Energy Dissipation Rate and Micromixing in a Two-Step Micro-Reactor with Intensively Swirled Flows.

ABSTRACT: The influence of the hydrodynamics (flow rates Q, specific energy dissipation rate ε) on the micromixing in a two-step microreactor with intensively swirled flows (MRISF-2) was studied experimentally. Three methods of liquid input into the reactor were compared: (i) through the upper tangential and axial nozzles (TU1, Ax); (ii) through two upper tangential nozzles (TU1, TU2); (iii) through the upper and lower tangential nozzles (TU1, TL2). Segregation index X_s used as a measure of micromixing level was determined by means of iodide iodate reaction method. The Bernoulli equation for a device with two inputs and one output was derived to assess the energy consumption. It was revealed that in MRISF-2 up to 99.8-99.9% of input energy is dissipated, i.e., transformed into liquid element deformations thus resulting in better micromixing. For each of three liquid inputs, the dependence ε = f(Q) could be fairly approximated by an exponent ε = A₁Qⁿ¹, with n₁ ≈ 3.0. For connection (TU1, TU2) the dependence X_s = f(ε) falls linearly for Q > 2 L/min, but for the low flow rates (Q ≈ 1 L/min) there is an unusually small X_s value; the effect of good micromixing is caused by the kinetic energy concentrated in a small volume of liquid near the neck. The best behavior in terms of micromixing was achieved for the (TU1, Ax) connection scheme: the level of X_s ≈ 0.01 for ε ≈ 30 W/kg, and comes down with growing ε to X_s ≈ 0.002 for ε ≈ 30,000 W/kg. These values are 50 and 250 times lower compared to the mixing in a lab glass with a magnetic stirrer, as shown in our previous work. The parameters of dependencies Xs=A3εn3 were found for (TU1, Ax) and (TU1, TL2).

SUBMITTER: Abiev RS 

PROVIDER: S-EPMC9699309 | biostudies-literature | 2022 Oct

REPOSITORIES: biostudies-literature