Chitosan-CdS Quantum Dots Biohybrid for Highly Selective Interaction with Copper(II) Ions
Ontology highlight
ABSTRACT:
SUBMITTER: K. Algethami F
PROVIDER: S-EPMC9347964 | biostudies-literature | 2022 Jun
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Citric acid capped CdS quantum dots (CA-CdS QDs), a new assembled fluorescent probe for copper ions (Cu2+), was synthesized successfully by a simple hydrothermal method. In this work, the fluorescence sensor for the detection of heavy and transition metal (HTM) ions has been extensively studied in aqueous solution. The results of the present study indicate that the obtained CA-CdS QDs could detect Cu2+ with high sensitivity and selectivity. It found that the existence of Cu2+ has a significant fluorescence quenching with a large red shifted (from greenish-yellow to yellowish-orange), but not in the presence of 17 other HTM ions. As a result, Cu₂S, the energy level below the CdS conduction band, could be formed at the surface of the CA-CdS QDs and leads to the quenching of fluorescence of CA-CdS QDs. Under optimal conditions, the copper ions detection range using the synthesized fluorescence sensor was 1.0 × 10‒8 M to 5.0 × 10‒5 M and the limit of detection (LOD) is 9.2 × 10‒9 M. Besides, the as-synthesized CA-CdS QDs sensor exhibited good selectivity toward Cu2+ relative to other common metal ions. Thus, the CA-CdS QDs has potential applications for detecting Cu2+ in real water samples.
| S-EPMC6358774 | biostudies-literature
Project description:Due to the rapid development of industrialization, various environmental problems such as water resource pollution are gradually emerging, among which heavy metal pollution is harmful to both human beings and the environment. As a result, there are many metal ion detection methods, among which fluorescence detection stands out because of its rapid, sensitive, low cost and non-toxic characteristics. In recent years, graphene quantum dots have been widely used and studied due to their excellent properties such as high stability, low toxicity and water solubility, and have a broad prospect in the field of metal ion detection. A novel high fluorescence Cu2+, Co2+ sensing probe produced by graphene quantum hydrothermal treatment is reported. After heat treatment with hydrazine hydrate, the small-molecule precursor nitronaphthalene synthesized by self-nitrification was transformed from blue fluorescent GQDs to green fluorescent amino-functionalized N-GQDs. Compared with other metal ions, N-GQDs are more sensitive to Cu2+ and Co2+ on the surface, and N-GQDs have much higher selectivity to Cu2+ and Co2+ than GQDs. The strategy proposed here is simple and economical in design.
| S-EPMC9692581 | biostudies-literature
Project description:Functionalization of nanocrystals is essential for their practical application, but synthesis on nanocrystal surfaces is limited by incompatibilities with certain key reagents. The copper-catalyzed azide-alkyne cycloaddition is among the most useful methods for ligating molecules to surfaces, but has been largely useless for semiconductor quantum dots (QDs) because Cu+ ions quickly and irreversibly quench QD fluorescence. To discover nonquenching synthetic conditions for Cu-catalyzed click reactions on QD surfaces, we developed a combinatorial fluorescence assay to screen >2000 reaction conditions to maximize cycloaddition efficiency while minimizing QD quenching. We identify conditions for complete coupling without significant quenching, which are compatible with common QD polymer surfaces and various azide/alkyne pairs. Based on insight from the combinatorial screen and mechanistic studies of Cu coordination and quenching, we find that superstoichiometric concentrations of Cu can promote full coupling if accompanied by ligands that selectively compete with the Cu from the QD surface but allow it to remain catalytically active. Applied to the conjugation of a K+ channel-specific peptidyl toxin to CdSe/ZnS QDs, we synthesize unquenched QD conjugates and image their specific and voltage-dependent affinity for K+ channels in live cells.
| S-EPMC5966341 | biostudies-literature
Project description:Water-soluble and reductive carbon quantum dots (CQDs) were fabricated by the hydrothermal carbonization of chitosan. Acting as a reducing agent and stabilizer, the as-prepared CQDs were further used to synthesize gold nanoparticles (AuNPs). This synthetic process was carried out in aqueous solution, which was absolutely "green". Furthermore, the CQDs/AuNPs composite was used to detect iodine ions by the colorimetric method. A color change from pink to colorless was observed with the constant addition of I- ions, accompanied by a decrease in the absorbance of the CQDs/AuNPs composite. According to the absorbance change, a favorable linear relationship was obtained between ΔA and I- concentration in the range of 20⁻140 μM and 140⁻400 μM. The detection limit of iodide ions, depending on the 3δ/slope, was estimated to be 2.3 μM, indicating high sensitivity to the determination of iodide. More importantly, it also showed good selectivity toward I- over other anion ions, and was used for the analysis of salt samples. Moreover, TEM results indicated that I- ions induced the aggregation of CQDs/AuNPs, resulting in changes in color and absorbance.
| S-EPMC6315431 | biostudies-literature
Project description:A new high performance fluorescence assay for detection of Ag+ based on CdS quantum dots (QDs) using L-Aspartic acid (L-Asp) as a stabilizer was proposed in this work. The CdS quantum dots conjugation with L-Aspartic acid (L-Asp@CdS QDs) were successfully synthesized via a simple hydrothermal process. The QDs have a fluorescence emission band maximum at 595 nm with a quantum yield of 11%. The obtained CdS QDs exhibit a particle size of 1.63 ± 0.28 nm and look like quantum dot flowers. Basically, the fluorescence intensity of L-Asp@CdS QDs can be enhanced only upon addition of Ag+ and a redshift in the fluorescence spectrum was observed. Under optimum conditions, the fluorescence enhancement of L-Asp@CdS QDs appeared to exhibit a good linear relationship in between 100-7000 nM (R2 = 0.9945) with the Ag+ concentration, with a detection limit of 39 nM. The results indicated that the L-Asp@CdS QDs were well used in detection for Ag+ as fluorescence probe in aqueous solution with high sensitivity and selectivity. Moreover, the sensing system has been applied in detection Ag+ in real water samples. The recovery test results were 98.6%~113%, and relative standard deviation (n = 5) is less than 3.6%, which was satisfactory.
| S-EPMC6724099 | biostudies-literature
Project description:Nitrogen-doped carbon quantum dots (NCQDs) were prepared from chitosan through a hydrothermal reaction. When ethanol precipitation was used as the purification method, a high product yield of 85.3% was obtained. A strong blue fluorescence emission with a high quantum yield (QY) of 6.6% was observed from the NCQD aqueous solution. Physical and chemical characteristics of the NCQDs were carefully investigated by transmission electron microscopy (TEM), X-ray diffraction (XRD), Fourier transform infrared spectra (FTIR), Raman spectra, X-ray photoelectron spectroscopy (XPS), and transient fluorescence spectra. Experimental results showed that diameters of the NCQDs were in the range of 2-10 nm. The carbon quantum dots possess good water dispersibility and precipitation by ethanol. When used for metal ion detection, the detection limit of the NCQDs for Fe3+ was as low as 1.57 μM. This work proposed a facile method to synthesize NCQDs from chitosan with high yield and demonstrated that carbon quantum dots derived from chitosan were promising for ion detection.
| S-EPMC6941364 | biostudies-literature
Project description:The tunability of electronic and optical properties of semiconductor nanocrystal quantum dots (QDs) has been an important subject in nanotechnology. While control of the emission property of QDs in wavelength has been studied extensively, control of the emission lifetime of QDs has not been explored in depth. In this report, ZnO-CdS core-shell QDs were synthesized in a two-step process, in which we initially synthesized ZnO core particles, and then stepwise slow growth of CdS shells followed. The coating of a CdS shell on a ZnO core increased the exciton lifetime more than 100 times that of the core ZnO QD, and the lifetime was further extended as the thickness of shell increased. This long electron-hole recombination lifetime is due to a unique staggered band alignment between the ZnO core and CdS shell, so-called type II band alignment, where the carrier excitation holes and electrons are spatially separated at the core and shell, and the exciton lifetime becomes extremely sensitive to the thickness of the shell. Here, we demonstrated that the emission lifetime becomes controllable with the thickness of the shell in ZnO-CdS core-shell QDs. The longer excitonic lifetime of type II QDs could be beneficial in fluorescence-based sensors, medical imaging, solar cells photovoltaics, and lasers.
| S-EPMC6413518 | biostudies-literature
Project description:Bright and fast fluorescence makes semiconductor nanocrystals, or quantum dots (QDs), appealing for applications ranging from biomedical research to display screens. However, a few percent of their fluorescence intensity is surprisingly slow. Research into this "delayed emission" has been scarce, despite undesired consequences for some applications and potential opportunities for others. Here, we characterize the dynamics of delayed emission exhibited by individual CdSe/CdS core/shell QDs and correlate these with changes in the emission spectrum. The delayed-emission intensity from a single QD fluctuates strongly during an experiment of several minutes and is thus not always "on", implying that control over delayed emission may be possible. Periods of bright delayed emission correlate with red-shifted emission spectra. This behavior is consistent with exciton polarization by fluctuating electric fields due to diffusing surface charges, which have been known to cause spectral diffusion in QDs. Our findings thus provide a stepping stone for future efforts to control delayed emission.
| S-EPMC7309328 | biostudies-literature
Project description:Graphene quantum dots (GQDs) have attractive properties and potential applications. However, their various applications are limited by a current synthetic method which requires long processing time. Here, we report a facile and remarkably rapid method for production of GQDs exhibiting excellent optoelectronic properties. We employed the pulsed laser ablation (PLA) technique to exfoliate GQDs from multi-wall carbon nanotube (MWCNTs), which can be referred to as a pulsed laser exfoliation (PLE) process. Strikingly, it takes only 6 min to transform all MWCNTs precursors to GQDs by using PLE process. Furthermore, we could selectively produce either GQDs or graphene oxide quantum dots (GOQDs) by simply changing the organic solvents utilized in the PLE processing. The synthesized GQDs show distinct blue photoluminescence (PL) with excellent quantum yield (QY) up to 12% as well as sufficient brightness and resolution to be suitable for optoelectronic applications. We believe that the PLE process proposed in this work will further open up new routes for the preparation of different optoelectronic nanomaterials.
| S-EPMC5144005 | biostudies-literature
Project description:A highly sensitive biosensor for detecting HPV 16 DNA was prepared based on Keggin-type polyoxometalate (SiW12)-grafted CdS quantum dots (SiW12@CdS QDs) and colloidal gold nanoparticles (Au NPs), which exhibited remarkable selectivity and sensitivity upon target DNA detection because of its excellent photoelectrochemical (PEC) response. Here, an enhanced photoelectronic response ability was achieved with the strong association of SiW12@CdS QDs by polyoxometalate modification, which was developed through a convenient hydrothermal process. Furthermore, on Au NP-modified indium tin oxide slides, a multiple-site tripodal DNA walker sensing platform coupled with T7 exonuclease was successfully fabricated with SiW12@CdS QDs/NP DNA as a probe for detecting HPV 16 DNA. Due to the remarkable conductivity of Au NPs, the photosensitivity of the as-prepared biosensor was improved in an I3-/I- solution and avoided the use of other regents toxic to living organisms. Finally, under optimized conditions, the as-prepared biosensor protocol demonstrated wide linear ranges (15-130 nM), with a limit of detection of 0.8 nM and high selectivity, stability, and reproducibility. Moreover, the proposed PEC biosensor platform offers a reliable pathway for detecting other biological molecules with nano-functional materials.
| S-EPMC10303914 | biostudies-literature