Legacies of Pre-1960s Municipal Waste Incineration in the Pb of City Soils
Ontology highlight
ABSTRACT:
SUBMITTER:
PROVIDER: S-EPMC10569037 | biostudies-literature | 2023 Sep
REPOSITORIES: biostudies-literature
Similar Datasets
Project description: Not available
| S-EPMC10840445 | biostudies-literature
Project description:During coronavirus disease 2019 pandemic, the exponential increase in clinical waste (CW) generation has caused immense burden to CW treatment facilities. Co-incineration of CW in municipal solid waste incinerator (MSWI) is an emergency treatment method. A material flow model was developed to estimate the change in feedstock characteristics and resulting acid gas emission under different CW co-incineration ratios. The ash contents and lower heating values of the feedstocks, as well as HCl concentrations in flue gas showed an upward trend. Subsequently, 72 incineration residue samples were collected from a MSWI performing co-incineration (CW ratio <10 wt%) in Wuhan city, China, followed by 20 incineration residues samples from waste that were not co-incineration. The results showed that the contents of major elements and non-volatile heavy metals in the air pollution control residues increased during co-incineration but were within the reported ranges, whereas those in the bottom ashes revealed no significant changes. The impact of CW co-incineration at a ratio <10 wt% on the distribution of elements in the incineration residues was not significant. However, increase in alkali metals and HCl in flue gas may cause potential boiler corrosion. These results provide valuable insights into pollution control in MSWI during pandemic.
| S-EPMC8440058 | biostudies-literature
Project description:A new building filling materials (NBFM) using phosphogypsum and municipal solid waste incineration (MSWI) fly ash is prepared in this paper. The effects of MSWI fly ash dosage and MSWI fly ash water washing pretreatment on mechanical properties, setting time, metal leaching, hydration products and microstructure of NBFM are analyzed by a range of experimental studies. The results indicate that the mechanical properties, setting time and the density of micro interface of NBFM are optimal when the MSWI fly ash dosage is 3%. The mechanical properties of NBFM rise and the condensation time and leaching concentration of heavy metals decline after washing the MSWI fly ash. With the increase of the curing age, the metal element leaching of NBFM decreases, and when the curing age is 7 days, the solidification effect of NBFM on most metal elements meets the standard of Chinese code (GB5085.3-2007). The feasibility of MSWI fly ash and phosphogypsum as filling materials for building engineering is verified, and the change of macroscopic properties of NBFM is explained as well.
| S-EPMC9832018 | biostudies-literature
Project description:This study examined the potential health risks posed by the operation of 96 waste-to-energy (WtE) plants in 30 cities in the Bohai Rim of China. Utilizing a sophisticated simulation approach, the Weather Research and Forecasting (WRF) model coupled with the California Puff (CALPUFF) model, we obtained the spatial distribution of pollutants emitted by WtE plants in the atmosphere. Hazard indices (HI) and cancer risks (CR) were calculated for each plant using the United States Environmental Protection Agency's recommended methodologies. The results indicated that both HIs and CRs were generally low, with values below the accepted threshold of 1.0 and 1.0 × 10-6, respectively. Specifically, the average HI and CR values for the entire study area were 2.95 × 10-3 and 3.43 × 10-7, respectively. However, some variability in these values was observed depending on the location and type of WtE plant. A thorough analysis of various parameters, such as waste composition, moisture content, and operating conditions, was conducted to identify the factors that influence the health risks associated with incineration. The findings suggest that proper waste sorting and categorization, increased cost of construction, and elevated height of chimneys are effective strategies for reducing the health risks associated with incineration. Overall, this study provides valuable insights into the potential health risks associated with WtE plants in the Bohai Rim region of China. The findings can serve as useful guidelines for law enforcement wings and industry professionals seeking to minimize the risks associated with municipal solid waste (MSW) management and promote sustainable development.
| S-EPMC11400610 | biostudies-literature
Project description:This paper reports supplementary information to "Understanding room-temperature magnetic properties of anthropogenic ashes from municipal solid waste incineration to assess potential impacts and resources" [1]. The sample-set is composed of 47 samples of bottom (BA) and fly (FA) ashes from Municipal Solid Waste Incineration (MSWI), including eight magnetic extracts of selected BA and FA materials. The sampling relies on a simple random sampling strategy at four different MSWI sites in Northern Italy [2]. X-Ray Fluorescence (XRF) analysis on pressed powder pellets, microscopic observations on thin sections and stubs, and magnetic analysis were carried out. Various magnetic measurements are presented: the magnetic susceptibility measured at two different frequencies (0.47 and 4.7 kHz); the mass-specific susceptibility of ARM (χARM), expressed in m3/kg, calculated after mass-normalization and bias DC field correction; experiments for isothermal remanent magnetization (IRM) experimented were also conducted. The latter measurement allowed the calculation of additional parameters, such as the coercivity of remanence (B0cr) and the S-ratio [3]. The IRM acquired in a field of 1.0 T was regarded as the saturation IRM (SIRM). Mass-specific magnetic susceptibility (χ) was calculated by dividing the volume susceptibility by the sample mass. Finally, hysteresis loops and backfield curves at room temperature were measured on selected samples and are available. Data can be reused as groundwork information in future studies on MSWI residues. It would be essential to produce new data on geochemical and magnetic characteristics of MSWI residues to assure good coverage of data for enhanced sustainability of these heterogeneous streams of anthropogenic materials. This combination of methods will contribute to paving the way for quick and reliable resource assessment as well as to promote environmental sustainability.
| S-EPMC7298404 | biostudies-literature
Project description:We reported the gene expression profile of T47D cells treated with the organic extract of Particulate matter 2.5 (PM2.5) sampled next to the municipal solid waste incineration plant of Bologna city. Based on a air pollution distribution model that takes the incinaration plant as point source of emission, two sites were chosen to sample particulate matter near incineration plant: "FrulloEst" representing the maximum effect of the incineration plant, "Calamosco" representing the negative control of "FrulloEst" (minimun effect of incineration plant, same effect of other air pollution fonts). Another site, "Giardini Margherita", is chosen to sample the urban background air pollution. for each site sample collection was performed in winter and in summer season.
2018-01-31 | E-MEXP-3686 | biostudies-arrayexpress
Project description:BackgroundFly ashes from municipal solid waste incineration contain significant amounts of (technology critical) elements. Processes to recover Cu or Zn are already in practice, but it still remains difficult to evaluate the full secondary resource potential of the ashes. One reason is the absence of a worldwide comparable analytical basis for detailed market analyses. To encounter this, (i) an advice on how to analyse 65 elements after microwave-assisted digestion by ICP-OES and ICP-MS is delivered, (ii) the heterogeneity (hours to annual cycle) is evaluated for a incineration plant, (iii) leaching efficiency with three different eluents and (iv) the market potential of the elements as commodities are evaluated.Results and conclusionsAqua regia digestion was found to be sufficient to evaluated the recovery potential; except for the mass constituents Al, Si, Sn, Ti and the trace components Cr, Hf, Nb, U and W, for which HF-containing digestions delivered better recoveries. On different time scales, ashes were very homogenous and HCl- as well as H2SO4-supported leaching delivered, satisfying results within an hour (exceptions are, e.g., Bi and Sb). By applying characterisation factors of the life cycle assessment impact category "Resource depletion-minerals and metals" supplemented by the list of critical raw materials of the EU: Ag, Bi, Cd, Ga, In and Sb are most interesting elements to be recovered in future activities.
| S-EPMC7301355 | biostudies-literature
Project description:Municipal solid waste incineration (MSWI) is an effective method for reducing the volume/mass of waste. However, MSWI ashes contain high concentrations of many substances, including trace metal (loid)s, that could be released into the environment and contaminate soils and groundwater. In this study, attention was focused on the site near the municipal solid waste incinerator where MSWI ashes are deposited on the surface without any control. Here, combined results (chemical and mineralogical analyses, leaching tests, speciation modelling, groundwater chemistry and human health risk assessment) are presented to assess the impact of MSWI ash on the surrounding environment. The mineralogy of ∼forty years old MSWI ash was diverse, and quartz, calcite, mullite, apatite, hematite, goethite, amorphous glasses and several Cu-bearing minerals (e.g. malachite, brochantite) were commonly detected. In general, the total concentrations of metal (loid)s in MSWI ashes were high, following the order: Zn (6731 mg/kg) > Ba (1969 mg/kg) ≈ Mn (1824 mg/kg) > Cu (1697 mg/kg) > Pb (1453 mg/kg) > Cr (247 mg/kg) > Ni (132 mg/kg) > Sb (59.4 mg/kg) > As (22.9 mg/kg) ≈ Cd (20.6 mg/kg). Cadmium, Cr, Cu, Pb, Sb and Zn exceeded the indication or even intervention criteria for industrial soils defined by the Slovak legislation. Batch leaching experiments with diluted citric and oxalic acids that simulate the leaching of chemical elements under rhizosphere conditions documented low dissolved fractions of metals (0.00-2.48%) in MSWI ash samples, showing their high geochemical stability. Non-carcinogenic and carcinogenic risks were below the threshold values of 1.0 and 1 × 10-6, respectively, with soil ingestion being the most important exposure route for workers. The groundwater chemistry was unaffected by deposited MSWI ashes. This study may be useful in determining the environmental risks of trace metal (loid)s in weathered MSWI ashes that are loosely deposited on the soil surface.
| S-EPMC9976324 | biostudies-literature
Project description:A new technology was recently developed for municipal solid waste incineration (MSWI) fly ash stabilization, based on the employment of all waste and byproduct materials. In particular, the proposed method is based on the use of amorphous silica contained in rice husk ash (RHA), an agricultural byproduct material (COSMOS-RICE project). The obtained final inert can be applied in several applications to produce "green composites". In this work, for the first time, a process for pre-treatment of rice husk, before its use in the stabilization of heavy metals, based on the employment of Instant Pressure Drop technology (DIC) was tested. The aim of this work is to verify the influence of the pre-treatment on the efficiency on heavy metals stabilization in the COSMOS-RICE technology. DIC technique is based on a thermomechanical effect induced by an abrupt transition from high steam pressure to a vacuum, to produce changes in the material. Two different DIC pre-treatments were selected and thermal annealing at different temperatures were performed on rice husk. The resulting RHAs were employed to obtain COSMOS-RICE samples, and the stabilization procedure was tested on the MSWI fly ash. In the frame of this work, some thermal treatments were also realized in O2-limiting conditions, to test the effect of charcoal obtained from RHA on the stabilization procedure. The results of this work show that the application of DIC technology into existing treatment cycles of some waste materials should be investigated in more details to offer the possibility to stabilize and reuse waste.
| S-EPMC5455375 | biostudies-other
Project description:For the long-term operation of municipal solid waste incineration (MSWI), online monitoring and feedback control of polychlorinated dibenzo-p-dioxin and dibenzofuran (PCDD/F) can be used to control the emissions to national or regional standards. In this study, 500 PCDD/F samples were determined by thermal desorption gas chromatography coupled to tunable-laser ionization time-of-flight mass spectrometry (TD-GC-TLI-TOFMS) for 168 h. PCDD/F emissions range from 0.01 ng I-TEQ/Nm3 to 2.37 ng I-TEQ/Nm3, with 44% of values below 0.1 ng I-TEQ/Nm3 (the national standard). In addition, the temperature of the furnace outlet, bed pressure, and oxygen content are considered as key operating parameters among the 13 operating parameters comprising four temperature parameters, four pressure parameters, four flow parameters, and oxygen content. More specifically, maintaining the furnace outlet temperature to be higher than 800 °C, or bed pressure higher than 13 kPa, or the oxygen content stably and above 10% are effective methods for reducing PCDD/F emissions. According to the analysis of the Pearson coefficients and maximal information coefficients, there is no significant correlation between operating parameters and PCDD/F I-TEQ. Only when there is a significant change in one of these factors will the PCDD/F emissions also change accordingly. The feedback control of PCDD/F emissions is realized by adjusting the furnace outlet temperature, bed temperature, and bed pressure to control the PCDD/F to be less than 0.1 ng I-TEQ/Nm3.
| S-EPMC8305602 | biostudies-literature