specific wavelengths, was designed and fully characterized (both numerically and experimentally). A preliminary assessment of its potential to reconstruct the original spectra of red blood cells was performed, both in uninfected and Plasmodium falciparum-infected samples. The obtained results show that, although the experimental filters have a non-ideal performance characteristic, they allow us to distinguish, based on only 8 discrete points in the optical spectrum, between healthy and malaria infected samples, up to a detection limit of 12 parasites/μL of red blood cells. Those results enhance the potential of using such a device for malaria diagnostics, aiming for non-invasiveness.
| S-EPMC8398211 | biostudies-literature
Project description:Magneto-optical cerium-substituted yttrium iron garnet (Ce:YIG) thin films display Faraday and Kerr rotation (rotation of light polarisation upon transmission and reflection, respectively) as well as a nonreciprocal phase shift due to their non-zero off-diagonal permittivity tensor elements, and also possess low optical absorption in the near-infrared. These properties make Ce:YIG useful in providing nonreciprocal light propagation in integrated photonic circuits, which is essential for accomplishing energy-efficient photonic computation and data transport architectures. In this study, 80 nm-thick Ce:YIG films were grown on Gadolinium Gallium Garnet substrates with (100), (110) and (111) orientations using pulsed laser deposition. The films had bulk-like structural and magnetic quality. Faraday and Kerr spectroscopies along with spectroscopic ellipsometry were used to deduce the complete permittivity tensor of the films in the ultraviolet, visible and near-infrared spectral region, and the magneto-optical figure of merit as a function of wavelength was determined. The samples showed the highest IR Faraday rotation reported for thin films of Ce:YIG, which indicates the importance of this material in development of nonreciprocal photonic devices.
| S-EPMC4812311 | biostudies-literature
Project description:The key impact and significance of a multilayer polymer-based dielectric system on the remarkable photoresponse properties of zinc phthalocyanine (ZnPc)-based photosensitive organic field-effect transistors (PS-OFETs) have been systematically analyzed at various incident optical powers. A combination of inorganic aluminum oxide (Al2O3) and organic nonpolar poly(methyl methacrylate) (PMMA) is used as the bilayer dielectric configuration, whereas in the trilayer dielectric system, a bilayer polymer dielectric, consisting of PMMA, as the low-k dielectric polymer, on top of poly(vinyl alcohol) (PVA), the high-k polar dielectric, has been fabricated along with Al2O3 as the third layer. Before fabricating the OFETs, a systematic optimization of the nature of growth of the ZnPc molecules, deposited on PMMA-coated glass substrates at different substrate temperatures (T s) was performed and examined by atomic-force microscopy, field-emission scanning electron microscopy, X-ray diffraction, and Raman analysis. At 90 °C, the fabricated PS-OFETs with the Al2O3/PVA/PMMA trilayer dielectric configuration showed the best p-channel behavior, with an enhanced and remarkable photoresponsivity of R ∼ 9689.39 A W-1 compared to that of the Al2O3/PMMA bilayer dielectric system (R ∼ 2679.40 A W-1) due to the polarization of the dipoles inside the polar PVA dielectric, which increases the charge transport through the channel. The charge carrier mobility of the device also improved by one order (μh ∼ 1.3 × 10-2 cm2 V-1 s-1) compared to that of the bilayer dielectric configuration (μh ∼ 3.5 × 10-3 cm2 V-1 s-1). The observed specific detectivity (D*) and NEP values of the bilayer dielectric system were 6.01 × 1013 Jones and 2.655 × 10-17 W Hz-1/2, whereas for the trilayer dielectric system, the observed D* and NEP values were 5.13 × 1014 Jones and 1.043 × 10-17 W Hz-1/2, respectively. Additionally, the operating voltage of each of the fabricated devices was also very low (-10 V) due to the influence of the inorganic high-k Al2O3 dielectric layer. The electrical stability of all of the fabricated devices was also investigated by bias stress analysis under both light and dark conditions in vacuum. To the best of our knowledge, the photoresponsivity (R) reported here with an Al2O3/PVA/PMMA trilayer dielectric configuration is the highest reported value for thin film-based PS-OFETs, at a remarkably low operating voltage of -10 V, on low-cost glass substrates without indium tin oxide or/and Si/SiO2.
| S-EPMC6641034 | biostudies-literature
Project description:Flexible implantable neurointerfaces show great promise in addressing one of the major challenges of implantable neurotechnology, namely the loss of signal connected to unfavorable probe tissue interaction. The authors here show how multilayer polyimide probes allow high-density intracortical recordings to be combined with a reliable long-term stable tissue interface, thereby progressing toward chronic stability of implantable neurotechnology. The probes could record 10-60 single units over 5 months with a consistent peak-to-peak voltage at dimensions that ensure robust handling and insulation longevity. Probes that remain in intimate contact with the signaling tissue over months to years are a game changer for neuroscience and, importantly, open up for broader clinical translation of systems relying on neurotechnology to interface the human brain.
| S-EPMC10190290 | biostudies-literature
Project description:A simple sidewall patterning process for organic-inorganic multilayer thin-film encapsulation (TFE) has been proposed and demonstrated. An Al2O3 thin film grown by atomic layer deposition (ALD) was patterned by adhesion lithography using the difference in interfacial adhesion strength. The difference in interfacial adhesion strength was provided by the vapor-deposited fluoro-octyl-trichloro-silane self-assembled monolayer (SAM) patterns formed by a shadow mask. The sidewall patterning of multilayer TFE was shown possible by repeating the adhesion lithography and the vapor deposition of organic polymer and SAM patterns using shadow masks. The proposed process has the advantage of being able to pattern the blanket ALD-grown Al2O3 thin films by adhesion lithography using a SAM pattern that can be more accurately predefined with a shadow mask.
| S-EPMC10390510 | biostudies-literature
Project description:Neutron-Transformer Reflectometry Advanced Computation Engine (N-TRACE), a neural network model using a transformer architecture, is introduced for neutron reflectometry data analysis. It offers fast, accurate initial parameter estimations and efficient refinements, improving efficiency and precision for real-time data analysis of lithium-mediated nitrogen reduction for electrochemical ammonia synthesis, with relevance to other chemical transformations and batteries. Despite limitations in generalizing across systems, it shows promises for the use of transformers as the basis for models that could accelerate traditional approaches to modeling reflectometry data.
| S-EPMC11758268 | biostudies-literature
Project description:Transition-metal-doped semiconductor nanocrystals have received significant attention because of their attractive features deeming them invaluable in various technological fields including optoelectronics, bio-photonics, and energy conversion, to name a few. Of particular, these interests are two-dimensional materials with useful optical and magnetic properties combined with their large surface areas opening up new applications in biotechnology. These applications range from multimodal optical and magnetic bioimaging and sensing to measuring the weak magnetic field due to brain waves using their magneto-optic properties stemming from the exchange interaction between the transition metal dopants and the carrier spins. These magnetic 2D materials could also significantly advance the field of spintronics. In this work, we report on a study of the magnetic and magneto-optic properties of colloidal two-dimensional (2D) copper-doped CdSe nanoplatelets (NPLs) that are synthesized using a high-temperature colloidal technique. We carried out optical and circularly polarized magneto-photoluminescence spectrometry to investigate the magnetism in our solution-processed nanostructures doped with copper ion impurities. At cryogenic temperatures, two excitonic features are observed for doped NPLs, which are more prominent compared to the undoped NPLs. Furthermore, the excitonic circular polarization (CP) is recorded as a function of the applied magnetic field (B) and temperature (T). The detailed analysis provides a picture of the magneto-optical behavior of the doped 2D NPLs in the presence of paramagnetic copper ions. This work paves the way for significant advances in bio/nanophotonics where tunable optical and magnetic properties of doped nanoplatelets can be leveraged to make more efficient, flexible, and low-cost devices.
| S-EPMC11501793 | biostudies-literature