Rh-In2O3 Nanoparticles for Efficient Photocatalytic Degradation of Rifampin
Ontology highlight
ABSTRACT:
SUBMITTER: Tang S
PROVIDER: S-EPMC10620787 | biostudies-literature | 2023 Oct
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Special attention has recently been paid to surface-defective titanium dioxide and black TiO2 with advanced optical, electrical, and photocatalytic properties. Synthesis of these materials for photodegradation and mineralization of persistent organic pollutants in water, especially under visible radiation, presents interest from scientific and application points of view. Chemical reduction by heating a TiO2 and NaBH4 mixture at 350 °C successfully introduced Ti3+ defects and oxygen vacancies at the surface of TiO2, with an increase in the photocatalytic degradation of amoxicillin-an antibiotic that is present in wastewater due to its intense use in human and animal medicine. Three TiO2 samples were prepared at different annealing temperatures to control the ratio between anatase and rutile and were subjected to chemical reduction. Electron paramagnetic resonance investigations showed that the formation of surface Ti3+ defects in a high concentration occurred mainly in the anatase sample annealed at 400 °C, contributing to the bandgap reduction from 3.32 eV to 2.92 eV. The reduced band gap enhances visible light absorption and the efficiency of photocatalysis. The nanoparticles of ~90 m2/g specific surface area and 12 nm average size exhibit ~100% efficiency in the degradation of amoxicillin under simulated solar irradiation compared with pristine TiO2. Mineralization of amoxicillin and by-products was over 75% after 48 h irradiation for the anatase sample, where the Ti3+ defects were present in a higher concentration at the catalyst's surface.
| S-EPMC9330099 | biostudies-literature
Project description:Hierarchical mesoporous TiO2 was synthesized via a solvothermal technique. The sonochemical method was adopted to decorate plasmonic nanoparticles (NPs) (Ag, Au) on the pores of mesoporous TiO2. The crystallinity, structure, and morphology were determined to understand the physicochemical nature of the nanocomposites. The catalytic efficiency of the plasmonic nanocatalysts was tested for the azo dyes (congo red, methyl orange, acid orange 10, and remazol red) under solar and visible light irradiations. The generation of hydroxyl radicals was also studied using terephthalic acid as a probe molecule. An attempt was made to understand the influence of size, work function and Fermi level of the metal NPs toward the efficiency of the photocatalyst. The efficiency of the nanocomposites was found to be in the order of P25 < mesoporous TiO2 < mesoporous Ag-TiO2 < mesoporous Au-TiO2 nanospheres under both direct solar light and visible light irradiation. The results indicated that the adsorption of dye, anatase phase, and surface plasmon resonance of NPs favored the effective degradation of dyes in aqueous solution. Further, the efficiency of the catalyst was also tested for xanthene (rose bengal), rhodamine (rhodamine B, rhodamine 6G), and thiazine (methylene blue) dyes. Both TiO2 and NPs (Ag & Au) possess a huge potential as an eco-friendly photocatalyst for wastewater treatment.
| S-EPMC6644734 | biostudies-literature
Project description:The design and construction of a photocatalyst with a heterostructure are a feasible and effective way to enhance the catalytic performance. Herein, a specially designed composite based on MIL-125-NH2 and BiVO4 was prepared and used for wastewater treatment. In the hybrid MIL-125-NH2@BiVO4, MIL-125-NH2 was uniformly dispersed on the BiVO4 surface. There is a high affinity between MIL-125-NH2 and BiVO4 due to the lattice defects. Under visible light irradiation, the catalytic activity of the as-prepared composite was evaluated by the degradation of various dyes such as malachite green, crystal violet, methylene blue, and Congo red. Nearly 98.7, 99.1, and 41.0% of the initial MG, MB and Cr(VI) were respectively removed over the optical sample of BVTN-5, demonstrating that the hybrid holds great promise for practical applications. Moreover, the composites can be recycled and reused with good stability after five consecutive cycles. The mechanism was proposed and discussed in detail. This work will shed light on the construction of MOF-based composites for efficient photocatalysis.
| S-EPMC9352263 | biostudies-literature
Project description:Photocatalysis is one of the effective ways to degrade pollutant antibiotics. Agar is used as the adsorption module to provide abundant pore structure. Carbon dots (CDs) are selected as light energy conversion components. Graphitic carbon nitride (g-C3N4) is used as the main material of the catalyst. Agar/CDs/g-C3N4-functionalized aerogel with a unique 3D pore structure is assembled. The Agar/CDs/g-C3N4 aerogel shows the highest photocurrent density, which is 3.7 times that of agar, 2.4 times that of 3-g-C3N4 and 1.6 times that of Agar/g-C3N4 aerogel. Compared with 3-g-C3N4 and Agar/g-C3N4 aerogel, which can completely remove AMX after 75 min, Agar/CDs/g-C3N4 aerogel can degrade amoxicillin (AMX) completely after 45 min of illumination. The reason is that Agar/CDs/g-C3N4 aerogel has a larger specific surface area, richer functional groups, a wider spectral range, higher photocurrent density and better carrier migration and separation efficiency. It is a good strategy with which to combine the effects of each component in the ternary system for the efficient photocatalysis of organic pollutants.
| S-EPMC10888021 | biostudies-literature
Project description:The present study reports the synthesis of polycarbazole (PCz)-decorated TiO2 nanohybrids via in situ chemical polymerization of carbazole monomers in TiO2 dispersions. The ratio of the polymer in the nanohybrid varied between 0.5 and 2 wt %. The synthesized nanohybrids were characterized using infrared and diffuse reflectance spectroscopies, whereas the morphology was analyzed using X-ray diffraction (XRD) and transmission electron microscopy (TEM) techniques. XRD revealed changes in the peak corresponding to the d(001) plane of TiO2 owing to the interaction between the two components. TEM confirmed the formation of PCz-decorated nanohybrids. Amido Black 10B (AB-10B) was chosen as a model dye for the degradation studies. Sonophotocatalytic degradation of the dye was studied by varying the catalyst and dye concentrations. Results showed that PCz/TiO2 nanohybrids exhibited a complete degradation of AB-10B dye within a short span of 60-90 min, which was faster than pure TiO2 and the reported decorated TiO2 nanohybrids synthesized by other authors. The degraded dye fragments were identified using liquid chromatography-mass spectrometry (LCMS). By varying the loading of PCz in TiO2, the nanohybrids could be tuned to achieve visible light-driven degradation.
| S-EPMC6645004 | biostudies-literature
Project description:Colloidal-free screen-printed p-n BiOCl/BiFeO3 heterojunctions are successfully synthesized to achieve photocatalytic degradation of Rhodamine B (RhB) using visible light (λ ≥ 400 nm). The crystalline structure of dense BiOCl nanosheets self-assembled with impressive aspect ratio atop BFO powders is confirmed by XRD, Raman and TEM measurements. Iron impurities inside these 10 ± 2 nm-thick BiOCl nanosheets increase visible light absorption. Fluorescent Rhodamine B (RhB) dye degradation is used to evaluate the photocatalytic performance of this unique heterojunction material. For optimal metal-enhanced RhB degradation, a few nanometers of platinum are deposited using the sputtering technique to act as a cocatalyst. This unique architecture yields an impressive 92% RhB degradation in only 150 min under visible light. Operating at near-neutral pH, the proposed approach also addresses the key issue of catalysis recovery, which remains one of the main drawbacks of current photocatalysis technologies.
| S-EPMC9428655 | biostudies-literature
Project description:A Z-scheme system In2S3/WO3 heterojunction was fabricated via a mild hydrothermal method and further applied for photocatalytic degradation of tetracycline (TCH) and Rhodamine B (Rh B) under visible light irradiation. The morphological structure, chemical composition and optical properties were studied by XRD, SEM, HRTEM and UV-visible absorption spectra. The results revealed that In2S3/WO3 hierarchical structures were successfully constructed, and the prepared In2S3/WO3 photocatalysts exhibited enhanced visible-light absorption compared to pure WO3 nanorods, which are essential to improve the photocatalytic performance. The degradation rate of TCH using the In2S3(40 wt%)/WO3 heterostructure (WI40) photocatalyst was about 212 times and 22 times as high as that for pure WO3 and pure In2S3, respectively. The degradation rate of Rh B with the WI40 photocatalyst was about 56 times the efficiency of pure WO3 and 7.6 times that of pure In2S3. The results of the surface photovoltage (SPV), transient photovoltage (TPV) and reactive oxidation species (ROS) scavenger experiments indicated that the Z-scheme system of In2S3/WO3 is favorable for photoexcited charge transfer at the contact interface of In2S3 and WO3, which benefits the charge separation efficiency and depresses the recombination of photoexcited charge, resulting in favorable photocatalytic pollutant degradation efficiency under visible light irradiation.
| S-EPMC8694021 | biostudies-literature
Project description:In this study, we report the degradation of smooth and rough lipopolysaccharides (LPS) from Gram-negative bacteria and of lipoteichoic acid (LTA) from Gram-positive bacteria by peptide-coated TiO2 nanoparticles (TiO2 NPs). While bare TiO2 NPs displayed minor binding to both LPS and LTA, coating TiO2 NPs with the antimicrobial peptide LL-37 dramatically increased the level of binding to both LPS and LTA, decorating these uniformly. Importantly, peptide coating did not suppress reactive oxygen species generation of TiO2 NPs; hence, UV illumination triggered pronounced degradation of LPS and LTA by peptide-coated TiO2 NPs. Structural consequences of oxidative degradation were examined by neutron reflectometry for smooth LPS, showing that degradation occurred preferentially in its outer O-antigen tails. Furthermore, cryo-TEM and light scattering showed lipopolysaccharide fragments resulting from degradation to be captured by the NP/lipopolysaccharide coaggregates. The capacity of LL-37-TiO2 NPs to capture and degrade LPS and LTA was demonstrated to be of importance for their ability to suppress lipopolysaccharide-induced activation in human monocytes at simultaneously low toxicity. Together, these results suggest that peptide-coated photocatalytic NPs offer opportunities for the confinement of infection and inflammation.
| S-EPMC11551910 | biostudies-literature
Project description:The photocatalytic activity of photocatalysts is severely hampered by limited visible light harvesting and unwanted fast recombination of photogenerated e- and h+. In the current study, the photocatalytic efficiency of Cu-ZnO/S-g-C3N4 (CZS) nanocomposites was investigated against MB dye. The composite materials were designed via chemical co-precipitation method and characterised by important analytical techniques. Distinctive heterojunctions developed between S-g-C3N4 and Cu-ZnO in the CZS composite were revealed by TEM. The synthesized composites exhibit a huge number of active sites, a large surface area, a smaller size and better visible light absorption. The considerable enhancement in the photocatalytic activity of CZS nanocomposites might be accredited to the decay in the e-h pair recombination rate and a red shift in the visible region, as observed by PL and optical analysis, respectively. Furthermore, the metal (Cu) doping into the S-g-C3N4/ZnO matrix created exemplary interfaces between ZnO and S-g-C3N4, and maximized the photocatalytic activity of CZS nanocomposites. In particular, CZS nanocomposites synthesized by integrating 25% S-g-C3N4 with 4% Cu-ZnO (CZS-25 NCs) exhibited the 100% photocatalytic degradation of MB in 60 minutes under sunlight irradiation. After six cycles, the photocatalytic stability of CZS-25 NCs was excellent. Likewise, a plausible MB degradation mechanism is proposed over CZS-25 NCs based on photoluminescence and reactive species scavenger test observation. The current research supports the design of novel composites for the photocatalytic disintegration of organic contaminants.
| S-EPMC9044814 | biostudies-literature
Project description:In this study, novel hydrothermal ex situ synthesis was adopted to synthesize MoS2/WO3 heterostructures using two different molar ratios of 1:1 and 1:4. The "bottom-up" assembly was successfully developed to synthesize spherical and flaky-shaped heterostructures. Their structural, morphological, compositional, and bandgap characterizations were investigated through XRD, EDX, SEM, UV-Visible spectroscopy, and FTIR analysis. These analyses help to understand the agglomerated heterostructures of MoS2/WO3 for their possible photocatalytic application. Therefore, prepared heterostructures were tested for RhB photodegradation using solar light irradiation. The % efficiency of MoS2/WO3 composites for 30 min irradiation of 1:1 was 91.41% and for 1:4 was 98.16%. Similarly, the % efficiency of 1:1 MoS2/WO3 heterostructures for 60 min exposure was 92.68%; for 1:4, it was observed as 98.56%; and for 90 min exposure, the % efficiency of 1:1 was 92.41%, and 98.48% was calculated for 1:4 composites. The photocatalytic efficiency was further verified by reusability experiments (three cycles), and the characterization results afterward indicated the ensemble of crystalline planes that were responsible for the high efficiency. Moreover, these heterostructures showed stability over three cycles, indicating their future applications for other photocatalytic applications.
| S-EPMC9458188 | biostudies-literature