Ontology highlight
ABSTRACT:
PROVIDER: PRJNA1291108 | ENA |
REPOSITORIES: ENA
Similar Datasets
Project description:Ultraviolet stress in light/dark synchronized cells of the marine cyanobacterium Prochlorococcus marinus PCC9511
2010-08-03 | E-TABM-1028 | biostudies-arrayexpress
Project description:<p>Algal blooms are hotspots of primary production in the ocean, forming the basis of the marine food web and fueling the dissolved organic matter (DOM) pool. Marine viruses are key players in controlling algal bloom demise, thereby diverting algal biomass from higher trophic levels to the DOM pool, a process termed the ‘viral shunt’. To decode the metabolic footprint of the ‘viral shunt’ in the marine environment, we induced a bloom of <em>Emiliania huxleyi</em> and followed its succession using an untargeted exometabolomics approach. Here, we show that algal bloom succession induces dynamic changes in the exometabolic landscape. We discovered a set of novel chlorine-iodine-containing metabolites that were induced by viral infection and released during bloom demise. These metabolites were further detected in virus-infected oceanic <em>E. huxleyi</em> blooms. Therefore, we propose that halogenation with both chlorine and iodine is a distinct hallmark of the virus-induced DOM of <em>E. huxleyi</em>, providing insights into the metabolic consequences of the ‘viral shunt’ for marine DOM.</p>
2021-05-05 | MTBLS1720 | MetaboLights
Project description:Increasing atmospheric CO2 concentrations are causing decreased pH over vast expanses of the ocean. This decreasing pH may alter biogeochemical cycling of carbon and nitrogen via the microbial process of nitrification, a key process that couples these cycles in the ocean, but which is often sensitive to acidic conditions. Recent reports indicate a decrease in oceanic nitrification rates under experimentally lowered pH. How composition and abundance of ammonia oxidizing bacteria (AOB) and archaea (AOA) assemblages respond to decreasing oceanic pH, however, is unknown. We sampled microbes from two different acidification experiments and used a combination of qPCR and functional gene microarrays for the ammonia monooxygenase gene (amoA) to assess how acidification alters the structure of ammonia oxidizer assemblages. We show that despite widely different experimental conditions, acidification consistently altered the community composition of AOB by increasing the relative abundance of taxa related to the Nitrosomonas ureae clade. In one experiment this increase was sufficient to cause an increase in the overall abundance of AOB. There were no systematic shifts in the community structure or abundance of AOA in either experiment. These different responses to acidification underscore the important role of microbial community structure in the resiliency of marine ecosystems. SUBMITTER_CITATION: Title: Acidification alters the composition of ammonia oxidizing microbial assemblages in marine mesocosms Journal: Marine Ecology Progress Series Issue: 492 Pages: 1-8 DOI: 10.3354/meps 10526 Authors: Jennifer L Bowen Patrick J Kearns Michael Holcomb Bess B Ward
2013-08-27 | GSE49956 | GEO
Project description:Microarrays are useful tools for detecting and quantifying specific functional and phylogenetic genes in natural microbial communities. In order to track uncultivated microbial genotypes and their close relatives in an environmental context, we designed and implemented a “genome proxy” microarray that targets microbial genome fragments recovered directly from the environment. Fragments consisted of sequenced clones from large-insert genomic libraries from microbial communities in Monterey Bay, the Hawaii Ocean Time-series station ALOHA, and Antarctic coastal waters. In a prototype array, we designed probe sets to thirteen of the sequenced genome fragments and to genomic regions of the cultivated cyanobacterium Prochlorococcus MED4. Each probe set consisted of multiple 70-mers, each targeting an individual ORF, and distributed along each ~40-160kbp contiguous genomic region. The targeted organisms or clones, and close relatives, were hybridized to the array both as pure DNA mixtures and as additions of cells to a background of coastal seawater. This prototype array correctly identified the presence or absence of the target organisms and their relatives in laboratory mixes, with negligible cross-hybridization to organisms having ≤~75% genomic identity. In addition, the array correctly identified target cells added to a background of environmental DNA, with a limit of detection of ~0.1% of the community, corresponding to ~10^3 cells/ml in these samples. Signal correlated to cell concentration with an R2 of 1.0 across six orders of magnitude. In addition the array could track a related strain (at 86% genomic identity to that targeted) with a linearity of R2=0.9999 and a limit of detection of ~1% of the community. Closely related genotypes were distinguishable by differing hybridization patterns across each probe set. This array’s multiple-probe, “genome-proxy” approach and consequent ability to track both target genotypes and their close relatives is important for the array’s environmental application given the recent discoveries of considerable intra-population diversity within marine microbial communities. Keywords: target addition experiment, proof-of-concept for GPL6012
2007-10-31 | GSE9384 | GEO
Project description:Microarrays are useful tools for detecting and quantifying specific functional and phylogenetic genes in natural microbial communities. In order to track uncultivated microbial genotypes and their close relatives in an environmental context, we designed and implemented a âgenome proxyâ microarray that targets microbial genome fragments recovered directly from the environment. Fragments consisted of sequenced clones from large-insert genomic libraries from microbial communities in Monterey Bay, the Hawaii Ocean Time-series station ALOHA, and Antarctic coastal waters. In a prototype array, we designed probe sets to thirteen of the sequenced genome fragments and to genomic regions of the cultivated cyanobacterium Prochlorococcus MED4. Each probe set consisted of multiple 70-mers, each targeting an individual ORF, and distributed along each ~40-160kbp contiguous genomic region. The targeted organisms or clones, and close relatives, were hybridized to the array both as pure DNA mixtures and as additions of cells to a background of coastal seawater. This prototype array correctly identified the presence or absence of the target organisms and their relatives in laboratory mixes, with negligible cross-hybridization to organisms having â¤~75% genomic identity. In addition, the array correctly identified target cells added to a background of environmental DNA, with a limit of detection of ~0.1% of the community, corresponding to ~10^3 cells/ml in these samples. Signal correlated to cell concentration with an R2 of 1.0 across six orders of magnitude. In addition the array could track a related strain (at 86% genomic identity to that targeted) with a linearity of R2=0.9999 and a limit of detection of ~1% of the community. Closely related genotypes were distinguishable by differing hybridization patterns across each probe set. This arrayâs multiple-probe, âgenome-proxyâ approach and consequent ability to track both target genotypes and their close relatives is important for the arrayâs environmental application given the recent discoveries of considerable intra-population diversity within marine microbial communities. Keywords: target addition experiment, proof-of-concept for GPL6012 ***Overall Array design*** The prototype microarray targeted thirteen BAC or fosmid genome fragments (20-160kb) from both bacteria and archaea, recovered from a variety of marine habitats, as well as the cyanobacterium Prochlorococcus MED4. These clones were originally sequenced because of the presence of taxonomic marker or specific functional genes. This array consisted of sets of 70-bp oligonucleotides targeting each genome or genome fragment (Fig. 1), dispersed along the target sequences with no more than one probe per gene, and excluding rRNA genes as targets. The probes were selected solely based on theoretical thermodynamic properties and GC content (~40%); that is, probe selection did not focus on specific genes or regions, but simply produced the âoptimalâ probes for each genome proxy based on the probesâ predicted hybridization properties. rRNA genes were excluded, because this probe design approach, which avoids sequence alignments and considerations of RNA secondary structure, would be unlikely to result in useful rRNA probes. Furthermore, rRNA probes of traditional design could not be included on the array because their appropriate hybridization conditions would be very different from those of this arrayâs probes. ***Microarray probe design*** Microarray 70-mer probes were designed using the program ArrayOligoSelector (Zhu et al., 2003) with the following settings: target %GC = 40%, 1 probe/gene, with the ORFs for each genome fragment as both the input and the database file. The output candidate 70mers were then sorted based on their %GC and those closest to 40% were chosen. In the case of more than the target number of probes having 40%GC, the subset with the lowest free energy of hybridization were selected as probes. Generally, 20 probes were selected per organism. Prochlorococcus MED4 was represented by 60 probes total, 20 each for three different 80kb âgenome-proxyâ regions: 0-80kb, 1.29-1.37Mbp, and 1.58 to 1.66Mbp. Using the same method, a set (n=20) of positive control probes were designed to the genome of the halophillic archaeon Halobacterium salinarum NRC-1. Negative control probes (n=28) were designed to a set of 49 random 1000-base sequences (Stothard, 2000). ***Microarray construction and hybridization*** Oligonucleotides were synthesized (Illumina, San Diego, California), suspended in 3XSSC to a concentration of 40pmol/μl, and spotted on homemade poly-L-lysine-coated glass slides using a QArray 2 microarraying robot (Genetix, Hampshire, England). Six replicates of each probe were spotted. ***Microarray data analysis*** Hybridized arrays were scanned using an Axon Instruments 4000B scanner (Foster City, CA) and the data was normalized and filtered using perl scripts written for the purpose, by the following steps. (1) Signal intensities for each spot were calculated by subtracting the local background (mean F532 â median B532, as calculated by GenePix Pro 5.1 software, Axon Instruments). (2) The median value across replicates was calculated for each probe. (3) For each probe set, the number of probes greater than twice the mean negative control signal was calculated, before further processing. (4) Filter I: Arrays with less than half their positive control probes exceeding twice the mean negative control signal were considered poor quality, low dynamic range, arrays and were excluded from further analysis. (5) Each probe signal was corrected for non-specific binding by subtracting the mean negative control spot signal. (6) The data was then normalized for array-to-array variations in brightness by dividing each probe signal by the mean positive control signal. This positive control signal was the mean signal across the Halobacterium salinarum probes in each hybridization, with identical amounts of H. salinarum DNA having been added to each reaction prior to amplification and labeling. (7) Filter II: In order for a genotype to be considered âpresentâ, at least 45% of its probes had to exceed twice the mean negative control signal. (8) Finally, each genotype signal was calculated as either the MEAN or TUKEY BIWEIGHT across its probe set. ***Experimental Design*** The array was hybridized to laboratory mixtures of cloned environmental genomic DNA targeted by the array, in varying ratios. The use of multiple probes to target many genes from each organism helped to normalize probe-to-probe heterogeneity, by averaging across all probes in a set (as described below). The evenness of probe response across each genotypeâs set was also used to evaluate the relatedness of hybridizing DNA. To more precisely define the arrayâs phylogenetic range and specificity, it was tested against DNA from Prochlorococcus MED4 and related strains, spanning the known range of Prochlorococcus phylogenetic diversity. To test the effects of hybridization stringency on the specificity and signal of the MED4 probes, Prochlorococcus strains were hybridized at a range of conditions. To test whether the specificity results for Prochlorococcus were comparable for other targeted clades, two genome fragments recovered from closely related phylotypes within the SAR86 clade of the gamma-proteobacteria were represented on the array, and were tested for specificity. To understand the equivalence of probe sets targeting different regions of the same organismâs genome, we targeted three 80kb âgenome proxyâ regions of the Prochlorococcus MED4 genome. One of the regions fell in a genomic âislandâ where inter-strain variability is concentrated (âISL5â in Coleman et al., 2006). To test the array in a complex environmental context, we collected coastal seawater (lacking detectable Prochlorococcus cells by flow cytometry) and added Prochlorococcus cells from strains MED4, MIT9515, MIT9312 and MIT9313 over a range of concentrations from ~101 â 106 cells/ml (Fig. 3). The seawater was then filtered and the DNA extracted, amplified, labeled, and hybridized to the array.
2010-05-25 | E-GEOD-9384 | biostudies-arrayexpress