Project description:BackgroundThe conventional degumming process of ramie with alkaline treatment at high temperature causes severe environmental pollution. Pectate lyases can be used to remove pectin from ramie in a degumming process with reduced environmental pollution and energy consumption. Pectate lyase PEL168 from Bacillus subtilis has been previously characterized and the protein structure was resolved. However, Bacillus is not a suitable host for pectate lyases during the degumming process since most Bacillus produce cellulases endogenously with a detrimental effect to the fiber. Pichia pastoris, which does not express endogenous cellulases and has high secretion capability, will be an ideal host for the expression. No previous work was reported concerning the heterologous expression of pectate lyase PEL168 in P. pastoris with an aim for industrial application in ramie bio-degumming.ResultsThe gene pel168 was expressed in P. pastoris in this study. The recombinant protein PEL168 in P. pastoris (PEL168P) showed two bands of 48.6 kDa and 51.4 kDa on SDS-PAGE whereas the enzyme expressed in E. coli (PEL168E) was the same as predicted with a band of 46 kDa. Deglycosylation digestion suggested that PEL168P was glycosylated. The optimum reaction temperature of the two PEL168s was 50°C, and the optimum pH 9.5. After preincubation at 60°C for 20 min, PEL168E completely lost its activity, whereas PEL168P kept 26% of the residual activity. PEL168P had a specific activity of 1320 U/mg with a Km of 0.09 mg/ml and a Vmax of 18.13 μmol/min. K⁺, Li⁺, Ni²⁺ and Sr²⁺ showed little or no inhibitory effect on PEL168P activity, and Ca²⁺ enhanced enzyme activity by 38%. PEL168P can remove the pectin from ramie effectively in a degumming process. A 1.5 fold increase of PEL168 enzyme expression in P. pastoris was achieved by further codon optimization.ConclusionsPectate lyase PEL168 with an available protein structure can be heterologously expressed in P. pastoris. The characterized recombinant PEL168P can be used to remove pectin from ramie efficiently and the expression level of PEL168 in P. pastoris was increased markedly by codon optimization. Therefore, PEL168 is an ideal candidate for further optimization and engineering for bio-degumming.
Project description:α-Amylase as an important industrial enzyme has been widely used in starch processing, detergent, and paper industries. To improve expression efficiency of recombinant α-amylase from Bacillus licheniformis (B. licheniformis), the α-amylase gene from B. licheniformis was optimized according to the codon usage of Pichia pastoris (P. pastoris) and expressed in P. pastoris. Totally, the codons encoding 305 amino acids were optimized in which a total of 328 nucleotides were changed and the G+C content was increased from 47.6 to 49.2%. The recombinants were cultured in 96-deep-well microplates and screened by a new plate assay method. Compared with the wild-type gene, the optimized gene is expressed at a significantly higher level in P. pastoris after methanol induction for 168 h in 5- and 50-L bioreactor with the maximum activity of 8100 and 11000 U/mL, which was 2.31- and 2.62-fold higher than that by wild-type gene. The improved expression level makes the enzyme a good candidate for α-amylase production in industrial use.
Project description:Pectate lyases play an essential role in textiles, animal feed, and oil extraction industries. Pichia pastoris can be an ideal platform for pectate lyases production, and BspPel (a thermo-alkaline pectate lyase from Bacillus sp. RN1) was overexpressed by combined strategies, reaching 1859 U/mL in a 50 L fermentator. It displayed the highest activity at 80°C, and maintained more than 60% of the activity between 30 and 70°C for 1 h. It showed an optimal pH of 10.0, and exhibited remarkable stability over a wider pH range (3.0-11.0), retaining more than 80.0% of enzyme activity for 4 h. The K m and k cat of BspPel on PGA (polygalacturonic acid) was 2.19 g L-1 and 116.1 s-1, respectively. The activity was significantly enhanced by Ca2+, Mn2+, and Cu2+, and a slight increase was observed with the addition of Ba2+ and Mg2+. Scanning electron microscope was used to show the degumming efficiency of BspPel on ramie fibers. The loss weight was 9.2% when treated with crude enzyme supernatant and 20.8% when treated with the enzyme-chemical method, which was higher than the 14.2% weight loss in the positive control treated with 0.5% (w/v) NaOH alone. In conclusion, BspPel could be a good candidate for the ramie degumming industry.
Project description:Thermostable α-amylases are widely used in industry. The α-amylase from Bacillus licheniformis (BLA) with six potential glycosylation sites possessed excellent thermal and pH stability and high activity. Here, it was expressed in Pichia pastoris. The Pic-BLA-producing yeast without any antibiotics-resistant gene was cultivated in flasks and the amylase activity in fermentation supernatant reached 900 U/mL. The recombinant α-amylase Pic-BLA produced in P. pastoris was deeply glycosylated with 30% increase in molecular mass (MM). The deglycosylation treatment by Endoglycosidase H (Endo H) reduced the MM of Pic-BLA. Thermostability analysis showed that Pic-BLA and deglycosylated Pic-BLA were similar in heat tolerance. In order to eliminate the extra impact of Endo H, the BLA was also expressed in Escherichia coli to get non-glycosylated Eco-BLA. A comparative study between non-glycosylated Eco-BLA and glycosylated Pic-BLA showed no obvious difference in thermostability. It is speculated that the glycosylation has little effect on the thermostability of α-amylase BLA.
Project description:Alginate is one of the most abundant polysaccharides in algae. Alginate lyase degrades alginate through a β-elimination mechanism to produce alginate oligosaccharides with special bioactivities. Improving enzyme activity and thermal stability can promote the application of alginate lyase in the industrial preparation of alginate oligosaccharides. In this study, the recombinant alginate lyase cAlyM and its thermostable mutant 102C300C were expressed and characterized in Pichia pastoris. The specific activities of cAlyM and 102C300C were 277.1 U/mg and 249.6 U/mg, respectively. Both enzymes showed maximal activity at 50 °C and pH 8.0 and polyG preference. The half-life values of 102C300C at 45 °C and 50 °C were 2.6 times and 11.7 times the values of cAlyM, respectively. The degradation products of 102C300C with a lower degree of polymerization contained more guluronate. The oligosaccharides with a polymerization degree of 2-4 were the final hydrolytic products. Therefore, 102C300C is potentially valuable in the production of alginate oligosaccharides with specific M/G ratio and molecular weights.
Project description:Alkaline pectate lyase has developmental prospects in the textile, pulp, paper, and food industries. In this study, we selected BacPelA, the pectin lyase with the highest expression activity from Bacillus clausii, modified and expressed in Escherichia coli BL21(DE3). Through fragment replacement, the catalytic activity of the enzyme was significantly improved. The optimum pH and temperature of the modified pectin lyase (PGLA-rep4) were 11.0 and 70 °C, respectively. It also exhibited a superior ability to cleave methylated pectin. The enzyme activity of PGLA-rep4, measured at 235 nm with 0.2% apple pectin as the substrate, was 554.0 U/mL, and the specific enzyme activity after purification using a nickel column was 822.9 U/mg. After approximately 20 ns of molecular dynamics simulation, the structure of the pectin lyase PGLA-rep4 tended to be stable. The root mean square fluctuation (RMSF) values at the key catalytically active site, LYS168, were higher than those of the wildtype PGLA. In addition, PGLA-rep4 was relatively stable in the presence of metal ions. PGLA-rep4 has good enzymatic properties and activities and maintains a high pH and temperature. This study provides a successful strategy for enhancing the catalytic activity of PGLA-rep4, making it the ultimate candidate for degumming and various uses in the pulp, paper, and textile industries.
Project description:Stylopine is a protoberberine-type alkaloid that has potential biological activities. Based on the successful microbial production of (S)-reticuline, we attempted to produce stylopine from (S)-reticuline by the reaction of berberine bridge enzyme, cheilanthifoline synthase (CYP719A5), and stylopine synthase (CYP719A2). Biosynthetic enzyme expression was examined in a methanol-utilizing yeast (Pichia pastoris), and both a "consolidated" system with all genes expressed in one cell and a "co-culture" system with three cell lines that each express a single gene were examined. Although both systems efficiently converted reticuline to stylopine, the consolidated system was more rapid and efficient than the co-culture system. However, substrate-feeding experiments revealed a decrease in the conversion efficiency in the consolidated system during successive cultures, whereas the conversion efficiency in the co-culture system remained constant. Thus, the final amount of stylopine produced from reticuline after successive feedings in the co-culture system was more than 150 nmoles from 750 nmoles of (R, S)-reticuline (375 nmoles of (S)-reticuline). The advantages and drawbacks of the "consolidated" system and the "co-culture" system are discussed.
Project description:Pyranose dehydrogenase (PDH) is a fungal flavin-dependent sugar oxidoreductase that is highly interesting for applications in organic synthesis or electrochemistry. The low expression levels of the filamentous fungus Agaricus meleagris as well as the demand for engineered PDH make heterologous expression necessary. Recently, Aspergillus species were described to efficiently secrete recombinant PDH. Here, we evaluate recombinant protein production with expression hosts more suitable for genetic engineering. Expression in Escherichia coli resulted in no soluble or active PDH. Heterologous expression in the methylotrophic yeast Pichia pastoris was investigated using two different signal sequences as well as a codon-optimized sequence. A 96-well plate activity screening for transformants of all constructs was established and the best expressing clone was used for large-scale production in 50-L scale, which gave a volumetric yield of 223 mg L(-1) PDH or 1,330 U?L(-1) d(-1) in space-time yield. Purification yielded 13.4 g of pure enzyme representing 95.8% of the initial activity. The hyperglycosylated recombinant enzyme had a 20% lower specific activity than the native enzyme; however, the kinetic properties were essentially identical. This study demonstrates the successful expression of PDH in the eukaryotic host organism P. pastoris paving the way for protein engineering. Additionally, the feasibility of large-scale production of the enzyme with this expression system together with a simplified purification scheme for easy high-yield purification is shown.
Project description:Pectin methylesterase (PME) which is widely used in the cosmetic, food and pharmaceutical industries catalyses the hydrolysis of the methyl ester of pectin to yield methanol and free carboxyl groups. This study was performed to produce active pectin methylesterase (PME) extracellularly from Pectobacterium chrysanthemi in Pichia pastoris. Firstly, pGKBα was constructed for the secretion of heterologous protein. After it was cloned in Escherichia coli cells and the sequence was affirmed, PME gene was inserted into pGKBα. So, pGKBα-PME carried the PME gene in correct position was cloned in E. coli cells. Then, P. pastoris X-33 cells were transformed with linearized pGKBα-PME and six transformants were cultivated for recombinant PME production. It was observed that one of them had a high-capacity secretion of active PME. The molecular mass of extracellular PME enzyme was found to be about 59 kDa. The PME enzyme from P. chrysanthemi was produced by P. pastoris for the first time in this study. This recombinant enzyme might be produced in a large scale and also purified from the culture medium. Then, the purified enzyme might be used for clarification and increasing yield of juice in food industrial applications.Supplementary informationThe online version contains supplementary material available at 10.1007/s13205-022-03291-3.
Project description:Chitinase and chitin-oligosaccaride can be used in multiple field, so it is important to develop a high-yield chitinase producing strain. Here, a recombinant Pichia pastoris with 4 copies of ChiA gene from Bacillus licheniformis and co-expression of molecular chaperon HAC1 was constructed. The amount of recombinant ChiA in the supernatant of high-cell-density fermentation reaches a maximum of 12.7 mg/mL, which is 24-fold higher than that reported in the previous study. The recombinant ChiA can hydrolyze 30% collodidal chitin with 74% conversion ratio, and GlcNAc is the most abundant hydrolysis product, followed by N, N'-diacetylchitobiose. Combined with BsNagZ, the hydrolysate of ChiA can be further transformed into GlcNAc with 88% conversion ratio. Additionally, the hydrolysate of ChiA can obviously accelerate the germination growth of rice and wheat, increasing the seedling height and root length by at least 1.6 folds within 10 days.